Home > Lexmark > Printer > Lexmark T622N User Manual

Lexmark T622N User Manual

    Download as PDF Print this page Share this page

    Have a look at the manual Lexmark T622N User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 166 Lexmark manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.

    							30
    Verifying the IP
    settings1Print another network setup page and make sure the IP Address, Netmask, 
    and Gateway are what you expected.
    Use the information in “Printing a network setup page” on page 27 if you 
    need help.
    2Ping the printer and verify that it responds.
    For example, at a command prompt on a network computer type “ping” fol-
    lowed by the new printer IP address:
    ping xxx.xxx.xxx.xx
    If the printer is active on the network, you should receive a reply.
    Configure for Pull
    Printing
    (ImageQuick)If your printer has an ImageQuick™ optional firmware card installed, you can con-
    figure for Pull Printing once an IP address has been assigned to your printer.
    For detailed configuration instructions, refer to the online documentation on the 
    ImageQuick CD. The ImageQuick CD is shipped with printers that have the 
    ImageQuick optional firmware card pre-installed, and also with the firmware card if 
    you purchased it separately.
    Downloaded From ManualsPrinter.com Manuals 
    						
    							31
    Step 7: Install printer drivers
    A printer driver is software that lets your computer communicate with your printer.
    The following table is a quick guide to finding the specific instructions you need.
    Network printingThe following instructions explain how to install printer drivers on printers attached 
    to a network.
    WindowsPor ts
    The following network printer ports are supported:
    Microsoft IP port (Windows NT 4.0 and Windows 2000)
    Lexmark network port (Windows 95/98/Me, Windows NT 4.0, and Win-
    dows 2000)
    Printer drivers
    Note:Using the Lexmark T Family custom printer driver and a Lexmark network 
    por t provides enhanced functionality, such as printer status alerts.
    The following printer drivers are supported:
    Windows system printer driver
    Lexmark T Family custom printer driver
    System drivers are built into Windows operating systems. Custom drivers are 
    available on the drivers CD.
    Updated system and custom drivers are available on the Lexmark Web site at 
    www.lexmark.com/drivers.
    Type of printer installationNetwork environment or operating systemPage
    Network
    (Ethernet or Token-Ring connections)Windows
    (Windows 95/98/Me, Windows NT 4.0, Windows 2000)31
    Macintosh 32
    UNIX/Linux 32
    NetWare 33
    Local
    (parallel or USB connections)Windows
    (Windows 95/98/Me, Windows NT 4.0, Windows 2000)33
    Macintosh 34
    UNIX/Linux 34
    Downloaded From ManualsPrinter.com Manuals 
    						
    							32
    Printing methods
    The following network printing methods are supported:
    Direct IP printing
    Shared printing (point and print, peer-to-peer)
    Creating ports and installing drivers
    Read the detailed instructions on the drivers CD. Click View documentation and 
    look for network printer installation.
    If you choose to install without using the instructions on the drivers CD, you need 
    a basic understanding of network printing on TCP/IP networks, printer driver 
    installation, and the process involved in adding new network ports.
    MacintoshYour Lexmark T Family printer connects automatically to AppleTalk networks and 
    becomes readily visible to other network clients.
    You must create a printer object (icon) on the desktop of each network client using 
    the LaserWriter 8 printer driver and the Lexmark T Family PostScript Printer 
    Description (PPD) file.
    Note:A PPD file provides detailed information about the capabilities of a printer to 
    UNIX or Macintosh drivers or applications.
    A printer object (icon) must be created on the desktop of each network client using 
    the LaserWriter 8 printer driver and the Lexmark T Family PostScript Printer 
    Description (PPD) file.
    Specific information about installing the printer on your AppleTalk network can be 
    found in the online documentation on the drivers CD that shipped with your printer.
    A Lexmark PPD Installer is provided in the downloadable Web package available 
    on the Lexmark Web site at www.lexmark.com.
    Depending upon which drivers CD shipped with your printer, you may also find this 
    software on the drivers CD. Launch this utility and follow the instructions to install 
    the PPDs. Send a test print job when you have finished.
    UNIX/LinuxYour printer supports many UNIX platforms, such as Sun Solaris and Linux.
    Note:The Sun Solaris package is located both on the drivers CD and on the Lex-
    mark Web site at www.lexmark.com/drivers.
    Lexmark provides a printer driver package for each supported UNIX platform con-
    taining all the necessary drivers and PPDs. The user’s guide contained in each 
    package gives detailed instructions for installing and using Lexmark printers in 
    UNIX environments.
    Downloaded From ManualsPrinter.com Manuals 
    						
    							33
    You can download these printer driver packages from Lexmark’s Web site at 
    www.lexmark.com/drivers. Depending on which drivers CD shipped with your 
    printer, you may also find the driver package you need on the CD.
    NetWareYour Lexmark T Family printer works with both Novell Distributed Print Services 
    (NDPS) and regular queue-based NetWare environments.
    Novell Distributed Print Services (NDPS)
    If you have an NDPS environment, we recommend you install the Lexmark NDPS 
    IP Gateway. The gateway tightly integrates your printers with NDPS so you can 
    easily monitor, control, and print to them.
    You can get the gateway, the snap-ins, the support files and a white paper with 
    installation instructions on the Web at www.lexmark.com/networking/ndps.html.
    Additional information about network printer installation can be found at www.lex-
    mark.com/publications or on the drivers CD that shipped with your printer.
    Non-NDPS (queue-based)
    For the latest information about Lexmark support for non-NDPS (queue-based) 
    environments, click View Documentation on the drivers CD and look for network 
    printer installation. This documentation is also available on the Lexmark Web site 
    at www.lexmark.com/publications. 
    Local printingThe following instructions explain how to install a printer driver on a printer 
    attached to a computer using a parallel or USB connection.
    WindowsSupported connections
    The following printer connections are supported:
    Parallel (Windows 95/98/Me, Windows NT 4.0, and Windows 2000)
    USB (Windows 98/Me and Windows 2000)
    Note:Using the Lexmark T Family custom printer driver provides enhanced func-
    tionality, such as printer status alerts.
    Printer drivers
    The following printer drivers are supported:
    Windows system printer driver
    Lexmark T Family custom printer driver
    System drivers are built into Windows operating systems. Custom drivers are 
    available on the drivers CD.
    Downloaded From ManualsPrinter.com Manuals 
    						
    							34
    Updated system and custom drivers are available at www.lexmark.com/drivers.
    Installation instructions
    Read the detailed online instructions on the drivers CD. Click View documentation 
    and look for information about local printer installation. Detailed instructions are 
    provided for parallel and USB connections.
    MacintoshIf you are setting up the printer for local printing, you need to install the Lexmark T 
    Family PPD and use it with the LaserWriter 8 printer driver or the Adobe Post-
    Script driver.
    The Lexmark T Family PPD and specific information about local printer installation 
    on Macintosh computers can be found on the drivers CD that shipped with your 
    printer.
    After the printer is installed, print a test page to verify your printer is correctly set 
    up.
    UNIX/LinuxYour printer supports many UNIX platforms, such as Sun Solaris and Linux.
    Note:The Sun Solaris package is located both on the drivers CD and on the Lex-
    mark Web site at www.lexmark.com/drivers.
    Lexmark provides a printer driver package for each supported UNIX platform con-
    taining all the necessary drivers and PPDs. The user’s guide contained in each 
    package gives detailed instructions for installing and using Lexmark printers in 
    UNIX environments.
    All the driver packages support local printing using a parallel connection. The 
    driver package for Sun Solaris systems also supports USB connections to Sun 
    Ray appliances and Sun workstations.
    You can download these printer driver packages from Lexmark’s Web site at 
    www.lexmark.com/drivers. Depending on which drivers CD shipped with your 
    printer, you may also find the driver package you need on the CD.
    Downloaded From ManualsPrinter.com Manuals 
    						
    							Downloaded From ManualsPrinter.com Manuals 
    						
    							www.lexmark.com
    Lexmark and Lexmark with diamond design are trademarks of Lexmark International, Inc., 
    registered in the United States and/or other countries.
    © 2001 Lexmark International, Inc.
    740 West New Circle Road
    Lexington, Kentucky 40550
    P/N 11K3092
    E.C. 1K0911
    Downloaded From ManualsPrinter.com Manuals 
    						
    All Lexmark manuals Comments (0)

    Related Manuals for Lexmark T622N User Manual