Lenovo Thinkvision L200p Users Guide

							L200p 

 
						

							8
i i i
1-4
1-4
1-91-4
Manually installing the Soft OSM 3-7
3-9
Safety and Maintenance Guidelinesiv
 
						

							3AFETY INFORMATION
       
     •Ž’Š Šœ   
0REDINSTALAC
						

							Safety and Maintenance Guidelines
iv
 
						

							Digital Interface Cable
This  U
ser’s  Guide  contains  detailed  information  on  the ThinkVision™  L200p  Wide
F
lat P
anel Monitor. For a quick overview, please see the Setup Poster that was
s
hipped  w
ith  your  monitor.
N
ote : To a
ttach a VESA mount, please see
“De
taching  the  monitor  stand”  on  page  2-7.
8
 
						

							1-2L200p Wide Flat Panel Monitor User’s Guide
Product overview
This  section  will  provide  information  on  adjusting  monitor  positions,  setting  user
c
ontrols, a
nd using the cable lock slot.
Types of adjustments
Ti
lt
Please see the illustration below for an example of the tilt range.
Swivel
With the built-in pedestal, you can tilt and swivel the monitor for the most
c
omfortable v
iewing angle.
 -45o                                             45o
110mm
Height Adjustment
After pressing the top of the monitor, remove the fixed pin and adjust the height of
the  mo
nitor.
 
						

							User controls
Your monitor has controls on the front which are used to adjust the display.
Fo r information on how to use these controls, please see “Adjusting your monitor
image” on page 2-3.
Monitor Pivot
90O
- Adjust height to the top position before rotation the monitor.
- R
otate clockwise until the monitor stops at 90°.
Chapter 1. Getting started1-3
 
						

							Setting up your monitor
This section provides information to help you set up your monitor.
Connecting and turning on your monitor
Note:Be sure to read the Safety Information located in the  Monitor  Safety,
Tro
ubleshooting, and Warranty Guide  before carrying out this procedure.
1. P
ower off your computer and all attached devices, and unplug the computer power
c
ord.
2. C
onnect the digital signal cable to the video port on the back of the computer.
N
ote: On
e end of the signal cable is already pre-attached to your monitor.
1-4
L200p Wide Flat Panel Monitor User’s Guide
Cable lock slot
Your monitor is equipped with a cable lock slot located on the rear of your monitor
(
in t
he lower right corner). Please follow the instructions that came with the cable
l
ock t
o attach it.
 
						

							3.    Connect the analog signal cable to the D-SUB connector of the monitor and the
o
ther e
nd on the back of the computer.
Chapter 1. Getting started1-5
4
.   Pl
ug
 the monitor power cord and the computer cord into grounded electrical outlets.
Note:  A certified power supply cord has to be used with this equipment. The relevant
n
ational  i
nstallation  and/or  equipment  regulations  shall  be  considered. A  certified
p
ower s
upply cord not lighter than ordinary polyvinyl chloride flexible cord
a
ccording to I
EC 60227 (designation H05VV-F 3G 0.75mm2 or H05VVH2-F2 3G
0
.75mm2) shall be used. Alternative a flexible cord be of synthetic rubber according
to I
EC 60245 (designation H05RR-F 3G 0.75mm2) shall be used.