Lenovo Thinkvision L200p Users Guide

L200p 

 

8
i i i
1-4
1-4
1-91-4
Manually installing the Soft OSM 3-7
3-9
Safety and Maintenance Guidelinesiv
 

3AFETY INFORMATION
       
     •Ž’Š Šœ   
0REDINSTALAC

Safety and Maintenance Guidelines
iv
 

Digital Interface Cable
This  U
ser’s  Guide  contains  detailed  information  on  the ThinkVision™  L200p  Wide
F
lat P
anel Monitor. For a quick overview, please see the Setup Poster that was
s
hipped  w
ith  your  monitor.
N
ote : To a
ttach a VESA mount, please see
“De
taching  the  monitor  stand”  on  page  2-7.
8
 

1-2L200p Wide Flat Panel Monitor User’s Guide
Product overview
This  section  will  provide  information  on  adjusting  monitor  positions,  setting  user
c
ontrols, a
nd using the cable lock slot.
Types of adjustments
Ti
lt
Please see the illustration below for an example of the tilt range.
Swivel
With the built-in pedestal, you can tilt and swivel the monitor for the most
c
omfortable v
iewing angle.
 -45o                                             45o
110mm
Height Adjustment
After pressing the top...

User controls
Your monitor has controls on the front which are used to adjust the display.
Fo r information on how to use these controls, please see “Adjusting your monitor
image” on page 2-3.
Monitor Pivot
90O
- Adjust height to the top position before rotation the monitor.
- R
otate clockwise until the monitor stops at 90°.
Chapter 1. Getting started1-3
 

Setting up your monitor
This section provides information to help you set up your monitor.
Connecting and turning on your monitor
Note:Be sure to read the Safety Information located in the  Monitor  Safety,
Tro
ubleshooting, and Warranty Guide  before carrying out this procedure.
1. P
ower off your computer and all attached devices, and unplug the computer power
c
ord.
2. C
onnect the digital signal cable to the video port on the back of the computer.
N
ote: On
e end of the signal cable is already...

3.    Connect the analog signal cable to the D-SUB connector of the monitor and the
o
ther e
nd on the back of the computer.
Chapter 1. Getting started1-5
4
.   Pl
ug
 the monitor power cord and the computer cord into grounded electrical outlets.
Note:  A certified power supply cord has to be used with this equipment. The relevant
n
ational  i
nstallation  and/or  equipment  regulations  shall  be  considered. A  certified
p
ower s
upply cord not lighter than ordinary polyvinyl chloride flexible cord
a...