Lenovo B71 80 Laptop User Guide

27
Appendix A. CRU instructions
Customer Replaceable Units (CRUs) are parts that can be upgraded or 
replaced by the customer. If a CRU is determined to be defective during the 
warranty period, a replacement CRU will be provided to the customer. 
Customers are responsible for installing the self-service CRUs for this 
product. Customers also can install optional-service CRUs, which might 
require some technical skills or tools, or request that a technician install the 
optional-service CRU under the...

Appendix A. CRU instructions
28
Replacing the hard disk drive - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 
You can increase the storage capacity of your computer by replacing the hard 
disk drive with one of greater capacity. You can purchase a new hard disk 
drive from your reseller or Lenovo marketing representative.
The hard disk drive is very sensitive. Incorrect handling can cause damage 
and permanent loss of data on the hard disk. Before removing...

Appendix A. CRU instructions
29
To replace the hard disk drive, do the following:
1Remove the screws  a, and then remove the bottom slot cover  b.
2 Remove the frame fixing screws  c.
2
1
1 

Appendix A. CRU instructions
30
3Detach the hard disk drive connector shown by arrows  d and  e.
4  Take out the hard disk drive secured in a metal frame  6.
5 Remove the screws and detach the metal frame from the hard disk drive.
6 Attach the metal frame to a new hard  disk drive and tighten the screws.
7Reconnect the hard disk drive connector. Slide the new hard disk drive firmly 
into place, and then reinstall the frame fixing screws to secure the drive.
8Reinstall the bottom slot cover and tighten...

Appendix A. CRU instructions
31
Replacing the memory  - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 
You can increase the amount of memory in your computer by installing 
double data rate three synchronous dynamic random access memory 
(DDR3L SDRAM)-available as an option-in the memory slot of your 
computer. DDR3L SDRAM modules are available in various capacities.
To install a DDR3L SDRAM module, do the following:
1Touch a...

Appendix A. CRU instructions
32
3If two DDR3L SDRAM modules are already installed in the memory slot, 
remove one of them to make room for the new one by pulling out on the 
latches on both edges of the socket at the same time. Be sure to save the 
old DDR3L SDRAM for future use.
4Align the notch of the DDR3L SDRAM module with the protrusion of the 
socket and gently insert the new module at a 30-45° angle.
5Push the DDR3L SDRAM module down until the latches on both sides of 
the socket lock into its...

Appendix A. CRU instructions
33
To make sure that the DDR3L SDRAM module is installed correctly, do as 
follows:
1Press the Novo button to open the Novo button menu.
2Select the BIOS Setup. The System Memory item shows the total amount 
of memory installed in your computer. 

Appendix A. CRU instructions
34
Replacing the keyboard  - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 
To replace the keyboard, do the following:
1Remove the screws a.
2Turn the computer over and open the display panel.
Notes:•Make sure the computer is turned off and all the cables disconnected from the computer 
before you replace the keyboard.
•Make sure the computer display is closed to avoid being damaged.
111 

Appendix A. CRU instructions
35
3Pull to unsnap the keyboard in the direction as shown by the arrows b 
c.
4Lift up the keyboard d and detach the connector in the direction shown 
by the arrows e f.
5Reinstall the new keyboard and tighten the screws.
2
2
3
456 

Appendix A. CRU instructions
36
Replacing the optical drive  - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 
To replace the optical drive, do the following:
1Remove the keyboard. For details, see “Replacing the keyboard” on page 
34.
2Remove the screw shown in the illustration a. Gently pull the optical 
drive out from its cavity b.
3Insert a new optical drive and tighten the screw to secure the drive.
Notes:•Make sure the computer is turned off...