Land Rover Range Rover Workshop Pre Delivery Inspection Pdi Lm 3rd Edition Rover Manual

Workshop Manual
Pre Delivery Inspection
NRRWM  21/11/01  11:23 am  Page 29 

WORKSHOP MANUAL - PRE-DELIVERY 
INSPECTION (PDI)
LRL0516ENG 3rd Edition
© 2002 Land Rover
All rights reserved. No part of this publication may be reproduced, stored in a retrieval system or transmitted in any form, 
electronic, mechanical, recording or other means without written prior permission from Land Rover. 

CONTENTS
CONTENTS 1
PRE-DELIVERY INSPECTION .................................................................  01-1
PROCEDURES
Pre-delivery inspection (PDI) ..........................................................................................................  01-1 

CONTENTS
2CONTENTS 

PRE-DELIVERY INSPECTION
PROCEDURES 01-1
PRE-DELIVERY INSPE CTION PROCEDURES
Pre-delivery inspection (PDI)
$% 10.10.01
Preliminary 
1.After parking vehicle in work bay, remove keys 
from ignition switch.
2.Check the integrity of factory fitted door and 
tailgate closure seals. Should a seal be broken 
or missing,  ensure the tool kit and spare wheel 
are present. Also check that no internal 
damage to trim has occurred.
3.Remove door and tailgate closure seals.
4.Open bonnet for access.5.Loosen nut and...

PRE-DELIVERY INSPECTION
01-2 PROCEDURES
8.Check security of battery carrier clamps and 
positive battery terminal. Using a volt meter, 
ensure battery voltage exceeds 12.65 volts 
before connecting Testbook/T4. If voltage is 
below this figure recharge battery.
NOTE: The voltage check must be carried out 
before connecting Testbook/T4. Failure to do 
this may result in vehicle configuration failure. 
9.If BBUS multiplug is disconnected, remove nut 
securing sounder to support bracket.
10.Connect...

PRE-DELIVERY INSPECTION
PROCEDURES 01-3
14.Connect earth lead to negative battery terminal 
and tighten bolt to 10 Nm (7 lbf.ft).
15.Start engine, turn the steering fully from lock to 
lock and back to the straight ahead position. 
This action is required to extinguish the 
Steering Angle Sensor (SAS) and Dynamic 
Stability Control (DSC) warning lamps. Stop the 
engine.16.Release cover from drivers side vehicle 
diagnostic socket and connect the Testbook/T4 
lead (DTC 0065A). Connect lead to Testbook/
T4...

PRE-DELIVERY INSPECTION
01-4 PROCEDURES
19. Telephone handset registration: The 
following describes the process for registering 
a new phone to a vehicle. Again, it should be 
remembered that only one phone can be 
registered to a vehicle and that any other phone 
should be de-registered prior to trying to 
register a new phone. 
20.Replacement handsets will be supplied from 
the manufacturer in German. Language 
changes can only be made once the phone is 
registered to the vehicle, therefore the...

PRE-DELIVERY INSPECTION
PROCEDURES 01-5
Vehicle Interior
1. Models fitted with Hi Line Multi Function 
Display (MFD) only: Set time, date and radio 
audio settings, including presets.
2.Turn key in ignition switch to position 1.
3.Switch on the MFD.
4.Depress the menu button, using the right rotary 
control select clock and set time by depressing 
the right rotary control, follow the on screen 
icons. Enter correct time in either 12 or 24 hour 
mode. Press menu to exit clock mode.5.Set 6 FM and 6 AM...