Land Rover Fuel Injection System Manual

;
,: ;
..,..’ :
:,:1.i :“.,: ,:
i.‘.’X
.’ I
.
,:. .‘,;. : :.1990 
NINclcROVER
BASE IDLE SPEED SETTING
NOTE: the base idle speed is set at the factory. It
should not require further adjustment unless the
plenum chamber is changed. The adjustment
screwis sealed with a plug to prevent
unauthorised alteration. Check the ignition
timingbeforeattempting
thefollowing
procedure, since this will affect the idle speed.
Equipment required
Two blanking hoses. It is recommended that these
are manufactured using a new...

K”i;;l;i 1990
FUEL INJECTION SYSTEM 119 1
:
,::
.,. ,.FUEL SYSTEM 1991 MODEL YEAR
..A revised fuel sytem is fitted to 1991 model year
vehicles. The major change is the fitting of a plastic
fuel tank with improved breather system. The
remote expansion tank is now deleted.
A further improvement is the fitting of a combined
fuel pump and sender unit. A panel in the floor of
the vehicle permits access to the fuel pump/sender
unit
FUEL PUMP/SENDER UNIT
WARNING: Ensurethat the Fuel Handling
Precautions given...

’ FUELINJECTIONSYSTEMRefitting
11.
12.
13.
14.
15.
16.
17.
18.
19.Insert the fuel pump into the tank. Fit the
retaining ring and tighten to a torque of 45-50
Nm (34-37 
Ibf ft).
Connect the fuel lines to the pump.
Connect the electrical leads at the multi-plug.Connect the ground lead to the pump and
insulate with suitable sealant.When the fuel system has been reassembled
check all fuel pipes, sealing rings and hose
connections are secure.Run the engine to check for fuel leaks before
final...

:
,_ :
‘.’ .,
.’
:. >,
yo;;; 1990
FUEL INJECTION SYSTEM
13. Remove the back two bolts and nut plates
securing the fuel tank cradle.
14. Remove the front nuts, bolts and washers, and
remove the fuel tank cradle.15. With the aid of an assistant, tilt the right hand
side of the tank upwards and manouver the
tank through the chassis to remove.Refitting
16. Reverse the removal procedure, ensuring thatthe sealing ring, fuel pipe and hose
connections are secure.
17. Run the engine and recheck all connections
to...

:
,,:....’.‘.’..I ::‘, ,. ,;
.’
:..X
‘.
1191FUEL INJECTION SYSTEM
FUEL FILLER FLAP RELEASE BUTTON
The fuel filler flap is no longer part of the central
locking system on 1991 model year vehicles. The
filler flap is permanently locked. To release the flap
press the button situated on the steering column
shroud. On closing, the filler flap will be locked
automatically. Note that the release button will only
work with ignition switched OFF.
Remove and refit
Removing
1. Disconnect the battery negative lead....