Land Rover Discovery Series Ii 04my Owners Handbook Nas Rover

Fuses
220
Fuse specification
Fuse numberRating (amps)Circuit protected
1 25 Central door locking
2 10 Fuel flap release
3 10 Instrument pack 
Switch illumination
4 10 Fog guard lights - rear
5 10 Headlight high beam - LH
6 25 Air conditioning blower - rear
7 30 Heater blower - front
8 30 Heated rear window
Heated mirrors
9 10 Headlight normal beam - LH
10 10 Headlight normal beam - RH
11 10 Side & tail lights - LH
Number plate light 
Switch illumination
Trailer socket
12 30 Sunroof
13 30 Electric windows...

Fuses
221
21 15 Transfer box
Alarm audible warning
Shift i/lock
22 10 Headlight high beam - RH
23 10 Starter motor
24 10 Alternator
Automatic transmission
Engine management
25 15 Brake lights
Reverse lights
26 10 Auxiliary circuits relays
27 10 Instruments
Hill descent control
28 10 Self levelling suspension
Anti-lock braking
29 10 Active cornering enhancement (ACE)
30 20 Cruise control
Electric mirrors
Screen washer - rear
31 10 Air conditioning blower - front
32 25 Accessory socket
33 10 Side & tail...

Fuses
222
ENGINE COMPARTMENT FUSE BOX
WARNING
Batteries emit explosive hydrogen gas; 
ensure that sparks, flames and other ignition 
sources are kept away from the engine 
compartment.
A second fuse box is located on the right side of 
the engine compartment adjacent to the coolant 
reservoir.
Press all four latches in the direction of the 
arrows shown on the illustration to release the 
fuse box cover.
Information on the underside of the cover 
identifies the fuses and their ratings. This 
information...

Fuses
223
Fuse specification
Fuse numberRating (amps)Circuit protected
1 30 Fuel injectors 
2 15 Engine management system
3 15 Front fog lights
4 20 Headlight washers
5 40 Cooling fans
6 10 Air conditioning
7 40 Heated front screen - LH
8 40 Heated front screen - RH
9 30 Trailer lights
10 30 Fuel pump
11 30 ABS valve
12 20 Automatic gearbox
13 10 Body Control Unit (BCU)
14 15 Direction indicators
Hazard lights
15 15
Active cornering enhancement (ACE)
*
16 10 Horn 

Fuses
224
UNDERSEAT FUSES
Two identical small fuse blocks are situated one 
beneath each front seat.
Fuse specification
H2609
Fuse numberRating (amps)Circuit protected
1 40 Seat electrics
2 3 Lumbar support - pump
3 3 Lumbar support - solenoid 

Bulb Replacement
225
B ulb Re plac emen tREPLACING BULBS
Check the operation of all exterior lights before 
you drive the vehicle.
Replacement bulbs
NOTE: All bulbs must be rated at 12 volts
NOTE: In certain territories it is a legal 
requirement to carry spare bulbs, in case of 
bulb failure. A replacement bulb kit is available 
as an approved accessory from your Land 
Rover retailer.Halogen bulbs
Halogen bulbs are used for main beam, dipped 
beam and front fog lights. Take care NOT to 
touch this type...

Bulb Replacement
226
FRONT LIGHT UNIT
Light unit removal
First unfasten the grille by unscrewing the 3 
scrivets as indicated, then remove the grille by 
pulling forward.To replace any of the bulbs, remove the light 
unit as follows:
Open the cover flap (1) and remove the 3 
screws as indicated. Pull the light unit forward 
and disconnect the electrical multi-plug (2) to 
release the unit.
H4373
1
H4375
2 

Bulb Replacement
227
Bulb location
1.Indicator
2.Headlight (Normal beam)
3.Headlight (High beam)
4.Sidelight
5.Marker light
Bulb coversHeadlight (Normal beam) bulb replacement
Remove the plastic bulb cover. Release the 
spring clip which holds the bulb and withdraw 
the bulb from the light unit. Disconnect the bulb 
from the electrical multi-plug . Replace the bulb 
and re-connect to multi-plug. Insert the bulb 
into the light unit, ensuring that the tab of the 
bulb locates in the bulb holder.
Replace...

Bulb Replacement
228
Headlight (High beam) bulb replacement
Remove the plastic bulb cover. Release the 
spring clip which holds the bulb and withdraw 
the bulb from the light unit. Disconnect the bulb 
from the electrical multi-plug. Replace the bulb 
and re-connect to multi-plug. Insert the bulb 
into the light unit, ensuring that the tab of the 
bulb locates in the bulb holder.
Replace the spring clip and plastic bulb cover.
NOTE: Do not touch the bulb glass with your 
fingers. If necessary, clean the...

Bulb Replacement
229
Front Marker light bulb replacement
Remove the plastic bulb cover. Withdraw the 
bulb holder from the light unit. Pull the bulb 
from the holder, replace the bulb and insert the 
bulb holder into the light unit. Front direction indicator bulb replacement
Remove the plastic bulb cover. Unscrew the 
bulb holder as indicated above and withdraw 
from the light unit. Push and twist the bulb to 
release from the holder, replace the bulb and 
insert the bulb holder into the light unit....