Land Rover Discovery Owners Handbook Exp Rover

Bulb replacement
136
HEADLIGHT AND SIDELIGHT
Light unit removal
To replace either headlight or sidelight bulb,
remove the light unit as follows:
Disengage the three retaining clips and rotate
them approximately 10 degrees (see inset) to
align with the slots. The light unit can now be
released forward.
NOTE:
Vehicles fitted with headlight levelling
(as illustration, above) have two retaining clips
only (the bottom of the light unit is mounted
on the headlight height adjustment operating
rod). Remove the...

Bulb replacement
137
Replacing the headlight unit
Replacement is a reversal of the above
procedure. However if headlight levelling is
fitted, it is necessary to carefully align the
lower fixing position to the height adjustment
operating lever before fitting the retaining
clips.
Once the retaining clips are secure, firmly
push the bottom of the headlight unit towards
the rear of the vehicle to fully engage the
height adjustment operating lever, a firm
clunk will be felt when engagement is...

Bulb replacement
138
FRONT DIRECTION INDICATORS
Unclip the spring to release the light unit. Lift
out the light unit and turn the bulb holder
anti-clockwise to release. Push and twist the
bulb to remove.
When replacing the light unit, locate the two
lugs at the bottom of the unit before
re-engaging the spring.
SIDE REPEATER LIGHT
Push the lens firmly to the right, lift the left
edge and withdraw the light unit from the
wing. Twist to release the bulb holder and pull
the bulb to remove. 

Bulb replacement
139
REAR LIGHT CLUSTER
(Stop, reverse & fog guard lights)
To gain access to the light cluster, either:
remove the side pocket cover (picture A) or,
half pull out the side facing seat (picture B),
as applicable. Use a small screwdriver to lever
the fastener cover free (the fastener location is
arrowed in the inset) and then unscrew the
fastener to remove the access panel (as
shown in the lower illustration).
Twist and remove the appropriate bulb holder,
then push and twist to release the...

Bulb replacement
140
BUMPER MOUNTED LIGHTS
(Tail lights & direction indicators)
Reach behind the bumper and twist to remove
the relevant bulb holder, push and twist to
release the bulb.NUMBER PLATE LIGHTS
Remove the screws and withdraw the lens.
Pull the bulb out.
HIGH MOUNTED STOP LIGHT
Remove the retaining screws and the cover
from the rear of the light unit. Twist to remove
the bulb holder. Push and twist to release the
bulb.
FRONT FOG LIGHTS
To change a front fog light bulb entails
removing the light...

Bulb replacement
141
INTERIOR LIGHT
Prise the lens from the unit. Spread the bulb
holders to release the bulb.
LOADSPACE LIGHT
Prise the light from its location. Push and
twist the bulb to remove. Replace and
reassemble.
GLOVEBOX LIGHT
Slide the light unit to the left and insert a
broad flat-headed screwdriver to release the
retaining catch.
Withdraw the light unit from the glovebox and
pull out bulb to replace. 

Cleaning & vehicle care
142 WASHING YOUR VEHICLE
Wash your vehicle frequently using a sponge
and generous quantities of cold or lukewarm
water containing a car shampoo. Rinse and
dry off with a chamois leather.
·
Do not use hot water!
·
Do not use detergent soap products or
washing-up liquid!
During winter months when salt has been
used on the roads, use a hose to wash the
underside of the vehicle. Pay particular
attention to wheelarches and panel seams,
and to removing accumulations of mud.
Similarly,...

Cleaning & vehicle care
143 LOOKING AFTER THE INTERIOR
·
Clean plastic-faced or cloth covered
surfaces with diluted upholstery cleaner.
·
Leather seats, steering wheel and trim
features should be cleaned with a damp
cloth moistened with undiluted upholstery
cleaner. Leave for five minutes, and then
repeat the operation using a clean cloth
and water - but avoid flooding the area!
Dry and polish the leather with a dry,
lint-free cloth.
·
DO NOT use petrol, detergents, furniture
creams or polishes!
·
Sweep...

145
SECTION 5General data
Section Contents Page
Lubricants & fluids 147..................................
Capacities 149................................................
Engine data 150..............................................
Steering 151...................................................
Electrical system 152......................................
Dimensions 153.............................................
Towing weights 153.......................................
Vehicle weights...

General data
147 LUBRICANTS AND FLUIDS
Recommendations for all climates and conditions.
COMPONENTS AMBIENT TEMPERATURE°C
Specification SAE -30 -20 -10 0 10 20 30 40 50
Petrol engine sump
Oil to meet either: 5W/30
RES.22.OL.G4, 5W/40, 5W/50
ACEA A2:96 10W/30
API SG or SH 10W/40
10W/50
10W/60
Diesel engine sump 5W/30
5W/40, 5W/50
Oil to meet either:
RES 22.OL.PD2, 10W/30
ACEA B2:96, 10W/40
API CE 10W/50
15W/40
Main gearbox, manual
ATF Dexron IID
Main gearbox, automatic
ATF Dexron IID
Transfer gearbox...