Land Rover Defender 1999 2002my Workshop Supplement Body Repair 3rd Edition Rover Manual

51REAR AXLE AND FINAL DRIVE
8
OVERHAUL 86.Before adjusting shim thickness, check pinion
face marking and if it has a plus (+) figure,
subtract that from shim thickness figure obtained
in previous instruction. Alternatively if pinion has
a minus (-) figure, add amount to shim thickness
figure.
87.Adjust shim thickness under pinion inner cup as
necessary, by amount determined in instructions
85 and 86.
88.Recheck pinion height setting instructions 82 to
84. If setting is correct, mean reading on dial
gauge...

REAR AXLE AND FINAL DRIVE
9
OVERHAUL Differential backlash checks
96.Pick up differential unit as left after instruction
52.
97.Fit differential unit and lever unit away from drive
pinion until opposite bearing cup is seated
against housing. Do not tilt unit.
98.Install a dial gauge on casing with its stylus
resting on back face of crown wheel. Zero the
gauge.
99.Lever differential unit to engage crown wheel
teeth in full mesh with drive pinion teeth. Do not
tilt unit.
100.Note total reading obtained on...

51REAR AXLE AND FINAL DRIVE
10
OVERHAUL REAR HUB ASSEMBLY - 90
Service repair no - 64.15.13.
1.Remove rear hubSee Repair. Rear hub
assembly.
2.Remove outer bearing.
3.Mark, for reassembly, position of hub to brake
disc.4.Remove 5 bolts and separate hub from brake
disc.
WARNING: A maximum of two road wheel
retaining studs can be renewed. Should
more studs be unserviceable fit new hub
with studs.
5.Remove grease seal and inner bearing from
hub.
6.Remove inner and outer bearing tracks.
REAR HUB COMPONENTS -...

REAR AXLE AND FINAL DRIVE
11
OVERHAUL
Refit
7.Clean hub and fit inner and outer bearing tracks.
8.Pack hub inner bearing with grease and fit to
hub.
9.With lip side leading, fit a new seal flush with
rear face of hub. Using service toolLRT-54-003
(LST137)seal replacer and drift. Apply grease
between seal lips.10.Assemble brake disc to hub, line up reassembly
marks. Applying Loctite 270, fit and tighten
retaining bolts to73 Nm (54 lbf/ft).
11.Pack hub outer bearing with grease and fit to
hub.
12.Fit rear...

51REAR AXLE AND FINAL DRIVE
12
OVERHAUL REAR STUB AXLE - 90
Service repair no - 64.15.22.
STUB AXLE COMPONENTS
1.Stub axle to axle casing bolt.
2.Mud shield.
3.Stub axle.
4.Stub axle joint washer.
5.Axle case.Overhaul
1.Remove hub assemblySee Repair. Rear hub
assembly.
2.Remove 6 bolts from stub axle to axle casing.
3.Remove mud shield.
4.Remove stub axle and joint washer.
Renew rear stub axle oil seal
5.Remove and discard oil seal. Lubricate seal and
lip with EP90 oil. Using special toolLRT-51-004
(LST...

REAR AXLE AND FINAL DRIVE
13
OVERHAUL REAR STUB AXLE - 110/130
Service repair no - 64.15.22
STUB AXLE COMPONENTS
1.Rear axle shaft
2.Stub axle to axle casing bolt
3.Mud shield
4.Stub axle
5.Stub axle joint washer
6.Axle caseOverhaul
1.Remove hub assemblySee REAR
SUSPENSION, Repair. Rear hub bearing.
2.Remove 6 bolts from stub axle to axle casing.
3.Remove mud shield.
4.Remove stub axle and joint washer.
5.Remove rear axle shaft from axle casing.
Renew rear stub axle oil seal
6.Remove and discard oil...

54 - FRONT AXLE AND FINAL DRIVE
CONTENTS
Page
DESCRIPTION AND OPERATION
DESCRIPTION 1.....................................................................................................
FAULT DIAGNOSIS
FAULT DIAGNOSIS 1.............................................................................................
REPAIR
FRONT AXLE ASSEMBLY 1..................................................................................
OVERHAUL
FRONT DIFFERENTIAL...

FRONT AXLE AND FINAL DRIVE
1
DESCRIPTION AND OPERATION DESCRIPTION
The welded steel front axle casing houses a separate
spiral bevel type differential unit, which is off-set to the
right of the vehicle centre line. The differential unit
drives the front wheels via the axle shafts and
constant velocity joints which are totally enclosed in
the spherical and swivel housings.The front wheels are pivoted on tape roller bearings at
the top and bottom of the swivel housing. The wheel
hubs on all axles are...