Land Rover Body Repairs Water Leaks Water Leak Landrover Jlrext Com Manual

If leak is still present the rivet should be drilled and 
replaced, and then painted with a touch up stick 2 
Materials required: sealant (clear/body coloured),  gloves, 
spirit wipe, cloth, hammer, nylon block, rivet, riv et gun, 
touch up stick 3 
Allow the sealant to cure, and retest suspect area  for 
water entry 4 
Is water still entering the vehicle?  
Yes  Carry out a water leak test and visual inspection o f any 
suspect or wet areas, once the water entry point ha s been 
determined refer to the...

To seal the rear lamp remove rear lamp and apply sealant around circumference of lamp base, re fit and wipe away 
any excess sealant 2 
Materials required: sealant (clear/body coloured),  gloves, 
spirit wipe cloth 3 
Allow the sealant to cure, and retest suspect area  for 
water entry 4 
Is water still entering the vehicle?  
Yes  Carry out a water leak test and visual inspection o f any 
suspect or wet areas, once the water entry point ha s been 
determined refer to the Water Ingress Paths And...

Materials required: sealant (clear/body coloured), gloves, 
spirit wipe, cloth 2 
Allow the sealant to cure, and retest suspect area  for 
water entry 3 
Is water still entering the vehicle?  
Yes  Carry out a water leak test and visual inspection o f any 
suspect or wet areas, once the water entry point ha s been 
determined refer to the Water Ingress Paths And 
Recommended Repair Procedure above 
No  Reinstall any trim/panels or component that have be en 
displaced 
PINPOINT TEST Z : UPPER TO LOWER...

Carry out a water leak test and visual inspection of 
any suspect or wet areas, once the water entry poin t 
has been determined refer to the Water Ingress Pat hs And Recommended Repair Procedure above 
No  Reinstall any trim/panels or component that have  
been displaced 
PINPOINT TEST AA : REAR END DOOR 
TEST CONDITIONSDETAILS/RESULTS/ACTIONS
AA1: REAR END DOOR
 NOTE: Due to the location of the spare wheel, the  rear end 
door may become miss-aligned to the body due to fixing torque relaxation....

Reinstall any trim/panels or component that have been 
displaced 
PINPOINT TEST AB : ROOF SEAM 
TEST CONDITIONSDETAILS/RESULTS/ACTIONS
AB1: ROOF SEAM
 NOTE: High visibility area excess sealant must be  wiped away leaving no residue or evidence of repai r 
Visual inspect the entire roof seam looking for  
irregularities in the flange edge condition. Check for gaps 
between the panels and panel joint conditions. Appl y 
sealant as required 1 
Materials required: sealant ( body coloured preferr ed or...

seal this is a very rare leak path. The leak is probably 
caused by deformation to the gasket which should be  
evident by visual check. The gasket should be re-se ated 
and re-tested prior to completing this repair. Usin g the 
boning tool carefully lift the outer edge of the ga sket seal. 
Working around the alpine light, lift and apply sea lant 
between the gasket and the roof panel. Care  must be 
taken to ensure that the roof is not damaged or scr atched 
whilst sealing the alpine light  
For leaks...

   
If the crack is minor it can be repaired by applying 
clear/body coloured sealant and then wiping it into  the 
crack with a gloved hand. If the crack is larger th e vehicle 
may require a body shop repair which will require t he body sealant scraping out of the channel, replacing with new 
body sealant and repaint  
1 
Materials required: sealant (clear/body coloured),  cloth, 
spirit wipe, gloves 2 
Allow the sealant to cure, and retest suspect area  for 
water entry 3 
Is water still entering the...