Kyocera FS 1300D User Manual

							Option6-3
Expansion Memory Modules
To expand the printer memory for more complex print jobs and faster 
print speed, you can plug in optional memory module (dual in line 
memory module) in the memory slot provided on the printer main 
controller board. You can select additional memory module from 64, 128, 
256 or 512MB. The maximum memory size is 544MB.
Precautions for handling the printers main controller 
board and memory module
To protect electronic parts, discharge static electricity from your body by 
touching a water pipe (faucet) or other large metal object before handling 
the memory module. Or, wear an antistatic wrist strap, if possible, when 
you install the memory module.
Always hold the main controller board or a memory module by its edges 
as shown below to avoid damaging electronic parts.
Note The expansion memory should only be installed by your 
service technician. We shall not be liable for any damages caused 
by improper installation of expansion memory.
Correct Incorrect
Downloaded From ManualsPrinter.com Manuals 
						

							6-4Option
Installing the Memory Module
1
Turn off the printer and disconnect the power cord and printer cable .
2Remove the right cover with a piece of metal similar to coin.
3Remove the fixing tape in case of the first installation. Then, remove 
the memory slot cover  as shown in the figure.
4Push out the clamps on both ends of the  memory socket.
5Remove the memory module  from its package.
6Aligning the cutouts of the memory module with the matching keys of 
the socket, carefully plug the  memory module into the memory 
socket  until it clicks in place.
Downloaded From ManualsPrinter.com Manuals 
						

							Option6-5
7The memory module  is secured to the memory socket with the 
clamps.
8Reinstall the  memory slot cover  and the right cover .
Removing a Memory Module
To  r e m o v e  a  memory module , remove the right cover and the memory 
slot cover  from the printer. Then, carefully push out the two  socket 
clamps . Ease the  memory module  out of the socket to remove.
Verifying the expanded memory
To verify that the  memory module is working properly, test it by printing a 
status page.
Downloaded From ManualsPrinter.com Manuals 
						

							6-6Option
Paper Feeder (PF-100 )
The PF-100  allows you to add one (for FS-1100) or two (for FS-1300D) 
more paper cassette to the bottom of the printer for continuous feeding 
of a large volume of paper. Each paper cassette can hold up to 
approximately 250 sheets of ISO A4, ISO A5, JIS B5, Letter, or Legal 
size (80g/m
2) paper. This feeder is attached at the bottom of the printer 
as shown on the left.
Downloaded From ManualsPrinter.com Manuals 
						

							Option6-7
Network Interface Card (IB-23)
The network interface card supports TCP/IP, IPX/SPX, NetBEUI and 
AppleTalk protocols, so that the printer can be used on network 
environments including Windows, Macintosh, UNIX, NetWare, etc. 
The network interface card  must be installed in the option interface slot 
that is located at the back of the printer.
1Turn off the printer and disconnect the  power cord and printer cable .
2Open the rear cover .
3Remove the  optional interface slot cover .
4Insert the Network Interface Card  and secure it with the screws 
removed in step 3.
5Close the rear cover , and connect the printer cable.
6Connect the power cord, and turn on the printer.
7Configure the network address from  Quick Setup. For more 
information, refer to  Operation Guide of the network card.
Downloaded From ManualsPrinter.com Manuals 
						

							6-8Option
CompactFlash (CF) Card
The printer is equipped with a slot for a CF card with the maximum size 
of 256MB. A  CF card is useful for storing fonts, macros, and overlays.
1Turn off the printer and disconnect the  power cord and printer cable .
2Open the rear cover .
3Remove the  optional interface slot cover .
When the Network Interface Card  is installed, remove it.
CAUTION  Before inserting a CF card  in the printer, make 
sure that the printer is switched off.
Downloaded From ManualsPrinter.com Manuals 
						

							Option6-9
4Insert the CF Card.
5Secure it with the screws removed in step 3.
6Connect the  power cord and printer cable  and turn on the printer. 
Downloaded From ManualsPrinter.com Manuals 
						

							6-10Option
Downloaded From ManualsPrinter.com Manuals 
						

							Appendix7-1
7 Appendix
This section lists the specifications of this printer. 
Specifications 7-2
Environmental Standard Requirements 7-4
Downloaded From ManualsPrinter.com Manuals 
						

							7-2Appendix
Specifications
NoteThese specifications are subject to change without notice.
Item Description
FS-1100 FS-1300D
Type Desktop
Printing Method Electrophotography, laser scan
Paper Weight Cassette 60 to 120 g/m²  60 to 120 g/m² (Duplex: 60 to 
105 g/m²)
MP Tray 60 to 220 g/m²
Paper Type Cassette Plain, Preprinted, Bond, Recycled, Rough, Letterhead, Color (Colour), 
Prepunched, High Quality, Custom 1 to 8 
MP Tray/Manual 
Feed Plain, Transparency, Preprinted, Labels, Bond, Recycled, Rough, Vellum, 
Letterhead, Color (Colour), Prepunched, Envelope, Cardstock, Thick paper,  
High Quality, Custom 1 to 8
Paper Size Cassette A4, JIS B5, A5, Follio, Legal, Letter, Oficio II, Statement, Executive, A6, B6, ISO 
B5, Envelope C5, 16K, Custom (105 × 148 to 216 × 356mm (4-1/8 × 5-13/16 to 
8-1/2 × 14 inches)
Paper Feeder A4, JIS B5, A5, Follio, Legal, Letter, Oficio II, Executive, B6, ISO B5, Envelope  C5, 16K, Custom (148 × 210 to 216 × 356mm (5-13/16 × 8-5/16 to 8-1/2 × 14 
inches)
MP Tray/Manual 
Feed A4, JIS B5, A5, Follio, Legal, Letter, Oficio II, Statement, Executive, A6, B6, ISO 
B5, Envelope C5, Envelope #10, Envelope #9, Envelope #6-3/4, Envelope 
Monarch, Envelope DL, Hagaki, Ofuku Hagaki, 16K, Yokei 2, Yokei 4, Custom  
(70 × 148 to 216 × 356mm (2-13/16 × 5-13/16 to 8-1/2 × 14 inches)
Magnification ratio 25 to 400%, 1% increments
Printing Speed Simplex A4/Letter: 28 ppm/30 ppm
A5: 17 ppm 
Duplex - A4/Letter: 14 ppm/15 ppm
First Print Time (A4, feed from 
Cassette) 6 seconds or less
Warm-up Time 
(22°C/71.6°F, 
60%RH) Power on 20 seconds or less (120 V AC), 19 seconds or less (220 to 240 V AC)
Sleep
15 seconds or less (120 V AC), 14 seconds or less (220 to 240 V AC)
Paper Capacity Cassette 1 250 sheets (80 g/m², 11 × 8 1/2/A4 or smaller) Cassette 2 250 sheets (80 g/m², 11 × 8 1/2/A4 or smaller)
Cassette 3 250 sheets (80 g/m², 11 × 8 1/2/A4 or smaller)
MP Tray - 50 sheets (80 g/m², 11 × 8 1/2/A4 or 
smaller)
Manual Feed 1 sheet (80 g/m², 11 × 8 1/2/A4 or  smaller) -
Output Tray 
Capacity Simplex
250 sheets (80 g/m²)
Duplex - 200 sheets (80 g/m²)
Downloaded From ManualsPrinter.com Manuals