Konica Minolta bizhub C35P User Manual

Replacing Consumables 7-28
11Push up the guides.
12Pull out the protective sheet.
13Close the right side cover.
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables7-29
14Install the all toner cartridges, all 
imaging units and waste toner 
bottle.
For details on installing 
the toner cartridges, 
imaging units or waste 
toner bottle, refer to 
“Replacing a Toner Car-
tridge” on page 7-5 or 
“Replacing a Imaging 
Unit” on page 7-10.
15Close the front cover.
When closing the front 
cover, press the area of 
the cover with small pro-
jections.
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables 7-30
16Reconnect the power cord, and 
turn on the printer.
17Reset the counter in the MAINTENANCE MENU/SUPPLIES/
REPLACE/TRANS. BELT
 menu.
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables7-31 Replacing the Backup Battery
When the backup battery is at its end of life, the printer’s date and time can-
not be retained. Follow the procedure described below to replace the backup 
battery.
Note
Only use the coin-shaped 3V lithium battery CR2032. It’s very important 
to protect the printer controller board and any associated circuit boards 
from electrostatic damage. Before performing this procedure, review 
the antistatic caution on page 10-3. In addition, always handle...

Replacing Consumables 7-32
3Using a screwdriver, remove two 
screws.
4Slide the panel slightly to the 
down and lift it off the printer.
5Remove the backup battery.
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables7-33
6Insert a new backup battery.
When inserting the new 
backup battery, be sure 
that the + side faces 
front.
Risk of explosion if bat-
tery is replaced by an 
incorrect type. Dispose of 
used batteries according 
to your local regulations. 
Do not burn the backup 
battery.
7Reinstall the panel and tighten two screws.
8Attach the back cover and tighten four screws.
9Reconnect all interface cables.
10Reconnect the power cord, and 
turn on the printer.
11Use DATE on the SYS...

Replacing Consumables 7-34
Replacing the Fuser Unit FU-P02
When the time to replace the fuser unit is reached, the message FUSER 
UNIT/END OF LIFE
 appears. Printing can continue even after this mes-
sage appears; however, since the print quality is reduced, the fuser unit 
should be replaced immediately
1Turn off the printer.
Note
There are extremely hot parts within the machine. Before replacing the 
fuser unit, wait about 20 minutes after turning off the machine, and then 
check that the fusing...

Replacing Consumables7-35
4Open the fuser unit cover.
5Pull down the 2 levers. 
6Remove the fuser unit.
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables 7-36
7Prepare a new fuser unit.
Be careful not to touch the 
surface of the fuser roller.
8Pull down the 2 levers of a new 
fuser unit.
9Insert the fuser unit until it locks 
into place.
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables7-37
10Lift up the two levers.
11Close the fuser unit cover.
12Close the eject cover.
Downloaded From ManualsPrinter.com Manuals