Kodak EasyShare Printer Dock 6000 User Manual

							11
2Getting Started with Your 
Camera
Loading the Camera Battery
NOTE: The battery pack is not charged when you receive it. The battery needs 
to be completely charged before using your camera.
Which Battery Do I Use?
IMPORTANT: The printer dock charges only the provided Kodak 
EasyShare Ni-MH rechargeable battery pack and Li-
Ion rechargeable battery (included with some 
cameras). If you use any other batteries, rechargeable 
or not, no charging takes place.
If your camera came with:Install this rechargeable in your 
camera:
CRV3 
Lithium, 3V2, AA
1.5V  OR Non-rechargeable starter batteries:
Ni-MH rechargeable
The Ni-MH rechargeable battery pack 
that came with your printer dock.
urg_00041.book  Page 11  Friday, January 3, 2003  10:37 AM
Downloaded From ManualsPrinter.com Manuals 
						

							 12
Chapter 2
Setting Picture Quality 
Your printer dock uses Best (3:2) aspect ratio for printing pictures. To take 
advantage of the aspect ratio and make sure your pictures are not cropped 
when printed, set your camera’s Picture Quality as follows.
Best (3:2) 
See your camera user’s guide for details on 
Setting Picture Quality.
If your camera came with a Li-Ion rechargeable battery:
Li-Ion, 1050 mAh Li-Ion, 1700 mAh OR
Install the Li-Ion rechargeable battery in your camera.
Do not use the Ni-MH battery pack
that came with the printer dock.
urg_00041.book  Page 12  Friday, January 3, 2003  10:37 AM
Downloaded From ManualsPrinter.com Manuals 
						

							13
Chapter 2
Docking and Charging the Camera
Docking your camera lets you make prints directly from the camera, transfer 
pictures from the camera to the computer, and charge the camera battery. 
1Make sure the battery is installed in the camera. See your camera user’s 
guide for details.
2On the camera bottom, locate the 
connector.
3Place the camera in the printer dock and 
push down to seat the connectors.
Charging begin when camera enters auto 
power-off. See your camera user’s guide 
for details.
The camera is now powered by the printer 
dock instead of the camera battery.

The Kodak EasyShare Ni-MH rechargeable 
battery pack and Li-Ion rechargeable 
batteries take 2.5 to 3.0 hours to fully 
charge.

After the battery is charged, leave the 
camera in the printer dock to maintain the 
full charge.

The three green charging lights monitor the 
charging status (see Printer Dock Status 
Lights, page 47).
1 Battery is less than half charged.
2 Battery is more than half charged.
3 Battery is fully charged.1
2
3
urg_00041.book  Page 13  Friday, January 3, 2003  10:37 AM
Downloaded From ManualsPrinter.com Manuals 
						

							urg_00041.book  Page 14  Friday, January 3, 2003  10:37 AM
Downloaded From ManualsPrinter.com Manuals 
						

							15
3Printing Without a Computer
Printing from Your Camera
1Make sure the AC power cord is connected and the color cartridge and 
paper are loaded (see Chapter 1, Getting Started with Your Printer Dock).
2Take a picture with your camera.
3Place the camera in the printer dock (see Chapter 2, Getting Started with 
Yo ur C amera).
4On the printer dock, press the Print Mode 
button to change print modes:
Tagged —prints pictures tagged for 
print in your camera’s Share menu.
Current —prints the pictures displayed 
on the camera screen. Use the arrow keys 
 on the printer dock to select a 
picture.
All —prints all the pictures in your 
camera internal memory and memory card.
Index —prints index prints of all the 
pictures in your camera internal memory 
and memory card.
urg_00041.book  Page 15  Friday, January 3, 2003  10:37 AM
Downloaded From ManualsPrinter.com Manuals 
						

							 16
Chapter 3
5
Press the Print   button.
The copy screen appears on your camera 
when current mode is highlighted on your 
printer dock. 
Use the arrow keys   on the 
printer dock to select the number of 
copies to print, then press the Print 
button again.
Printing starts.The paper cycles four 
times during the printing process before 
the finished print is ejected. Each of the 
first three passes places a layer of color 
(cyan, yellow, and magenta). The fourth 
pass places a clear coating that protects 
and preserves the image quality. 
CAUTION:Wait until printing is complete before removing prints, the 
paper tray or the camera. Failure to do so can cause paper 
misfeeds or jams and can damage the printer dock.
Removing Perforated Tabs from Prints
1Fold the side tabs away from the print.
2Remove each side tab and discard.
4X
urg_00041.book  Page 16  Friday, January 3, 2003  10:37 AM
Downloaded From ManualsPrinter.com Manuals 
						

							17
Chapter 3
Canceling Printing 

Press and hold the Print button   for 2 
seconds.
The print job is immediately canceled 
and ejected into the paper tray. If you 
cancel a print during the fourth pass 
(clear coat), the print is ejected upon 
completion.
4X
urg_00041.book  Page 17  Friday, January 3, 2003  10:37 AM
Downloaded From ManualsPrinter.com Manuals 
						

							urg_00041.book  Page 18  Friday, January 3, 2003  10:37 AM
Downloaded From ManualsPrinter.com Manuals 
						

							19
4Reviewing Pictures and 
Videos
To review pictures and videos stored on your camera:
1Make sure the power is connected to the printer dock (see Connecting the 
Power, page 5).
2Place the Kodak EasyShare camera in the printer dock (see Docking and 
Charging the Camera, page 13).
3Press the arrow keys   on the printer dock to scroll through the 
pictures and videos on your camera.
Running a Slide Show
Use the Slide Show to automatically review your pictures and videos, and to 
display pictures and videos on a television screen (see Displaying Pictures and 
Videos on a Television, page 20).
1Make sure the power is connected to the printer dock (see Connecting the 
Power, page 5).
2Place the Kodak EasyShare camera in the printer dock (see Docking and 
Charging the Camera, page 13).
3Press the Slide Show button  .
The pictures and videos are displayed in the order in which you took 
them. The slide show is finished when The End appears on the screen.

To manually navigate through pictures and videos during the slide 
show, press the arrow keys   on the printer dock.

To select images to print during the slide show, press the Print button 
 and select the number of copies to print.
urg_00041.book  Page 19  Friday, January 3, 2003  10:37 AM
Downloaded From ManualsPrinter.com Manuals 
						

							 20
Chapter 4
IMPORTANT: If, after you press the Print button, you decide not to 
print the picture, select 0 on the copies screen before 
resuming the slide show.

To resume the slide show, press the Print button   again or press the 
Slide Show button  . If neither button is pressed, after a short time 
the slide show resumes automatically.

To cancel the slide show, press and hold the Slide Show button   
until The End appears on the screen.
When the slide show ends, all the pictures you selected are 
printed.
Changing the Slide Show Display Interval
Use your Kodak EasyShare camera settings to change the length of time slides 
are displayed in the slide show. See your camera user’s guide for details.
Running a Continuous Slide Show Loop
When you turn on Loop on your Kodak EasyShare camera, the slide show is 
continuously repeated. See your camera user’s guide for details.

To cancel the slide show, press and hold the Slide Show button   until 
The End appears on the screen.
Displaying Pictures and Videos on a 
Television
You can display pictures and videos on a television, computer monitor, or any 
device equipped with a video input. (Images may not look as good on a 
television as on a computer monitor or when printed.)
An Audio/Video cable is required to connect to a television. Use the A/V cable 
that came with your Kodak EasyShare camera. To purchase one separately, see 
a retail dealer of Kodak products or visit www.kodak.com/go/printerdock.
You need at least one still image or video on your camera to display the picture 
on your television.
urg_00041.book  Page 20  Friday, January 3, 2003  10:37 AM
Downloaded From ManualsPrinter.com Manuals