Keurig 10 Manual

USE & CARE GUIDE  

2 3 
When using electrical appliances, basic 
safety precautions should be followed, 
including the following:
 1. Read all instructions before using.
 2.  Do not touch hot surfaces. Use 
handles and knobs when available.
 3. This appliance must be properly 
installed and located in accordance 
with these instructions before   
it is used.
  4.  The use of accessory attachments 
not recommended by the appliance 
manufacturer may result in fire, 
electrical shock, or injury   
to persons.
  5. Do not...

4 5 
CAUTION: There are three sharp 
needles that puncture pods, two 
above the Pod Holder and the  
other in the bottom of the Pod 
Holder. To avoid risk of injury, do 
not put your fingers in the Pod 
Holder Assembly.
CAUTION: There is extremely hot 
water in the Pod Holder during 
the brew process. To avoid risk of 
injury, do not lift the Handle or 
open the Pod Holder Assembly 
during the brewing process.
CAUTION: Please always keep the  
brewer in its upright position to 
avoid potential injury...

6 7 
FEATURESCONTROLS & INDICATORS
K200 SERIES BREWER 
 A.
 Water Reservoir Lid
  B.  MAX Fill
 C.  Water Reservoir
  D.  Ve nt
  E.  Water Reservoir 
Lock Tab Slots
  F.  Housing  P.
 Add Water Light (Blue)
 Q.  Descale Light (Red)
R.  Heating Light (Red)
 S.  Auto Off Light (Green)
 
G.  Power Cord
 H. Handle
 I. Lid
  J.  K-Cup® Pod Holder   
(J and K are the K-Cup®   
Pod Holder Assembly)  T.
 Auto Off Button
 U.  Power Light (Green)
 V.  Power Button
W.  Large Mug Button
 
K.  Funnel
  L.  K-Cup®...

8 9 
UNPACKING INSTRUCTIONS
1 |
 LET’S GET BREWING!
1.  Place brewer box on a large steady surface (such as a table or 
countertop) or on the floor. Open the box.
2.  Remove enclosed literature.
3.  Turn the box on its side with front of box face down.
4.  Reach into the box and grasp the plastic bag that contains the brewer.
5.  Carefully pull the plastic bag (and packaging materials) toward you 
and out of the box. The brewer will still be encased in the polyfoam 
and be on its side.
6.  Remove the top...

1011
SETUP
2. Place a large mug (10 oz. minimum) on   
the Drip Tray Plate.
3.  Remove the Water Reservoir from 
brewer by first removing Lid from 
Reservoir, then lifting Reservoir straight 
up and away from brewer (may be 
tight). Rinse with fresh water. Fill Water 
Reservoir with bottled or filtered   
water so that the water is to and not 
beyond the MAX FILL line. 5. 
Press Power Button found on upper right 
panel of the brewer. The green Power 
Light will illuminate.  
NOTE: A K-Cup® pod should not...

1213
1 |
 LET’S GET BREWING!
BREW YOUR FIRST CUP
1.  The green Power Light will illuminate to   
indicate the brewer is powered on. Place 
a cup or mug on the Drip Tray Plate. 2.
 Lift the Handle and the K-Cup® pod 
Holder will open toward you. Select   
a K-Cup® pod.
NOTE: Do not remove the foil lid or puncture the K-Cup® pod.
3.  Place a K-Cup® pod in the K-Cup®   
Pod Holder. Lower the Handle completely 
to close the Lid.
CAUTION: There are two sharp needles that puncture the 
K-Cup® pod, one above...

1 5 
14
2  |
 TIPS & MAINTENANCE
CONTROLS & INDICATORS (LED CONTROL CENTER) CARING FOR YOUR BREWER
PROGRAMMING AUTO OFF  
TIMER FEATURE
To set the brewer to turn off two hours 
after the last brew follow the steps below. 1. 
Press the Power Button to turn on   
the brewer.
2.  Press the black Auto Off Button to 
turn on the Auto Off Timer feature. 
The green Auto Off Light will illuminate 
When the Auto Off Timer is enabled, 
your brewer will automatically turn off 
two hours after your last brew. 3. 
To...

1 6 1 7 
2 |
 TIPS & MAINTENANCE
CARING FOR YOUR BREWER
CLEANING THE K-CUP® POD HOLDER ASSEMBLY
Cleaning the Parts The K-Cup® Pod Holder Assembly can be placed 
onto the top shelf of a dishwasher. NOTE: Use low temperature 
cycles in the dishwasher. To remove from the brewer, lift the 
Handle and grasp the top of the K-Cup® Pod Holder with one hand 
while pushing up on the bottom of the K-Cup® Pod Holder from 
underneath with the other until it releases. After cleaning, align the 
K-Cup® Pod Holder with...

1 8 1 9 
2 |
 TIPS & MAINTENANCE
CARING FOR YOUR BREWER
DESCALING YOUR BREWER
Depending on the mineral content of your water, calcium 
deposits or scale may build up in your brewer. Scale is non- toxic but if left unattended can hinder brewer performance. Regularly descaling your brewer every 3-6 months helps 
maintain the heating element, and other internal parts that 
come in contact with water. Calcium deposits may build up  faster, making it necessary to descale more often. 
You should promptly...