JVC Ux- H330 Manual

LVT1193-003A[B]
MICRO COMPONENT SYSTEM
UX-H330
UX-H300–Consists of CA-UXH330 and SP-UXH330
–Consists of CA-UXH300 and SP-UXH300
INSTRUCTIONS
UX-H330&H300[B]cover1.p6504.3.17, 0:06 PM 1 

G-1Warnings, Cautions and Others
CAUTION— (STANDBY/ON) button!
Disconnect the mains plug to shut the power off completely (all lamps
and indications go off). The 
 (STANDBY/ON) button in any
position does not disconnect the mains line.
• When the unit is on standby, the STANDBY lamp lights red.
• When the unit is turned on, the STANDBY lamp goes off.
The power can be remote controlled.
IMPORTANT for the U.K.
DO NOT cut off the mains plug from this equipment. If the plug
fitted is not suitable for the...

G-2
SAFETY INSTRUCTIONS
“SOME DOS AND DON’TS ON THE SAFE USE OF EQUIPMENT”
This equipment has been designed and manufactured to meet international safety standards, but like any electrical equipment,
care must be taken if you are to obtain the best results and safety is to be assured.
Do read the operating instructions before you attempt to use the equipment.
Do ensure that all electrical connections (including the mains plug, extension leads and interconnections between pieces of
equipment) are properly...

1
Power sources
• When unplugging the unit from the wall outlet, always pull
on the plug, not the AC power cord.
DO NOT handle the AC power cord with wet
hands.
Moisture condensation
Moisture may condense on the lenses inside the unit in the
following cases:
• After starting to heat the room.
• In a damp room.
• If the unit is brought directly from a cold to a warm place.
Should this occur, the unit may malfunction. In this case,
leave the unit turned on for a few hours until the moisture
evaporates,...

2
Contents
Location of the Buttons and Controls ............................. 3
Main Unit .................................................................................. 3
Remote Control ......................................................................... 5
Getting Started .................................................................. 6
Unpacking ................................................................................. 6
Connecting AM (MW) and FM Antennas...

3
Location of the Buttons and Controls
Become familiar with the buttons and controls on your unit.
Main Unit
OPEN
COMPACT
DIGITAL AUDIO
DAILY TIMER/SNOOZE
1
3
2
COMPACTDIGITAL AUDIO
STANDBY
CD
PHONES DOWN
4
#/8
7¢UP AUX
PUSH OPEN TAPE FM/AM AUX
VOLUME
+ –
MICRO COMPONENT SYSTEM
AUTO REVERSE
REC
4
5
6
7
8
p 9
q
w
e
r
t
Top view
Front view
01-05_UX-H330&H300[B]3.p6504.3.17, 0:01 PM 3 

4
Display window
Display window
1DAILY 1/2/3 (timer number) indicator
2
 (timer) indicator
3ON/OFF (timer on-time/off-time) indicators
4REC (recording timer) indicator
5
 (group folder) indicator
6SLEEP indicator
7SNOOZE indicator
8FM mode indicators
•MONO, ST (stereo)
9MP3 indicator
p
SOUND indicator
q
BASS indicator
wREC (recording) indicator
e2 3 (tape direction) indicator
rRepeat indicators
•
, ALL, GR. (group)
t
 (reverse mode) indicator
yPRGM (program) indicator
uRANDOM indicator
iRDS indicator...

5
Remote Control
See pages in parentheses for details.
COMPACTDIGITAL AUDIO
STANDBY
CD
PHONES DOWN
4
#/8
7¢UP AUX TAPE FM/AM AUX
VOLUME+ –
REC
When using the remote control, point it at the
remote sensor on the front panel. 1STANDBY/ON 
 button (8, 22)
2SLEEP button (23)
3CLOCK/TIMER button (8, 21)
4SET button (8, 15, 21, 22)
5CANCEL button (21, 22)
6Source buttons
•CD 3¥8, TAPE 2 3, FM/AM, AUX
Pressing one of these buttons also turns on the unit.
7RANDOM button (13)
8PROGRAM button (11, 12)
9Multi...

6
Getting Started
Unpacking
After unpacking, check to be sure that you have all the
following items.
The number in parentheses indicates the quantity of each
piece supplied.
•AM (MW) loop antenna (1)
•Remote control (1)
•Batteries (2)
If any item is missing, consult your dealer immediately.
Connecting AM (MW) and FM Antennas
1Connect the supplied AM (MW) loop
antenna to the AM LOOP terminal.
Place the antenna away from the unit and adjust its
position for the best reception.
2Adjust the position for the...

7
Connecting Other Equipment
To connect an audio equipment
You can connect audio equipment—used only as a playback
device.
•DO NOT connect any equipment while the
power is on.
•DO NOT plug in any equipment until all
connections are complete.
For playing other equipment through this unit,
connect between the audio output jacks on the other
equipment and AUX jack by using audio cords with mini
plugs (not supplied).
When the audio equipment has pin jacks for audio output:
Be sure that the pin plugs of the...