JVC Th V70r Instructions

68
2  Set the  AV COMPU LINK setting in the OTHERS menu, and the VCR ’s remote control code setting
as follows.
See page 62 to set the  AV COMPU LINK setting.
•  When connecting to the VIDEO-1 input jack of the T V:
Select  “D VD 2” (Initial setting).
Set VCR ’s  remote cont rol code to  B .
•  When connecting to the VIDEO-2 input jack of the T V:
Select  “D VD 3.”
Set VCR ’s  remote cont rol code to  A .
•  “DVD1” is not in use.
N O TES:
•   There m ay be no desc ription about connections to a  DVD pl...

69
Operating other manufacturers’ video equipment
By changing the remote control signals from preset ones to the other manufacturers’, you can use the remote control supplied
for this system to operate other manufacturers’ VCRs, CATV converters, DBS tuners, and TVs. (For TVs, see page 20.)
• When operating other video equipment, aim the remote control directly at the remote control sensor on each equipment.
Refer also to the instruction manuals supplied with your equipment.
• Manufacturers’ codes are...

70
Using the remote control for VCR
7For operating your VCR
1 Slide the remote control mode selector to ”AUDIO/TV/VCR.”
2 Press and hold VCR 
.
Keep it pressed until step 4 is finished.
3 Press VCR CONTROL.
4 Press Number buttons (1-9, 0) to enter a manufacturer’s code
(2 digit).
See the list below to find the code.
Examples: For a Philips VCR, press 0, then 9.
For an NEC VCR, press 2, then 5.
5 Release VCR .
6 Try to operate your VCR by pressing VCR 
.
When your VCR turns on or off, you have entered the...

71
To get the best performance of the system, keep your discs
and mechanism clean.
General Notes
In general, you will have the best performance by keeping
your discs, and the mechanism clean.
• Store discs in their cases, and keep them in cabinets or on
shelves.
Handling Discs
• Remove the disc from its case
by holding it at the edge while
pressing the center hole lightly.
• Do not touch the shiny surface
of the disc, or bend the disc.
• Put the disc back in its case
after use to prevent warping.
• Be...

72
SOLUTION
Insert the plug into the socket.
Press 
 on the center unit or
AUDIO 
 on the remote control to
turn off the system, insert the plug
firmly into an AC outlet, and press
 on the center unit or AUDIO
 on the remote control again.
Connect the system cable.
Come closer to the center unit.
(Operate the remote control within 7
m from the center unit.)
Avoid any obstacles.
(See page 19.)
Aim the remote control at the
remote sensor on each equipment
you want to operate.
Set it to the correct...

73
SOLUTION
Connect the cord correctly.
(See page 13.)
Adjust the balance properly.
(See pages 59 and 66.)
Set the speaker setting properly.
(See pages 60 and 66.)
Switch the power off, and remove and re-
insert the power plug in the socket.
Switch the power off and leave the unit a
few hours before switching the power on
again.
Connect the cord correctly.
(See page 10.)
Select the correct input on the TV.
Use a playable disc. (See page 6.)
Change the scan mode to “INTERLACE.”
(See page 26.)
Replace the...

74
PROBLEM
A disc cannot be played.
Not MP3 files but JPEG files are
played.
The MP3 control display appears on
the TV screen, but any operation
cannot be performed.
A disc cannot be played.
Not JPEG files but MP3 files are
played.
Hard to listen to broadcast because of
noise.
Continuous static during FM
broadcasts.
One-touch DVD play does not work
though you have connected AV
COMPU LINK cord correctly.
Suddenly, the system turns off by
itself.
The indications on the moving panel is
displayed...

75
Glossary
Aspect ratio
The ratio of vertical and horizontal sizes of a displayed
image. The horizontal vs. vertical ratio of conventional TVs is
4:3, and that of wide-screens is 16:9.
Chapter
Refers to individual chapters included in a title.
Composite video signal
Refers to video signal comprised of three kinds of signals
combined: an image signal made up of luminance and
chrominance signals using the frequency multiplication
technique; burst signal providing the basis for color
reproduction; and...

76
Index
4:3 LB ......................................................................... 58
4:3 PS ......................................................................... 58
16:9 AUTO ................................................................. 58
16:9 NORMAL ............................................................ 58
A
A-B repeat .................................................................. 50
All Channel Stereo ..................................................... 34
Angle list...

77
Specifications
7Center unit (XV-THV70)
Audio section
Total Harmonic Distortion 0.02 %
NOTE: This value is measured at System cord CONNECTOR for
reference.
Audio input sensitivity/Impedance (at 1 kHz)
Analog input:
AUX IN : 290 mV/47 kΩ
Digital input*:
DIGITAL IN (OPTICAL): –21 dBm to –15 dBm (660
nm ±30 nm)
* Corresponding to Linear PCM, Dolby Digital, and DTS
Digital Surround (with sampling frequency — 32 kHz,
44.1 kHz, 48 kHz)
Video section
Color System: NTSC
Horizontal Resolution: 500 lines...