JVC Th P5 Instructions

							38
References
7Handling Discs
 Remove the disc from its case by 
holding it at the edge while pressing 
the center hole lightly.
 Do not touch the shiny surface of 
the disc or bend the disc.
 Put the disc back in its case after use 
to prevent warping.
 Be careful not to scratch the surface 
of the disc when placing it back in 
its case. 
 Avoid exposure to direct sunlight, 
temperature extremes and moisture.To clean the disc 
Wipe the disc with a soft cloth in a 
straight line from center to edge.
 DO NOT use any solvent — such 
as conventional record cleaner, 
spray, thinner or benzine — to 
clean the disc.
7Cleaning the system
 Stains on the system should be wiped off with a soft cloth. 
If the system is heavily stained, wipe it with a cloth 
soaked in water diluted neutral detergent and wrung well, 
then wipe clean with a dry cloth.
 Since the system may deteriorate in quality, become 
damaged or get its paint peeled off, be careful about the 
following.
– DO NOT wipe it with a hard cloth.
– DO NOT wipe it forcefully.
– DO NOT wipe it with thinner or benzine.
– DO NOT apply any volatile substance such as 
insecticides to it.
– DO NOT allow any rubber or plastic to remain in 
contact with it for a long time.
Maintenance
Troubleshooting
PROBLEM POSSIBLE CAUSE SOLUTION
Power does not come on. The power cord is not connected. Connect the power cord correctly. (See page 
11.)
The remote control does 
not work.The batteries are exhausted. Replace the batteries. (See page 6.)
Sunlight is shining directly on the remote 
sensor.Hide the remote sensor from direct sunlight.
The remote control does 
not work as expected.The remote control mode is not for the 
desired source.Before operation, press one of the source 
selecting buttons for the desired source.
No sound. The speaker cord is not connected. Check the connection. (See pages 8 and 9.)
An incorrect source has been selected. Select the correct source. (See page 14.)
No picture is displayed on 
the TV screen.The SCART cable is not connected correctly. Connect the cable correctly. (See page 10.)
The disc or file is not playable. Use a playable disc or file. (See page 3.)
Video and audio are 
distorted.The disc is scratched or dirty. Replace or clean the disc.
A VCR is connected between the center unit 
and the TV.Connect the center unit and TV directly. (See 
page 10.)
The picture does not fit 
the TV screen.The monitor type is not set correctly. Set “MONITOR TYPE” properly. (See page 
31.)
Hard to listen to broadcast 
because of noise.Antennas are disconnected. Reconnect the antennas correctly and 
securely. (See page 7.)
The system suddenly 
turns off.The playback level of the current source is too 
high.Play back the source with lower volume level.
THP5-P3[B]-f.book  Page 38  Tuesday, December 27, 2005  3:39 PM
 
						

							39
References
7Center unit (XV-THP5/XV-THP3)
Audio section
Front/Surround: 40 W per channel, RMS at 3 Ω at 
1 kHz, with 10 % total harmonic 
distortion.
Center: 100
 W,  R M S  a t  4 Ω at 1 kHz, with 
10 % total harmonic distortion.
Subwoofer: 100
 W,  R M S  a t  4 Ω at 30 Hz, with 
10 % total harmonic distortion.
Video section
Vi d e o  S y s t e m : PA L
Horizontal Resolution: 500 lines
Signal-to-Noise Ratio: 64 dB
(Composite signal when “RGB” is selected)
Video output level
Composite: 1.0 V(p-p)/75 Ω
Y: 1.0 V(p-p)/75 Ω
C: 0.3 V(p-p)/75 Ω
RGB: 0.7 V(p-p)/75 Ω
Only for XV-THP5:
Component-Y: 1.0 V(p-p)/75 Ω
Component-P
B/PR: 0.7 V(p-p)/75 Ω
USB storage
USB specification:  Compatible with the USB 2.0 Full-
Speed
Compatible device: Mass Storage Class
Compatible file system:FAT16, FAT32
Bus power supply: Max. 500 mA
Tuner section
Tuning Range
FM: 87.50 MHz to 108.00 MHz
AM (MW): 522 kHz to 1 629 kHz
General
Power Requirements: AC 230 V , 50 Hz
Power Consumption: 60 W (at operation)
1.4 W (in standby mode)
Dimensions (W M H M D):
435 mm M 70 mm M 308 mm
Mass: 3.0 kg
7Subwoofer (SP-WP5)
Type: Bass-Reflex Type
Speaker: 16 cm cone M 1
Power Handling Capacity: 100 W
Impedance: 4 Ω
Frequency Range: 35 Hz to 200 Hz
Sound Pressure Level: 75 dB/W·m
Dimensions (W M H M D):
129 mm M 284 mm M 337 mm
Mass: 3.1 kg
7Satellite speakers (For TH-P5)
Front speakers (SP-THP5F)
Type: 3-Way Bass-Reflex Type 
(Magnetically-shielded Type)
Speaker: 11.5 cm cone M 1
4 cm cone M 1
1.5 cm cone M 1
Power Handling Capacity: 40 W
Impedance: 3 Ω
Frequency Range: 60 Hz to 20 000 Hz
Sound Pressure Level: 82 dB/W·m
Dimensions (W M H M D):
146 mm M 246.5 mm M 208 mm
Mass: 2.2 kg each
Center speaker (SP-THP5C)
Type: 1-Way Bass-Reflex Type 
(Magnetically-shielded Type)
Speaker: 6.5 cm cone M 2
Power Handling Capacity: 100 W
Impedance: 4 Ω
Frequency Range: 90 Hz to 20 000 Hz
Sound Pressure Level: 79 dB/W·m
Dimensions (W M H M D):
250 mm M 85 mm M 91 mm
Mass: 0.82 kg
Surround speakers (SP-THP5S)
Type: 1-Way Bass-Reflex Type
Speaker: 6.5 cm cone M 1
Power Handling Capacity: 40 W
Impedance: 3 Ω
Frequency Range: 90 Hz to 20 000 Hz
Sound Pressure Level: 72 dB/W·m
Dimensions (W M H M D):
79.5 mm M 147 mm M 88 mm
Mass: 0.51 kg each
Specifications
THP5-P3[B]-f.book  Page 39  Tuesday, December 27, 2005  3:39 PM
 
						

							40
References
7Satellite speakers (For TH-P3)
Front speakers (SP-THP3F)
Ty p e : 1 - Wa y  B a s s - R e f l e x  Ty p e  
(Magnetically-shielded Type)
Speaker: 6.5 cm cone M 1
Power Handling Capacity: 40 W
Impedance: 3 Ω
Frequency Range: 90 Hz to 20 000 Hz
Sound Pressure Level: 75 dB/W·m
Dimensions (W M H M D):
92 mm M 99 mm M 95.5 mm
Mass: 0.45 kg each
Center speaker (SP-THP3C)
Ty p e : 1 - Wa y  B a s s - R e f l e x  Ty p e  
(Magnetically-shielded Type)
Speaker: 6.5 cm cone M 1
Power Handling Capacity: 100 W
Impedance: 4 Ω
Frequency Range: 90 Hz to 20 000 Hz
Sound Pressure Level: 76 dB/W·m
Dimensions (W M H M D):
92 mm M 99 mm M 95.5 mm
Mass: 0.45 kg
Surround speakers (SP-THP3S)
Ty p e : 1 - Wa y  B a s s - R e f l e x  Ty p e  
Speaker: 6.5 cm cone M 1
Power Handling Capacity: 40 W
Impedance: 3 Ω
Frequency Range: 90 Hz to 20 000 Hz
Sound Pressure Level: 72 dB/W·m
Dimensions (W M H M D):
92 mm M 99 mm M 95.5 mm
Mass: 0.48 kg each
Designs & specifications are subject to change without notice.
THP5-P3[B]-f.book  Page 40  Tuesday, December 27, 2005  3:39 PM
 
						

							EN
1205RYMMDWJEM © 2005 Victor Company of Japan, Limited
TH-P5/TH-P3 DVD DIGITAL CINEMA SYSTEMSAFETY INSTRUCTIONS
“SOME DOS AND DON’TS ON THE SAFE USE OF EQUIPMENT”
This equipment has been designed and manufactured to meet international safety standards but, like any 
electrical equipment, care must be taken if you are to obtain the best results and safety is to be assured.
Do read the operating instructions before you attempt to use the equipment.
Do ensure that all electrical connections (including the mains plug, extension leads and interconnections 
between pieces of equipment) are properly made and in accordance with the manufacturer’s instructions. 
Switch off and withdraw the mains plug when making or changing connections.
Do consult your dealer if you are ever in doubt about the installation, operation or safety of your equipment.
Do be careful with glass panels or doors on equipment.
DON’T continue to operate the equipment if you are in any doubt about it working normally, or if it is 
damaged in any way — switch off, withdraw the mains plug and consult your dealer.
DON’T remove any fixed cover as this may expose dangerous voltages.
DON’T leave equipment switched on when it is unattended unless it is specifically stated that it is designed 
for unattended operation or has a standby mode.
Switch off using the switch on the equipment and make sure that your family know how to do this.
Special arrangements may need to be made for infirm or handicapped people.
DON’T use equipment such as personal stereos or radios so that you are distracted from the requirements of 
traffic safety. It is illegal to watch television whilst driving.
DON’T listen to headphones at high volume as such use can permanently damage your hearing.
DON’T obstruct the ventilation of the equipment, for example with curtains or soft furnishings.
Overheating will cause damage and shorten the life of the equipment.
DON’T use makeshift stands and NEVER fix legs with wood screws — to ensure complete safety always fit 
the manufacturer’s approved stand or legs with the fixings provided according to the instructions.
DON’T allow electrical equipment to be exposed to rain or moisture.
ABOVE ALL
—NEVER let anyone, especially children, push anything into holes, slots or any other opening in the case 
— this could result in a fatal electrical shock.;
—NEVER guess or take chances with electrical equipment of any kind — it is better to be safe than sorry!
E43486-340B
THP5-P3[B]-f.book  Page xliv  Tuesday, December 27, 2005  3:39 PM