JBL Micro 2 Owners Manual

®
jbl on stage micro II speaker dock for iPhone/iPod
®*
User Guide
English ........................ 2
Deutsch  ....................... 8
Français  ...................... 15
Español  ..................... 22
Italiano  ...................... 29
Dutch  ........................ 36
Korean  ....................... 43
Norwegian  ................50
Danish  ........................ 57
Japanese  .................... 64
Simplified Chinese  .....71
Finnish  ...................... 78
Russian...

2
Important Safety InstructionsPlease read the following precautions before use:
1.  Read these instructions.
2.  Keep these instructions.
3.  Heed all warnings.
4.  Follow all instructions.
5.  Do not use this apparatus near water.
6.  Clean only with a dry cloth.
7.  Do not block any ventilation openings. Install in accordance
with the manufacturer’s instructions.
8.  Do not install near any heat sources such as radiators, heat
registers, stoves or other apparatus (including amplifiers) that
produce...

3
fcc regulations
FCC Information for Users
This device complies with Part 15 of the FCC Rules. Operation is subject\
 to the following two conditions: (1) This device may not cause harmfu\
l interference; and (2) this device must accept any interference received, including i\
nterference that may cause undesired operation.
Radio and Television Interference
This equipment has been tested and found to comply with the limits for a\
 Class B digital device, pursuant to Part 15 of the FCC Rules. These lim\...

4
jbl on stage micro II easy setup guide
Carefully unpack your speaker
system and identify all its
components. JBL On Stage
Micro II, power supply, remote 
and adapter.Step 2. Move the battery door to
the unlocked position to open
the battery compartment.
or Step 3. Place 4 AAA batteries 
in the battery compartment.
Step 5. Place the appropriate iPhone/iPod adapter onto JBL On Stage 
Micro II. Place your iPhone/iPod on the docking connector or connect 
a 3.5mm (1/8") stereo audio cable to the rear of...

5
troubleshooting your jbl on stage micro II
SymptomPossible Problem
Solution
If you have any questions or need further assistance, please visit www.j\
bl.com.
These specifications are subject to change without notice. No sound from the 
JBL On Stage Micro II 
speaker system
Technical Specifications
Frequency Response:
  70Hz – 20kHz
Power Consumption:
  10W Maximum
Power Input:
  6V/1.5A
JBL On Stage Micro II Transducer:
  (2) 1
" Full range per channel
Dimensions:
  Diameter – 6
" (150mm)...

6
Troubleshooting
SymptomPossible Problem Solution
No sound from the JBL On Stage 
Micro II speaker system (continued) The JBL On Stage Micro II has been 
muted for more than 10 minutes in the 
battery-only mode Press the JBL On Stage Micro II Power button to turn the unit 
back on. Press either (+) or (–) to unmute.
No sound, no LED
No audio signal has been received for 10 minutes and JBL On Stage Micro II is in standby mode
Make sure audio signal is supplied through docked iPhone/iPod or “Audio In”...

7
SymptomPossible Problem SolutionNote
There is no sound coming from 
the JBL On Stage Micro II.
Sound comes from only one
side/channel. Make sure that the wall outlet 
or power strip has power. 
 
Make sure that all switches for 
outlet/power strip are on and 
that all switches for the unit 
are on.
Make sure that the iPhone/iPod 
is properly docked or that the 
auxiliary cable is properly con-
nected.
Turn up the volume.
Check the unit with a source 
that you know to be good.
Connect the “Aux In” cable...

SymptomPossible Problem SolutionNote
Distortion (static, cracking
or hissing sounds).
JBL On Stage Micro II
emits a loud hum
or buzzing noise.
Speaker system experiences 
radio-frequency interference or 
picks up a radio-station trans-
mission. Input cable is not plugged in 
properly.
Cable may be bad.
Ground logo (an unsuitable 
connection).
Input cable may be
picking up interference.
Audio source or source material 
may be the problem.
Test the JBL On Stage Micro II
 
with another source. Does the...

9
jbl on stage micro II remote easy setup guide
Additional Features:
1. In the battery-only mode, the JBL On Stage Micro II loudspeaker dock wil\
l turn off to save battery power when muted or paused    
    for longer than 10 minutes.
2.  In the wall adapter power supply mode JBL On Stage Micro II will go \
into standby mode if no audio signal is detected for 10 
     minutes. The green LED will turn off. Once an audio signal is detec\
ted the speaker will return to normal playing mode and the...

10
Harman Consumer, Inc.
8500 Balboa Boulevard, Northridge, CA 91329 USA
1.516.255.4525 (USA only)
www.jbl.com© 2010 Harman International Industries, Incorporated. All rights reser ved. Tous droits réser vés.
Part Number: 950-0282-001
JBL and Odyssey are trademarks of Harman International Industries, Incorporated, registered in the United States and/or other countries.
*The trademark On Stage is used with permission of OSA International, Inc.
iPhone is a trademark of Apple Inc., registered in the U.S....