Innovative Concepts In Entertainment Hammerhead Owners And Service Manual

OWNERS AND SERVICE MANUAL
INNOVATIVE CONCEPTS IN ENTERTAINMENT INC.
10123 MAIN STREET, CLARENCE, NY 14031
SERVICE:  1–716–759–0360
  FAX: 1–716–759–0884
  E–MAIL: [email protected] 

 INTRODUCTION.............................................. PAGE 3
GAME FEATURES
GAME PLAY
 INSTALLATION................................................. PAGE 4
BEFORE YOU BEGIN
INSTALLATION
 PROGRAMMING OPTIONS............................ PAGE 5 & 6
INTRODUCTION
USING THE PROGRAMMING OPTIONS
 MAINTENANCE............................................... PAGE 7
 QUICK TROUBLESHOOTING......................... PAGE 8
 GAME REPAIR................................................. PAGE 9 – 11
OPERATIONAL...

INTRODUCTION
GAME FEATURES
Thank you for purchasing the new Hammerhead game
from I.C.E.  This new “WACKY” game utilizes all the
proven technology of it’s predecessor Smack–n–Alien. ICE
has taken out the cost but not the quality, giving the
customer a fresh look with full reliability.
Game cabinetry is stylish, yet bright. The game has been
designed to be either a back–to–back centerpiece or a
wall unit that will enhance the look of any location. Thick
16 gauge metal panels and marine grade water...

INSTALLATION
BEFORE YOU BEGIN
WARNING: WHEN INSTALLING THIS GAME, A
GROUNDED A.C. RECEPTACLE MUST BE USED.
FAILURE TO DO SO COULD RESULT IN INJURY TO
YOURSELF OR OTHERS. FAILURE TO USE A
GROUNDED RECEPTACLE COULD ALSO CAUSE
IMPROPER GAME OPERATION, OR DAMAGE TO THE
ELECTRONICS
DO NOT DEFEAT OR REMOVE THE GROUNDING
PRONG ON THE POWER CORD FOR THE SAME
REASON AS  GIVEN ABOVE.  USING AN  IMPROPERLY
GROUNDED GAME COULD VOID YOUR WARRANTY.
HAVE A QUALIFIED ELECTRICIAN CHECK YOU’RE A.C.
RECEPTACLE TO BE SURE...

PROGRAMMING
INTRODUCTION
The Hammerhead game is extremely flexible from a programming standpoint. This allows the customer to “fine tune” the
game to his or her exact needs.
This section will describe in detail each of the programming options and how they work.
PLEASE READ THIS SECTION THOROUGHLY BEFORE CALLING OUR SERVICE DEPARTMENT. MOST QUESTIONS
REGARDING SET–UP AND OPERATION WILL BE FULLY EXPLAINED HERE.
HOW TO USE THE PROGRAMMING OPTIONS
PROGRAMMING BUTTON - Use this button to enter and exit the...

PROGRAMMING
    OPTION     DEFAULT          MIN /MAX         DEFINITION
O 7 0 0 1 0 Volume adjustment
1 2 0 1 0 9 coins per credit switch 1
2 1 0 0 0 9 # of coin 1’s per credit switch 2
3 2 0 1 0 9 9 number of seconds per game
4 2 0 0 0 6 difficulty (lower = easier)
5 2 0 0 0 9 tickets just for playing
6 5 0 1 1 0 hits per tickets
7 2 5 0 0 9 9 ticket cap per game
8 5 0 0 9 9 minutes between attract mode
9 3 0 1 0 3 attract mode type
1 0 0 0 0 0 0 1 factory reset
NOTE: After the factory reset has been...

MAINTENANCE
GENERAL MAINTENANCE
This game has been designed to be as trouble and
maintenance free as possible.
With this in mind the only basics are to keep the game
clean. Below are the main areas to take care of with
specific directions.
MARQUEE
The MARQUEE should be cleaned with a soapy water
solution if covered with water–based dirt such as food
products. After cleaning with soapy water, polish with a
commercial plastic polish or a spray furniture polish.
These have lubricating oils that condition...

QUICK TROUBLESHOOTING
GAME WILL NOT TAKE OR ADD MONEY CORRECTLY
•Micro switch not working or returning properly. Check and repair or replace as necessary.
•Bad Harnessing or connector. Check w/ohm meter and repair as necessary.
•Game programming set incorrectly. Check programming option and re–program if necessary.
Bad Main P.C. Board. Check and repair or replace as necessary.
SHARKS WILL NOT POP UP DURING GAME PLAY
•Opto Sensor is not working properly. Test and replace as necessary.
•Reflective foil is...

GAME REPAIR
WARNING: ALWAYS REMOVE POWER TO
THE GAME BEFORE ATTEMPTING ANY
SERVICE, UNLESS NEEDED FOR SPECIFIC
TESTING.
FAILURE TO OBSERVE THIS PRECAUTION
COULD RESULT IN SERIOUS INJURY TO
YOURSELF OR OTHERS.
OPERATIONAL
BACKGROUND
The HAMMERHEAD game has been manufactured
with modular design in mind. Almost everything in the
game can be EASILY removed for servicing. This
makes it much easier for the repairman as he / she
can work in a quieter less distracting environment
away from the Game Room floor....

GAME REPAIR
REPLACEMENT & REPAIR
COIL BED SERVICING
To remove the coil bed:1. Remove the 4 bolts that hold the boat bow on tothe cabinet. The bolts are located on the
underside of the playfield, on the left & right sides
of the game.
2. Remove the 6 bolts holding the coil bed in position as shown in the photo below.
3. Unplug the multi pin connector by twisting off.
COIL BED PARTS REPLACEMENT
Service the coil bed as follows: Remove all the shark heads from the coil bed. Toremove sharks, turn the coil bed...