InFocus Projector Lp70+ User Manual

LP
®
70+
collaboration without limits
Introduction
6693LP70_Dividers.qxd  2/12/04  1:29 PM  Page 4 

1
INTRODUCTION
The InFocus
® LP70+™ is a projector specifically designed for 
portability, connectivity, and collaboration. It is easy to connect, 
easy to use, easy to transport, and easy to maintain. 
Image Resolution
The XGA resolution of the projected image is 1024x768. The pro-
jector is compatible with screen resolutions up to 1280x1024. If 
your computer ’s screen resolution is higher than 1280x1024, reset 
it to a lower resolution before you connect the projector.
NOTE: The projector automati-...

2
Introduction
F
IGURE 1
Shipping box contents
1. Projector + lens cap 6. Audio cable
2. Remote control with batter-
ies7. Computer cable
3. User’s Guide, Quick Start 
card, and CD8. SCART adapter *
4. Audio/Video (A/V) cable
5. Power cord *
* country-dependent 
1
23
4
5
6
78
LP70.book  Page 2  Friday, February 13, 2004  7:39 AM 

3
FIGURE 2
Front view of projector
F
IGURE 3
Rear view of projector
F
IGURE 4
Bottom view of projector
key pad zoom ring
focus ring
 
remote control sensor (IR)
connectors
 
power connector
security lock
remote control sensor (IR)
adjustable foot
speaker
foot release
lamp housing
leveling foot
LP70.book  Page 3  Friday, February 13, 2004  7:39 AM 

4
Introduction
Usage Guidelines
 Do not look directly into the projection lens when the projector 
is turned on. The bright light may harm your eyes.
 Do not block the grills on the projector. Restricting the air flow 
can cause it to overheat and turn off. If this happens, you must 
wait a minute before attempting to turn it back on.
 Handle the projector as you would any product with glass 
components. Be especially careful not to drop it.
 Avoid leaving the projector in direct sunlight or extreme...

LP
®
70+
collaboration without limits
Setting up the Projector
6693LP70_Dividers.qxd  2/12/04  1:29 PM  Page 5 

5
SETTING UP THE PROJECTOR
1Place the projector on a flat surface.
The projector must be within 6 feet (1.8 m) of your power 
source and your computer.
If you want to project from behind a translucent screen, set 
up the projector behind your screen. See “Rear” on page 24 
to reverse the image.
2Position the projector the desired distance from the screen.
NOTE: The projector must be at 
least 4.9 feet (1.5 m) from the 
projection screen. 
If the image is too big or too small, use the zoom ring to...

6
Setting up the Projector
NOTE: Before you continue,
make sure the projector and all
other equipment is turned off. If
you’re connecting a computer,
make sure the distance between it
and the projector is 6 feet or less.
F
IGURE 6
Connector panel
Wireless Projection
You can use the projector ’s Computer connector along with the I
nFocus LiteShow wireless adapter and software for cable-free digital 
projection. Contact an authorized InFocus dealer or visit our website at 
www.infocus.com for more...