InFocus Projector Lp70+ User Manual

							LP
®
70+
collaboration without limits
User’s Guide
6693LP70_Dividers.qxd  2/12/04  1:29 PM  Page 1 
						

							WARNING: This product contains chemicals, including lead, known to the State of California to cause
bir th defects or other reproductive harm. Wash hands after handling.
WARNING:This product has a lamp which contains a ver y small amount of mercur y.  Dispose of it as
required by local, state, or federal ordinances and regulations. For more information, see www.eiae.org
6693LP70_Dividers.qxd  2/12/04  1:29 PM  Page 2 
						

							LP
®
70+
collaboration without limits
User’s Guide
6693LP70_Dividers.qxd  2/12/04  1:29 PM  Page 3 
						

							Copyright © 2004 by InFocus Corporation
Wilsonville, Oregon. All rights reserved.
LP70.book  Page 1  Friday, February 13, 2004  7:39 AM 
						

							FCC Warning
This equipment has been tested and found to comply with the limits for a Class A 
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to 
provide reasonable protection against harmful interference when the equipment 
is operated in a commercial environment. This equipment generates, uses, and 
can radiate radio frequency energy and, if not installed and used in accordance 
with the instruction manual, may cause harmful interference to radio communi-
cations. Operation of this equipment in a residential area is likely to cause harm-
ful interference in which case the user will be required to correct the interference 
at his own expense.
Canada
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Can-
ada.
Safety Certifications
UL, CUL, TUV, GOST
Other specific Country Approvals may apply, please see product certification 
label. 
EN 55022 Warning
This is a Class A product. In a domestic environment it may cause radio interfer-
ence, in which case the user may be required to take adequate measures. 
InFocus reserves the right to alter product offerings and specifications at any time.
LP70.book  Page 2  Friday, February 13, 2004  7:39 AM 
						

							Declaration of Conformity
Manufacturer: InFocus Corporation
27700B SW Parkway Ave. Wilsonville, Oregon 97070 USA
European Office: Strawinskylaan 585, 1077 XX Amsterdam, The Netherlands
We declare under our sole responsibility that the projector conforms to the follow-
ing directives and norms:
Directive 89/336/EEC, Amended by 93/68/EEC
EMC: EN 55022
           EN 55024
  EN 61000-3-2
  EN 61000-3-3
Directive 73/23/EEC, Amended by 93/68/EEC
Safety: EN 60950: 1992 + A1 + A2 + A3 + A4: 1997
January, 2004
Australian Certification C-tick mark
Trademarks
Apple, Macintosh, and PowerBook are trademarks or registered trademarks of 
Apple Computer, Inc. IBM and PS/2 are trademarks or registered trademarks of 
International Business Machines, Inc. Microsoft, PowerPoint, and Windows are 
trademarks or registered trademarks of Microsoft Corporation. InFocus and LP 
are trademarks or registered trademarks of InFocus Corporation.
LP70.book  Page 3  Friday, February 13, 2004  7:39 AM 
						

							i
TABLE OF CONTENTS
Safety Instructions  iii
Introduction 1
Image Resolution  1
Compatibility 1
Unpacking the Projector  1
Usage Guidelines  4
If You Need Assistance  4
Warranty 4
Setting up the Projector  5
Connecting a Computer  7
Connecting a Video Player  9
Powering up the Projector  11
Turning Off the Projector  14
Using the Projector  15
Basic Image Adjustment  15
Adjusting the Projector  15
Using the Remote Control  17
Using the Keypad and Remote Buttons  18
Using the On-Screen Menus  20
Basic Menu  21
Setup menu  23
Maintenance & Troubleshooting  29
Cleaning the Lens  29
Cleaning the Lamp Filter Screens  29
Replacing the Projection Lamp  30
Replacing the Batteries in the Remote Control  32
Using the Security Lock  32
Troubleshooting 33
Appendix 37
Accessories 37
Projected Image Size  38
Index 39
LP70.book  Page i  Friday, February 13, 2004  7:39 AM 
						

							ii
table of contents
LP70.book  Page ii  Friday, February 13, 2004  7:39 AM 
						

							iii
SAFETY INSTRUCTIONS
Please read and follow all safety instructions provided BEFORE
 
using your new projector. Failure to comply with safety instruc-
tions may result in fire, electrical shock, or personal injury and 
may damage or impair protection provided by equipment. Please 
save all safety instructions.
Safety Definitions:

Wa r n i n g : Statements identify conditions or practices that 
could result in personal injury.
Caution: Statements identify conditions or practices that could 
result in damage to your equipment.
Safety Symbols:
Attention:
 For information about usage of a feature, please 
refer to the User ’s Guide.
War n i n g : Hot surface. Do not touch.
An arrow pointing to the lamp door on the projector.
Wa r n i n g: Turn the projector off, disconnect the power cord, 
and wait 60 minutes before opening the lamp housing.
Safety Terms:

Wa r n i n g : Don’t look directly into the lens when the projector is 
turned on.
Wa r n i n g : To replace the lamp, turn the projector off 
and unplug the power cord. To avoid burns, wait 60 min-
utes before opening the lamp door. Follow all instructions pro-
vided in this User ’s Guide.
Wa r n i n g : Please use the power cord provided. Connect 
the power cord to a receptacle with a protective safety 
(earth) ground terminal.
Wa r n i n g : Refer all service to qualified service personnel. Ser-
vicing your own projector will void the warranty. 
Caution: Don’t block ventilation openings.
LP70.book  Page iii  Friday, February 13, 2004  7:39 AM 
						

							iv
Safety Instructions

Caution: Don’t set liquids on the projector. Spilled liquids may 
damage your projector.
Caution: Don’t place the projector on a hot surface or in direct 
sunlight.
Caution: Do not drop the projector. Transport the projector in 
an InFocus-approved case; see page 37 for a list of cases.
Important Operating Considerations for Safety

Place the projector in a horizontal position no greater than 15 
degrees off axis.
Locate the projector in a well-ventilated area without any 
obstructions to intake or exhaust vents. Do not place the projec-
tor on a tablecloth or other soft covering that may block the 
vents. 
Locate the projector at least 4 (1.2 m) away from any heating or 
cooling vents.
Refer to this manual for proper startup and shutdown proce-
dures.
In the unlikely event of the lamp rupturing, discard any edible 
items placed in the surrounding area and thoroughly clean the 
area along all sides of the projector. Wash hands after cleaning 
the area and handling the ruptured lamp. This product has a 
lamp which contains a very small amount of mercury. Dispose 
of it as required by local, state or federal ordinances and regula-
tions. For more information see 
www.eiae.org.
Follow these instructions to help ensure image quality and lamp 
life over the life of the projector. Failure to follow these instruc-
tions may affect the warranty. For complete details of the war-
ranty, see the Warranty section at the end of this users guide. 
Do not place objects in
this area on the back of the projector
2
 f
t 
(.6m)
LP70.book  Page iv  Friday, February 13, 2004  7:39 AM