InFocus Projector IN3138HD User Manual

							IN3138HD User’s Manual 
–54  – 
SIGNAL RESOLUTIONH-SYNC 
( KHZ ) 
V-SYNC
( HZ ) 
COMPOSITE
S_VIDEO COMPONENT RGB 
(ANALOG) 
HDMI 
(DIGITAL)
1440 x 900  55.9 60  －  － ○ ○ 
1440 x 900  70.6 75  －  － ○ ○ 
1600 x1200 75 60 － － ○ ○ 
1680 x 1050 64.7 59.9 － － ○ ○ 
1680 x 1050 65.3 60 － － ○ ○ 
1920 x 1200 74 60 － － ○ ○ 
1920 x 1080 67.5 60 － － ○ ○ 
640 x 480  35 66.7  －  － ○ ○ 
832 x 624  49.7 74.5  －  － ○ ○ 
1024 x 768  60.2 74.9  －  － ○ ○ 
Apple 
Macintosh 
1152 x 870 68.7 75.1 － － ○ ○ 
480i 15.734 60 － ○ － ○ SDTV 576i 15.625 50 － ○ － ○ 
576p 31.3 50 － ○ － ○ EDTV 480p 31.5 60 － ○ － ○ 
720p 37.5 50 － ○ － ○ 
720p 45 60 － ○ － ○ 
1080i 33.8 60 － ○ － ○ 
1080i 28.1 50 － ○ － ○ 
1080p 27 24 － ○ － ○ 
1080p 28 25 － ○ － ○ 
1080p 33.7 30 － ○ － ○ 
1080p 56.3 50 － ○ － ○ 
HDTV 
1080p 67.5 60 － ○ － ○ 
O ：Frequency supported 
—：Frequency not supported 

The native resolution of the panel is 1920x1080  
Resolutions listed above other than 1920 x 1080 (the native resolution of the proj ector) will be resized and displayed, 
however they may contain lines or uneven looking text. This is normal. 
A yellow background means that the resolution will be displayed in a 4:3 aspect ratio. 
A blue background means that these resolutions ma y display some video noise. This is normal.  
						

							IN3138HD User’s Manual 
Projector Dimensions 
 
264.1mm [10.40]
285.1mm [11.22]
130.4mm [5.13]122.3mm [4.81]
 
–  55  –  
						

							IN3138HD User’s Manual 
–56  – 
REGULATORY COMPLIANCE 
FCC Warning 
This equipment has been tested and found to comply  with the limits for a Class B digital device 
pursuant to Part 15 of the FCC Rules. These  limits are designed to provide reasonable protection 
against harmful interference when the equipm ent is operated in a commercial environment. 
This equipment generates, uses, and  can radiate radio frequency energy and, if not installed and 
used in accordance with the instruction manual , may cause harmful interference to radio 
communications. Operation of this equipment in  a residential area is likely to cause harmful 
interference in which case the user will be required  to correct the interference at his/her own expense. 
Changes or modifications not expressly approved  by the parties responsible for compliance could 
void the user’s authority to operate the equipment. 
Canada 
This class B digital apparatus complies with Canadian ICES-003. 
Safety Certifications 
FCC-B, cUL, UL, CB, CE, C- tick, CCC, PSB, CU, TUV-GS 
 
  
						

							IN3138HD User’s Manual 
– 57  – 
APPENDIX I 
Serial Communication 
The following table describes the serial comm unication configuration that should be used when 
interfacing to CLI via the serial port. 
Windows HyperTerminal or ProComm are two tools  that can be used to send CLI commands across 
the serial port. 
Setting Value 
Bits per second  19200 
Data bits 8 
Parity None 
Stop bits 1 
Flow control None 
Emulation VT100 
 
No Function Command RWMinMaxDefaultStep Parameter 
1V AC Power On 
(Auto power on)  APO RW 0 1 0 1 0:Disable; 1:Enable 
3V Aspect Ratio 
ARZ RW 0 5  0  1 
0:Fill 
1:4:3 
2:16:9 
3:Letterbox 
4:Native 
5:2.35:1 
4V Auto Image  AIM W n/a 1  1  1 1:Enable 
5V Auto Off Time  AOT RW 0 36 6  1 
0:Never 
1~36 * 5 = ? min 
1:5min 
6:30min (Default) 
36:180min 
6V Auto Source  ASC RW 0 1  1  1 0:Disable; 1:Enable 
7V Blank Screen  BLK RW 0 1  0  1 0:Disable; 1:Enable 
9V Brightness  BRT RW 0 100 50  1 Valid only when Display 
Mode = User 
11V Projection  
(Ceiling mode)  CEL RW 0 3 0 1 
0:Front 
1:Rear  
2:Ceiling  
3:Ceiling+Rear 
12V Closed Captions: Non- 
Muted  CLC RW 0 1 0 1 Off 
On (CC1) 
14V Color 
CLR RW 0 100 50  1 Video S-Video only = satu-
ration 
15 
(None) Color Space CSM RW 0 2 0 1 
Valid only when Display 
Mode = User 
0:Auto  
1:RGB 
2:YUV  
						

							IN3138HD User’s Manual 
–58  – 
No Function Command RWMinMaxDefaultStep Parameter 
16V Color Temp  TMP RW 0 2 Source 
Specific 1 
Valid only when Display 
Mode = User 
0:Warm 
1:Normal  
2:Cold 
17V Contrast 
CON RW 0 100 50  1 Valid only when Display 
Mode = User 
18V Current Source  SRC RW 0 13 0  1 
0:VGA1 
1:VGA2 
5:HDMI-1 
7:DP 
12:Video 
13:S-Video 
21V Digital Zoom  DZM RW -1010 0  1 -10~10 
27V Error Condition  ERR R n/an/a n/a  n/a 
0:No error 
1:Lamp not lit after 5 At-
tempts 
3:Lamp went out unexpect-
edly 
4:Fan failure 
5: Overheating 
7: Case open 
8:DMD error 
9:Color wheel 
28V Factory Reset  RST W n/a 1  1  1 1:reset 
32V Freeze Screen  FRZ RW 0 1  0  1 0:Disable 
34V Gamma  GTB RW 0 5 Source 
Specific 1 
Valid only when Display 
Mode = User 
0:1.8  
1:2.0  
2:2.2  
3:2.4 
4:B&W  
5:Linear 
40V Horz. Position 
HPS RW -5 5  0  1 RGB source only 
(HPS?) to get range 
45V Lamp Hours in High 
Power Mode  LMO R 0 9999  
Displays the number of 
hours that the current lamp 
has run in High Power 
(Normal) mode. 
46V Lamp Hours in Low 
Power Mode  LME R 0 9999  
Displays the number of 
hours that the current lamp 
has run in Low Power (Eco) 
mode. 
47V Lamp Life 
LIF R n/aNote   280W lamp life  3000 on 
E20.8 
49V  Lamp Resets (Total 
number)  LMR R 0 99990 1  
62V 
Lamp Low Power  IPM RW 0 1  0  1 0=ECO, 1=Normal  
						

							IN3138HD User’s Manual 
– 59  – 
No Function Command RWMinMaxDefaultStep Parameter 
63V Language  LAN RW 0 25 0  1 
0:English 
1:French 
2:German 
3:Spanish 
4:Portuguese 
5:Simplified Chinese 
6:Traditional Chinese 
7:Italian 
8:Norwegian 
9:Swedish 
10:Dutch 
11:Russian 
12:Polish 
13:Finnish 
14:Greek 
15:Korean 
16:Hungarian 
17:Czech 
18:Arabic 
19:Turkish 
20:Vietnamese 
21:Japanese 
22:Thai 
23: Farsi(Persian) 
24:Hebrew 
25:Indonesia 
77V Menu  MNU RW 0 1  0  1 0:Clear; 1:Display 
79V Menu Navigation  NAV W 0 5  n/a  1 
0:Menu Key 
1:Up Key 
2:Down Key 
3:Select Key 
4:Left Key 
5:Right Key 
81V Menu Transparency  TOE RW 0 4  0  5 
0:0% 
1:20% 
2:40% 
3:60% 
4:80% 
91V Mute  MTE RW 0 1  0  1 0:disable; 1:enable 
104V Frequency (Phase)  MSS RW 0 31 x  1 RGB source only 
108V Power  PWR RW 0 1  0  1 0:Turn Off 
1:Turn On 
111V Presets  PST RW 0 7 source 
Specific 1 
0:Presentation 
1:Bright 
2:Game 
3:Movie 
4:TV 
5:sRGB 
6:Blackboard 
7:User 
114V 
Projector Firmware Ver. FVS R string       DP186-595IFUA-DPP02 
115  Projector High Power 
Hours  LTO R 0 9999
     
Displays the numbers of 
hours that the projector has 
run in High Power (Normal) 
mode over its life (including 
all lamps).  
						

							IN3138HD User’s Manual 
–60  – 
No Function Command RWMinMaxDefaultStep Parameter 
116V Projector Info menu  PRI W  1    1 Display Projector Info menu
117  Projector Low Power 
Hours  LTE R 0 9999
     
Displays the numbers of 
hours that the projector has 
run in Low Power (Eco) 
mode over its life (including 
all lamps). 
118V Projector Model  MDL R string       IN3138HD 
119V Projector Resolution  NRS R string       1080p 
121V  Projector Total Hours  LMT R 0 9999   1   
123V  Lamp Hour Reset  LRT RW n/a1  n/a  1 Reset Lamp Hour 
(OSD:Status) 
126V Search Screen  DSU RW 0 4  0  1 
0:Black 
1:Red 
2:Black 
3:Blue 
4:White 
130V Sharpness  SHP RW 0 31 14  1  
155V System State  SYS R 0 18 0  1 
0:Standby 
2:Start Up 
12:Cooling 
18:Error 
158V Tint  TNT RW 0 100 50  1  
160V Tracking  MTS RW -5 5  0  1 RGB source only 
-5~5 
162V Vert. Keystone  DKV RW -4040 0  1  
164V Vert. Position  VPS RW -5 5  0  1 
RGB source only 
(VPS?) to get range 
(VPS+) 
(VPS-) 
167V Volume  VOL RW 0 10 5  1 0~10