InFocus Projector IN118HDxc User Manual

30
TimerAuto Off Time : aut
 omatically turns the projector off after no signals are 
detected for a preset number of minutes. If an active signal is received before 
the projector powers down, the image will be displayed.
High Altitude Setting High Altitude : W
 e recommend you turn on the High Altitude Mode when 
your environment is between 5000' ( 1500m) and 10,000' (3000m) above sea 
level.
Status/Service:
Source Info : a read-only display of current source settings.
Projector Info : a...

31
Maintenance
Cleaning the lens
1Apply a non-abrasive camera lens cleaner to a soft, dry cloth.
• Projector must be off and the le ns
  must be at room temperature.
• Avoid using an excessive amount of  cleaner, and don’t apply the cleaner 
directly to the lens. Abrasive cleane rs, solvents or other harsh chemicals 
might scratch the lens.
2Lightly wipe the cleaning cloth over the lens in a circular motion.
WARNINGS: • Turn the projector off and unplug power cord before cleaning any part of the pro...

32
Replacing the projection lamp
The Lamp Hours timer in the Projector Info menu counts the number of hours the 
lamp has been in use.
• NOTE: Be su
 re to use the InFocus lamp module designed for this projector. 
You can order new lamps from  www.infocus.com (in select areas), your 
retailer or your dealer.  Only genuine InFocus lamps are tested for use in this 
projector.  Use of non InFocus lamps may cause electrical shock and fire, and 
may void the projector warranty.  InFocu s is not liable for the...

33
1
Turn off the projector and unplug the power cord.
2Wait 60 minutes to allow the projector to cool thoroughly. 
3Remove the lamp door, loca
ted on top of the projector, by removing the screw 
on the side of the lamp door, sliding the door right, and lifting the lamp door off.
4Loosen the captive screws that attach  the lamp housing to the projector.  
NOTE: I
f the projector is installed on a  ceiling mount, be careful not to drop the 
lamp module once the captive screws are loosened.
5Carefully lift...

34
Numerics
3D Sync Invert 27
A
AC Power On 29
Aspect Ratio 26
Audio 1/Audio 2 8
Auto Image 26
Auto Off Time 30
Auto Source 29
AV Mute 28
B
Blank Key 28
Blank Screen 28
Brightness 26
C
Cable box 11
Ceiling Mount 26, 28
Closed Captions 28
Color Space 27
Computer 1 28
Computer 1/Computer 2 8
Computer 2 28
ConnectingVideo device 11
Contacting InFocus 19
Contrast 26
Customer service contact information 19 D
Digital Zoom 28
E
Eco Blanking 29
F
Factory Reset 30
Focus 10
Freeze Screen 28
G
Gamma 27
H
HDMI 28...

35
menu usage 25
Mute 28
O
Overscan 27, 28
P
Phase 27
PIN Protect 29
Power connector 8
Power cord 8
Power Saving Mode 29
Prevent PC Screen Saver 27
Programmed Dimming 29
ProjectorConnecting video devices 11
Keypad buttons 22
Menus 25
Positioning 6
Setting up 6
Troubleshooting problems 12
Projector Info 28, 30
R
Rear Project 28
Red/Green/Blue Gain 27
Red/Green/Blue Offset 27
remote control 20
Resetting the projector 30
S
Screen Aspect 11 Search Screen 29
Service 30
Sharpness 26
Show Messages 29
Source 28...