Iiyama Prolite E2273hds 1 User Manual

ENGLISH
  OPERATING THE MONITOR   15  
Memory Recall
Factory-preset data is restored.
English
DeutschEnglish
German FrançaisFrenchJapanese Finnish
ItalianoItalianTraditional Chinese Simplifi ed Chinese 
EspañolSpanishSuomi
H.PositionOSD is too left
OSD is too right
OSD is too low
OSD is too high
You can set the OSD display duration time 
between 5 and 60 seconds.V.Position
Adjustment Item
Problem / Option                                      Button to Press
Setup MenuSetup Menu
Language Select
OSD...

ENGLISH
16  OPERATING THE MONITOR 
● Lock Mode

1. The OSD lock will be activated by pressing the front buttons  and  for about 10 seconds. If you 
try to access the OSD by pressing any of the buttons 
, ,  and , message OSD Locked will 
appear on the screen.
2. The OSD lock will be deactivated by pressing the front buttons 
 and  again for 10 seconds.

1. The power switch lock will be activated by pressing the front buttons  and  for 10 seconds. 
Locking the power switch means that wont be able to turn...

ENGLISH
  OPERATING THE MONITOR   17  
SCREEN ADJUSTMENTS
 The screen adjustments described in this manual are designed to set image position and minimize 
fl icker or blur for the particular computer in use. 
 The monitor is designed to provide the best performance at resolution of 1920 × 1080, but can not 
provide the best at resolutions of less than 1920 × 1080 because the picture is automatically stretched 
to fi t the full screen. It is recommended to operate at resolution of 1920 × 1080 in normal...

ENGLISH
18  OPERATING THE MONITOR 
F  1) Adjust the H.Position so that the left side of the picture frame will move to the left edge of  
  the display area.
 When the left side of the picture frame moves apart from the left edge of the display 
area during the Clock adjustment, adjust steps 1) and 2).
 Another way to make the Clock adjustment is to correct the vertical wavy lines in the 
zebra pattern.
 The picture may fl icker during the Clock, H.Position and V.Position adjustment.
 In case the...

ENGLISH
  OPERATING THE MONITOR   19  
 In case the strong fl icker or blurs remain on a part of the screen, repeat steps 
F and 
G  because the Clock may not be adjusted correctly. If the fl icker or blurs still remain, 
set the refresh rate of computer to low (60Hz) and repeat steps from 
C again.
 Adjust the H.Position after the Phase adjustment if the horizontal position moves 
during the adjustment. G  Adjust the Phase to correct horizontal wavy noise, fl icker or blur in the zebra pattern.NOTE
H...

ENGLISH
20  OPERATING THE MONITOR 
Even when using the power management mode, the monitor consumes electricity. Turn off 
the Power Switch whenever the monitor is not in use, during the night and weekends, to 
avoid unnecessary power consumption.
It is possible that the video signal from the computer may be on while the H or V sync 
signal is missing. In this instance, the POWER MANAGEMENT feature may not work 
properly.
POWER MANAGEMENT FEATURE
Power Management Mode        
When the H-sync signal...

ENGLISH
  TROUBLE SHOOTING  21  
TROUBLE SHOOTING
1. Perform the adjustments described in OPERATING THE MONITOR, depending on the problem you 
have. If the monitor does not get a picture, skip to 2.
2. Consult the following items if you cannot fi nd an appropriate adjustment item in OPERATING THE 
MONITOR or if the problem persists.
3. If you are experiencing a problem which is not described below or you cannot correct the problem, 
discontinue using the monitor and contact your dealer or iiyama service...

ENGLISH
22  TROUBLE SHOOTING / RECYCLING INFORMATION
No sound.The audio equipment (computer etc.) is ON.
The Audio Cable is properly connected.
The Volume is turned up.
The Mute is OFF.
The audio output level of the audio equipment is within the specifi cation 
of the monitor.
The audio output level of the audio equipment is within the specifi cation 
of the monitor.
The Audio Cable is properly connected.
The sound is too 
loud or too quiet.
A strange noise is 
heard.
For better environment...

ENGLISH
  APPENDIX  23  
SPECIFICATIONS
APPENDIX 
* Audio equipment is not connected. 
LCD Panel  Driving system
a-Si TFT Active Matrix
0.248mm H × 0.248mm V
Response time Pixel pitch
5ms (Black, White, Black), 2ms (Gray to Gray)
Display ColorsApprox.16.7M
Sync FrequencyAnalog: Horizontal: 24.0-80.0kHz, Vertical: 55-75Hz 
Digital: Horizontal: 30.0-80.0kHz, Vertical: 55-75Hz 
Maximum Resolution
1920 × 1080, 2.1 MegaPixels
Input Connector
D-Sub mini 15 pin, DVI-D 24 pin,HDMI 
Input Sync Signal Separate...

ENGLISH
24  APPENDIX
DIMENSIONS
M074B21
COMPLIANT TIMING
Dot Clock
25.175MHz
31.500MHz
31.500MHz
36.000MHz
40.000MHz
49.500MHz
65.000MHz
75.000MHz
78.750MHz
108.000MHz
135.000MHz
106.500MHz
136.750MHz
146.250MHz
138.500MHz
21.053MHz Vertical
Frequency
59.940Hz
75.000Hz
72.809Hz
56.250Hz
60.317Hz
75.000Hz
60.004Hz
70.069Hz
75.029Hz
60.020Hz
75.025Hz
59.887Hz
74.984Hz
60.000Hz
59.930Hz
56.424Hz
VESA
SVGA VGA
XGA 1024 × 768640 × 480
800 × 600Horizontal 
Frequency
31.469kHz
37.500kHz
37.861kHz
35.156kHz...