Icom Ic-r5 Communications Reciever Instruction Manual

60
11
FREQUENCY TABLE
New2001
11
Other communications— other countries
CH Frequency
1 446.00625
2 446.01875
3 446.03125
4 446.04375
5 446.05625
6 446.06875
7 446.08125
8 446.09375D D
PMR446 channels
(unit: MHz)
CH Frequency
59 434.525
60 434.550
61 434.575
62 434.600
63 434.625
64 434.650
65 434.675
66 434.700
67 434.725
68 434.750
69 434.775
CH Frequency
1 433.075
2 433.100
3 433.125
4 433.150
5 433.175
6 433.200
7 433.225
8 433.250
9 433.275
10 433.300
11 433.325
12 433.350
13 433.375
14 433.400
15...

61
11
FREQUENCY TABLE
New2001
CH Frequency
1 476.425 MHz
2 476.450 MHz
3 476.475 MHz
4 476.500 MHz
5 476.525 MHz
6 476.550 MHz
7 476.575 MHz
8 476.600 MHz
9 476.625 MHz
10 476.650 MHz
11 476.675 MHz
12 476.700 MHz
13 476.725 MHz
14 476.750 MHz
15 476.775 MHz
16 476.800 MHz
17 476.825 MHz
18 476.850 MHz
19 476.875 MHz
20 476.900 MHzD D
UHF C.R.S 
(Citizen Radio Service) 
channels
CH Frequency
21 476.925 MHz
22 476.950 MHz
23 476.975 MHz
24 477.000 MHz
25 477.025 MHz
26 477.050 MHz
27 477.075 MHz
28...

62
12
MAINTENANCE
1112
PROBLEM POSSIBLE CAUSE SOLUTION REF.
Troubleshooting
If your receiver seems to be malfunctioning, please check the
following points before sending it to a service center.
No power comes on.
No sound comes from the
speaker.
Sensitivity is low and only
strong signals are audible.
Frequency cannot be set.
No beep sound.
Receive audio is distorted.
Desired set mode item
cannot be selected.
Programmed scan does
not start.
Memory or bank scan
does not start.
Installed batteries cannot...

63
12
MAINTENANCE
New2001
CP-18A/E fuse replacementIf the fuse blows or the receiver stops functioning while oper-
ating with the optional CP-18A/E, find the source of the prob-
lem if possible, and replace the damaged fuse with a new,
rated one (FGB 5 A) as shown below.
Fuse 5 A
IC-R5_1.qxd  02.10.23 11:29  Page 63 (1,1) 

64
13
SPECIFICATIONS
1213
D D
GENERAL•Frequency coverage :
(Unit: MHz)
USA 0.150–823.995, 849.000–868.995,
894.000–1309.995
France 0.150–29.995, 50.200–51.200, 
87.500–108.000, 144.000–146.000, 
430.000–440.000,
1240.000–1300.000
Other than above 0.150–1309.995 MHz
•Number of memory channels : 1250 (incl. 50 scan edges and 200
auto write channels)
•Frequency resolution : 5, 6.25, 8.33,* 9*, 10, 12.5, 15, 20,
25, 30, 50, 100 kHz
*selectable depending on the operating frequency band.
•Operating temperature...

65
OPTIONS
New2001 New2001
14OptionsBC-149 A/D 
AC ADAPTER
Regularly charges the installed
batteries. 
6 V DC/1 A output.
CP-18A/E
CIGARETTE LIGHTER
CABLE WITH DC
-DC CONVERTER
Allows you to operate the re-
ceiver through a 12 V cigarette
lighter socket, and also charges
the installed rechargeable bat-
teries regularly. A DC-DC con-
verter is built-in.
AD-92SMA
ANTENNA
CONNECTOR ADAPTER
Allows you to connect an exter-
nal antenna with a BNC con-
nector.
SP-13
EARPHONE
Provides clear receive audio in...

New2001
q
w
iR5
 VFO and memory mode selection
POCKET GUIDE
Push [V/M•S.MW•~] to toggle 
between VFO and memory mode.➥
 Receive mode selection
Push [MODE•SCAN] several 
times to select the desired mode➥
 Audio level setting
Push [Y] to increase, push [Z] 
to decrease the audio level.
➥
 Squelch level setting
While pushing [SQL], rotate 
[DIAL]  to set the squelch level.
➥
 Frequency band selection
Push [BAND•         ] several times, 
or while pushing [BAND•     ], 
rotate [DIAL] to select the...

New2001
q
w
e
r
 Memory channel programming
Set the desired frequency and 
other functions in VFO mode.
Push [V/M•S.MW•~] for 1 sec. 
to enter select memory write 
condition.
• 1 short and 1 long beeps sound.Rotate [DIAL] to select the 
desired memory channel number.
Push [V/M•S.MW•~] for 1 sec. 
again to program the contents 
into the selected channel.
• 3 beeps sound.
q
w
e
 Scan skip setting
Push [V/M•S.MW•~] to select 
memory mode.
Rotate [DIAL] to select the 
desired memory channel.
While pushing...

DECLARATION
OF CONFORMITY
68
16
CE
16
New2001
We Icom Inc. Japan
1-1-32, Kamiminami, Hirano-ku
Osaka 547-0003, Japan
Declare on our sole responsibility that this equipment complies with the
essential requirements of the Radio and Telecommunications Terminal
Equipment Directive, 1999/5/EC, and that any applicable Essential Test
Suite measurements have been performed.Kind of equipment: COMMUNICATIONS RECEIVERType-designation:
iR5
Version (where applicable):
This compliance is based on conformity with the...

1-1-32 Kamiminami, Hirano-ku, Osaka 547-0003 Japan
A-6198H-1EX-q
Printed in Japan©2002 Icom Inc.
New2001
IC-R5_1.qxd  02.10.23 11:29  Page 69 (1,1)