Husqvarna P-zt 60 Manual
Here you can view all the pages of manual Husqvarna P-zt 60 Manual. The Husqvarna manuals for Lawn Mower are available online for free. You can easily download all the documents as PDF.
Page 31
10. Fill with 20W50 motor oil until oil just appears at the bottom of each transaxles’ top port (approximately 2 quarts per transaxle, 4 quarts total). Install the top port lug into each transaxle as the oil level reaches the port. 11. Reinstall and torque the top port plugs to 180 in./lbs. 12. Continue to fill the transaxles through the expansion tank until the FULL COLD line is reached (this will take approximately 23 additional ounces). 13. Reinstall the expansion tank cap by hand. Do not...
Page 32
Engine will not start Blade switch is engaged Steering controls are not locked in the neutral position Park brake is not activated Dead battery Contamination in the carburetor or fuel line Fuel supply shutoff valve is closed or in the wrong position Clogged fuel filter or fuel line Ignition system faulty Starter does not turn the engine over Dead battery Battery terminal cable contacts are defective Blown fuse Fault in the starter safety circuit. See Safety System in the Maintenance Section Engine runs...
Page 33
Winter Storage The machine should be readied for storage at the end of the mowing season, or if it will not be in use for more than 30 days. Fuel allowed to stand for long periods of time (30 days or more) can leave sticky residues that can plug the carburetor and disrupt engine function. Fuel stabilizers are an acceptable option as regards to the sticky residues that can occur during storage. Add stabilizer to the fuel in the tank or in the storage container. Always use the mixing ratios specified by...
Page 34
TIMER SCHEMATIC 34 SCHEMATIC
Page 35
ENGINE ManufacturerKawasaki TypeFX751V Power24.5 hp 1) LubricationPressure with oil filter FuelMin 87 octane unleaded (Max ethanol 10%, Max MTBE 15%) Fuel tank capacity11 gallons CoolingAir cooled Air filterHeavy duty canister Alternator12v 15 amp @ 3600 rpm StarterElectric TRANSMISSION TransmissionZT-3400 Steering controlDual levers, foam gripped Speed forward0-10 mph Speed reverse0-5 mph BrakesInternal Cog Front caster tires13 x 6.5-6 Rear tires, turf pneumatic23 x 10.5-12 Tire pressure15 PSI / 103 kPa...
Page 36
Standard 1/4" fasteners 9 ft/lb Standard 5/16" fasteners 18 ft/lb Standard 3/8" fasteners 33 ft/lb Standard 7/16" fasteners 52 ft/lb Standard 1/2" fasteners 80 ft/lb HEX HEAD CAP SCREWS The torque values shown should be used as a general guideline when specific torque values are not given. U.S. Standard Hardware GradeSAE Grade 5SAE Grade 8Flangelock Screw w/Flangelock Nut Sizeft./lbsNmft./lbsNmft./lbsNm Shank Size (Diameter in inches, fine or coarse thread) 1/49121318...
Page 37
DELIVERY SERVICE ActionDate, mtr reading, stamp, sign Charge and connect the batteryr Adjust the tire pressure of all wheels to 15 PSI (1 bar)r Connect the contact box to the cable for the seat’s safety switchr Check hydraulic oil levelr Check hydraulic hoses for kinking or leaksr Check neutral positionr Fill with fuel and open the fuel shut off valver Start the enginer Check that there is drive to both wheelsr Check mower deck pitch and adjustmentr Check: Safety switch for the park braker Safety switch...
Page 38
AFTER 10 HOURS ActionDate, mtr reading, stamp, sign Change the engine oilr Change the oil filterr Inspect hydraulic hosesr Inspect hydraulic beltr Inspect hydraulic filterr Check neutral positionr Check safety systemr Check seat beltr Check ROPSr Check fuel system for leaksr Inspect safety guards and shieldsr Check brake adjustmentr DAILY SERVICE ActionDate, mtr reading, stamp, sign Clean debris from mowerr Check engine oil levelr Check the tire pressuresr Check underside of deckr Inspect deck pulleysr...
Page 39
50-HOUR SERVICE ActionDate, mtr reading, stamp, sign Clean debris from mowerr Check engine oil levelr Check the tire pressuresr Check underside of deckr Inspect deck pulleysr Check/clean the engine’s cooling air intaker Check safety systemr Check seat beltr Check ROPSr Check fuel system for leaksr Inspect safety guards and shieldsr Check brake adjustmentr 39 SERVICE JOURNAL
Page 40
250-HOUR SERVICE ActionDate, mtr reading, stamp, sign Grease fittings (caster pivots and caster wheels)r Inspect dampersr Inspect framer Inspect throttle and choke cablesr Inspect hardwarer Check the tire pressuresr Change the engine oil and filterr Change air filterr Inspect spark plugr Inspect fuel filterr Check engine RPMr Clean underside of deckr Check blade pitchr Grease blade spindlesr Inspect spindle bearingsr Inspect deck belt and bladesr Inspect idler arm bearingsr Inspect deck idler pulleysr...