HP Stream 7 Owners Manual

5.Slide off the metal audio-out (headphone)/audio-in (microphone) jack, and micro USB 2.0 port 
protection plate 
(3). Retain this plate to insert on the replacement system board.NOTE:The protection plate and the left side of the system board are also held in place by two screws 
that were previously removed when the mid-frame cover was removed.
Reverse this procedure to install the system board.
System board25  

Power button boardDescriptionSpare part numberPower button board796791-001
Before removing the power button board, follow these steps:
1.Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on, and 
then shut it down through the operating system.
2.Disconnect the power from the tablet by unplugging the power adapter cord from the tablet.
3.Disconnect all external devices from the tablet.
4.Remove the back cover (see Back cover on page 13).
5.Remove the...

Power buttonDescriptionSpare part numberPower button796793-001
Before removing the power button, follow these steps:
1.Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on, and 
then shut it down through the operating system.
2.Disconnect the power from the tablet by unplugging the power adapter cord from the tablet.
3.Disconnect all external devices from the tablet.
4.Remove the back cover (see Back cover on page 13).
5.Remove the mid-frame cover (see...

Volume control buttonDescriptionSpare part numberVolume control button796794-001
Before removing the volume control button, follow these steps:
1.Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on, and 
then shut it down through the operating system.
2.Disconnect the power from the tablet by unplugging the power adapter cord from the tablet.
3.Disconnect all external devices from the tablet.
4.Remove the back cover (see Back cover on page 13).
5.Remove...

6Specifications
 MetricU.S.Dimensions (portrait orientation)Height11.07 cm4.36 inWidth19.27 cm7.59 inDepth0.99 cm0.37 inWeight (lowest weight configuration)0.36 kg0.79 lbInput powerThe tablet operates on DC power, which can be supplied by an AC or a DC power source. The AC power source must be rated at 
100-240 V, 50/60 Hz, 0.3-1.0 A.NOTE:The tablet can operate on DC power using an industry-standard micro-B USB cable. The HP 5V 2A adapter included with your 
tablet is recommended for charging the...

7Using HP PC Hardware Diagnostics (UEFI)
HP PC Hardware Diagnostics is a Unified Extensible Firmware Interface (UEFI) that allows you to run 
diagnostic tests to determine whether the tablet hardware is functioning properly. The tool runs outside the 
operating system so that it can isolate hardware failures from issues that are caused by the operating 
system or other software components.
To start HP PC Hardware Diagnostics (UEFI):
1.Turn off the tablet.
2.Press and hold the Volume down button.
3.While...

8Backup and recovery
To protect your information, use Windows backup and restore utilities to back up individual files and folders, 
back up your entire hard drive, or create system restore points. In case of system failure, you can use the 
backup files to restore the contents of your tablet.
1.Swipe from the right edge of the touch screen to display the charms, tap Search, and then tap the 
search box.
2.In the search box, type restore, and then select from the list of displayed options.
NOTE:For...

5.While continuing to hold the Volume down button, press the power button to turn on the tablet.
The Startup menu is displayed.
After the startup menu is displayed, release the Volume down button.
6.Tap F9 Boot Options.
7.Select the external flash drive as the boot device.
8.Restart the tablet, and follow the on-screen instructions to continue.
Using Windows Refresh or Windows Reset
When your tablet is not working properly and you need to regain system stability, the Windows Refresh option allows you to...

9Power adapter requirements
The wide-range input feature of the tablet permits it to operate from any line voltage from 100 to 120 volts 
AC, or from 220 to 240 volts AC.
The 2-conductor power adapter included with the tablet meets the requirements for use in the country or 
region where the equipment is purchased.
Power adapters for use in other countries and regions must meet the requirements of the country or region 
where the tablet is used.
Requirements for all countries
The following requirements...

Country/regionAccredited agencyNorwayNEMKOThe People's Republic of ChinaCCCSaudi ArabiaSASOSingaporePSBSouth AfricaSABSSouth KoreaKTLSwedenSEMKOSwitzerlandSEVTaiwanBSMIThailandTISIThe United KingdomASTAThe United StatesUL34Chapter 9   Power adapter requirements