HP LaserJet Pro CM1415fn User Manual
Have a look at the manual HP LaserJet Pro CM1415fn User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 1114 HP manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
Network Setup menu In the following table, items that have an asterisk (*) indicate the factory default setting. Menu itemSub-menu itemDescription Wireless MenuWireless Setup WizardGuides you through the steps to set up the product on a wireless network Wi-Fi Protected SetupIf your wireless router supports this feature, use this method to set up the product on a wireless network. This is the simplest method. Run Network TestTests the wireless network and prints a report with the results. Turn Wireless On/OffEnables or disables the wireless network feature. TCP/IP ConfigAutomatic* ManualAutomatic : The product automatically configures all the TCP/IP settings via DHCP, BootP or AutoIP. Manual : You can manually configure the IP address, subnet mask, and default gateway. The control panel prompts you to specify values for each address section. As each address is completed, the product prompts for address confirmation before moving to the next one. After all three addresses are set, the network reinitializes. Auto CrossoverOn * OffEnables or disables the use of a standard 10/100 network cable when the product is directly connected to a coomputer. Network ServicesIPv4 IPv6Enable or disable the IPv4 and IPv6 protocols. By default, each protocol is enabled. Link SpeedAutomatic * 10T Full 10T Half 100TX Full 100TX HalfSets the link speed manually if needed. After setting the link speed, the product automatically restarts. Restore Defaults Resets all network configurations to their factory defaults. ENWW Setup Menu 25
Function specific menus The product features function-specific menus for copying, faxing, scanning, and using a USB flash drive. To open these menus, touch the button for that function on the control panel. Copy Menu To open this menu, touch the Copy button, and then touch the Settings... button. NOTE:Settings that you change with this menu expire 2 minutes after the last copy completes. Menu itemSub-menu itemSub-menu itemDescription ID Copy NOTE:This item is available from the main Copy screen. You do not need to touch the Settings... button to access it. Copies both sides of identification cards, or other small-size documents, onto the same side of one sheet of paper. Number of Copies(1–99) Specifies the number of copies Reduce/EnlargeOriginal=100% Legal to Letter=78% Legal to A4=83% A4 to Letter=94% Letter to A4=97% Full Page=91% Fit to Page 2 Pages per Sheet 4 Pages per Sheet Custom: 25 to 400% Specifies the size of the copy. Lighter/Darker Specifies the contrast of the copy. OptimizeDescribe OriginalAuto Select Mixed Text PictureSpecifies the type of content in the original document, so the copy is the best match for the original. PaperPaper Size Paper Type Specifies the paper size and type for copies. Multi-Page Copy Off On When this feature is on, the product prompts you to load another page onto the scanner glass or to indicate that the job is complete. 26 Chapter 2 Control panel menus ENWW