HP LaserJet 1005w User Manual

Use watermarks
A watermark is a notice, such as “Confidential,” that is printed in the background of each page of a
document.
1.On the File  menu, click  Print.
2. Open the  Watermarks  menu.
3. Next to  Mode, select the type of watermark to use. Select  Watermark to print a semi-transparent
message. Select  Overlay to print a message that is not transparent.
4. Next to  Pages, select whether to print the watermark on all pages or on the first page only.
5. Next to Text , select one of the standard...

Print on both sides of the page (duplex printing)
Print on both sides manually1.Insert enough paper into one of the trays to accommodate the print job. If you are loading special
paper such as letterhead, load it in one of the following ways:
●For Tray 1, load the letterhead paper face-up with the top edge feeding into the product first.
● For all other trays, load the letterhead paper face-down with the top edge at the front of the
tray.
2. On the File  menu, click  Print.
3. On the Finishing menu,...

5 Connectivity
●USB and parallel connections
●
Network configuration
ENWW 23
 

USB and parallel connections
1.Insert the software installation CD into the computer CD-ROM drive.
2. If the installation program does not start automatically, browse the CD contents and run the
SETUP.EXE file.
3. Follow the on-screen instructions.
NOTE: During the installation, there is a prompt to plug in the parallel or USB cable.
Figure 5-1   Parallel connection
Figure 5-2  USB connection
24 Chapter 5   Connectivity ENWW
 

Network configuration
You might need to configure certain network parameters on the product. You can configure these
parameters from the embedded Web server. See 
Embedded Web server on page 57.
Supported network protocols
The product supports the TCP/IP network protocol. It is the most widely used and accepted networking
protocol. Many networking services utilize this protocol. This product also supports IPv4 and IPv6. The
following tables list the networking services/protocols that are supported on the...

Service nameDescription
BOOTP (bootstrap protocol)For Automatic IP address assignment. BOOTP server
provides the product with an IP address. Requires
administrator to input the product MAC hardware address on
BOOTP server in order for product to obtain an IP address from
that server.
Auto IPFor Automatic IP address assignment. If neither a DHCP
server nor a BOOTP server is present, this service allows the
product to generate a unique IP address.
Install the product on a network
In this configuration, the...

Set or change the network password
Use the embedded Web server to set a network password or change an existing password.
1.Open the embedded Web server and click the  Networking tab.
2. In the left-side pane, click the  Password button.
NOTE:If a password has previously been set, you are prompted to type the password. Type the
password, and then click the  Apply button.
3.In the  Device Password  area, type the new password in the  Password box and in the  Confirm
Password  box.
4. At the bottom of the...

28 Chapter 5   ConnectivityENWW
 

6 Paper and print media
●Understand paper and print media use
●
Supported paper and print media sizes
●
Custom paper sizes
●
Supported paper and print media types
●
Tray and bin capacity
●
Special paper or print media guidelines
●
Load trays
●
Configure trays
●
Use paper output options
ENWW 29
 

Understand paper and print media use
This product supports a variety of paper and other print media in accordance with the guidelines in this
user guide. Paper or print media that does not meet these guidelines might cause the following problems:
●Poor print quality
● Increased jams
● Premature wear on the product, requiring repair
For best results, use only HP-brand paper and print media designed for laser printers or multiuse. Do
not use paper or print media made for inkjet printers. Hewlett-Packard...