HP DesignJet 70 User Manual

							HP Designjet 70/110plus Printer series—Quick Reference Guide
50 11.Any applicable print cartridge warranty shall not apply to HP print cartridges 
that have been refilled, remanufactured, refurbished, misused, or tampered 
with in any way.
B. Limitations of warranty
1. TO THE EXTENT ALLOWED BY LOCAL LAW, NEITHER HP NOR ITS THIRD 
PARTY SUPPLIERS MAKE ANY OTHER WARRANTY OR CONDITION OF ANY 
KIND, WHETHER EXPRESS OR IMPLIED, WITH RESPECT TO THE HP 
PRODUCTS, AND SPECIFICALLY DISCLAIM THE IMPLIED WARRANTIES OR 
CONDITIONS OF MERCHANTABILITY, SATISFACTORY QUALITY, AND 
FITNESS FOR A PARTICULAR PURPOSE.
C. Limitations of liability
1. To the extent allowed by local law, the remedies provided in this Warranty 
Statement are the customer’s sole and exclusive remedies.
2. TO  TH E EX TEN T A LLOWE D BY  LO CAL  L AW,  EXCE PT FO R TH E OB LI GATIO NS 
SPECIFICALLY SET FORTH IN THIS WARRANTY STATEMENT, IN NO EVENT 
SHALL HP OR ITS THIRD PARTY SUPPLIERS BE LIABLE FOR DIRECT, INDIRECT, 
SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES, WHETHER BASED 
ON CONTRACT, TORT, OR ANY OTHER LEGAL THEORY AND WHETHER 
ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.
D. Local law
1. This Warranty Statement gives the customer specific legal rights. The customer 
may also have other rights which vary from state to state in the United States, 
from province to province in Canada, and from country to country elsewhere in 
the world.
2. To the extent that this Warranty Statement is inconsistent with local law, this 
Warranty Statement shall be deemed modified to be consistent with such local 
law. Under such local law, certain disclaimers and limitations of this Warranty 
Statement may not apply to the customer. For example, some states in the 
United States, as well as some governments outside the United States (including 
provinces in Canada), may:
a. Preclude the disclaimers and limitations in this Warranty Statement from 
limiting the statutory rights of a consumer (e.g. the United Kingdom);
b. Otherwise restrict the ability of a manufacturer to enforce such disclaimers or 
limitations; or
HP limited warranty statement (continued)
 
						

							HP Designjet 70/110plus Printer series—Quick Reference Guide
51 c. Grant the customer additional warranty rights, specify the duration of 
implied warranties which the manufacturer cannot disclaim, or not allow 
limitations on the duration of implied warranties.
3. FOR CONSUMER TRANSACTIONS IN AUSTRALIA AND NEW ZEALAND, 
THE TERMS IN THIS WARRANTY STATEMENT, EXCEPT TO THE EXTENT 
L AWFULLY PE RM IT TE D, DO NOT EXCLUD E, RESTRICT, OR MOD I FY, AND  ARE  
IN ADDITION TO, THE MANDATORY STATUTORY RIGHTS APPLICABLE TO 
THE SALE OF HP PRODUCTS TO SUCH CUSTOMERS.
Revision: February 10th, 2003
HP limited warranty statement (continued)
 
						

							HP Designjet 70/110plus Printer series—Quick Reference Guide
52
Regulatory notices
You can obtain current Material Safety Data Sheets for the ink systems used in the 
printer by mailing a request to this address: Hewlett-Packard Customer Information 
Center, 19310 Pruneridge Avenue, Dept. MSDS, Cupertino, CA 95014, U.S.A.
There is also a Web page:
http://www.hp.com/hpinfo/community/environment/productinfo/psis_inkjet.htm
Regulatory Model Number
For regulatory identification purposes, your product is assigned a Regulatory Model 
Number. The Regulatory Model Number for your product is BCLAA-0301, BCLAA-
0302 and BCLAA-0408, depending of your product size. This regulatory number 
should not be confused with the marketing name (such as HP Designjet printer) or 
product numbers (such as Z####X where Z and X are any single letter and # is any 
number).
Electro-Magnetic Compatibility (EMC)
FCC statements (U.S.A.)
The U.S. Federal Communications Commission (in 47 cfr15.105) has specified that 
the following notices be brought to the attention of users of this product.
Product identification numbers:
HP Printer with identification numbers: BCLAA-0301, BCLAA-0302, BCLAA-0408.
This device complies with part 15 of the FCC rules. Operation is subject to the 
following two conditions: (1) this device may not cause harmful interference, and 
(2) this device must accept any interference received, including interference that 
may cause undesired operation. 
Shielded cables
Use of shielded data cables is required to comply with the Class B limits of Part 15 
of the FCC Rules.
Caution: Pursuant to Part 15.21 of the FCC Rules, any changes or modifications 
to this equipment not expressly approved by the Hewlett-Packard Company may 
cause harmful interference and void the FCC authorization to operate this 
equipment.
Note: This equipment has been tested and found to comply with the limits for a 
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are 
designed to provide reasonable protection against harmful interference in a 
residential installation. This equipment generates, uses, and can radiate radio
 
						

							HP Designjet 70/110plus Printer series—Quick Reference Guide
53 frequency energy and, if not installed and used in  accordance with the instructions, 
may cause harmful interference to radio communications. However, there is no 
guarantee that interference will not occur in a particular installation. If this 
equipment does cause harmful interference to radio or television reception, which 
can be determined by turning the equipment off and on, the user is encouraged to 
try to correct the interference by one or more of the following measures:
• Reorient the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which 
the receiver is connected.
• Consult your dealer or an experienced radio/TV technician.
You may find useful the following booklet prepared by the FCC: “How to Identify 
and Resolve Radio-TV Interference Problems”. This booklet is available from the US 
Government Printing Office, Washington, DC 20402, Stock No. 004-000-00345-
4.
Normes de sécurité (Canada)
Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les 
limites applicables aux appareils numériques de Classe B prescrites dans le 
réglement sur le brouillage radioélectrique édicté par le Ministére des 
Communications du Canada. 
DOC statement (Canada)
This digital apparatus does not exceed the Class B limits for radio noise emissions 
from digital apparatus set out in the Radio Interference Regulations of the Canadian 
Department of Communications.
Korean EMI statement
Regulatory notices (continued)
 
						

							HP Designjet 70/110plus Printer series—Quick Reference Guide
54 VCCI Class B (Japan)
Safety Power cord warning
Taiwanese EMI statement
Chinese EMI Statement
Sound (Germany)
Geräuschemission (Germany) LpA < 70 dB, am Arbeitsplatz, im Normalbetrieb, 
nach DIN45635 T. 19.
Regulatory notices (continued)
 
						

							HP Designjet 70/110plus Printer series—Quick Reference Guide
55
DECLARATION OF CONFORMITY
according to ISO/IEC Guide 22 and EN 45014
Supplier‘s Name:Hewlett-Packard Company
Supplier's Address:Avda. Graells, 501
08174 Sant Cugat del Vallès
Barcelona, Spain
declares that the product
    Regulatory Model: 
3)BCLAA-0301
BCLAA-0302
BCLAA-0408
    Product Family:HP Designjet Inkjet Printers
    Product Options:
All
4)
Conforms to the following Product Specifications
    Safety: IEC 60950-1:2001 / EN 60950-1:2001
    EMC:
CISPR 22:1997 / EN 55022:1998 Class B
1)
E N  55024:1 998 +A 1
EN 61000-3-2:2000
EN 61000-3-3:1995+A1:2001
FCC Title 47 CFR, Part 15 Class B
2)
Additional Information
The product herewith complies with the requirements of the Low-Voltage Directive 73/23/EEC and the EMC 
Directive 89/336/EEC and carries the CE marking accordingly.
(1)The product was tested in a typical configuration with HP Personal Computer Systems and peripherals.(2)This Device complies with Part 15 of the FCC Rules. Operation is subject to the following two Conditions:  (1) 
this device may not cause harmful interference, and (2) this device must accept any interference received, including 
interference that my cause undesired operation. 
(3)This product is assigned a Regulatory model number which stays with the regulatory aspects of the design. The 
Regulatory Model Number is the main product identifier in the regulatory documentation and test reports, this 
number should not be confused with the marketing name or the product numbers.
(4)Except bundles including p/n: Q1292-60058  EyeOne Kit, which are only intended for EMEA market.
Sant Cugat del Vallès 
(Barcelona),
January 25
th, 2005
Josep-Maria Pujol,
Product Regulations Manager
Local contact for regulatory topics only:
European Contact:
USA Contact:
Australia Contact:Hewlett-Packard GmbH, HQ-TRE, Herrenberger Strasse 140, 71034 
Boeblingen, Germany 
Hewlett-Packard Company, HPCC, 20555 S.H. 249 Houston, Texas, 
7 7070
Hewlett-Packard Australia Ltd, Product regulations Manger, 31-41 
Joseph Street, Blackburn, Victoria, 3130, Australia
 
						

							Printed on recycled
paper
Imprimé sur
du papier recyclé
Stampato su
carta riciclata
Gedruckt auf
Recyclingpapier
Impreso en papel
reciclado
© Hewlett-Packard Company, 2005
04/2005
Q6655-90011
Printed in Germany.
Imprimé en Allemagne.
Stampato in Germania.
Hewlett Packard Company
Avenida Graells, 501
08174 Sant Cugat del Vallés
Barcelona
Spain
Q6655-90011