HP Compaq Wf1907v User Guide

							
Technical Specifications
User’s GuideB–11
■w2408 supports preset modes 1 through 20
Factory Preset Video Input Modes, w2408
PresetResolution
Horizontal 
Frequency (kHz)Ve r t i c a l  
Frequency (Hz)
1 640 x 480 31.5 59.9
2 640 x 480 37.5 75.0
3 720 x 400 31.5 70.0
4 800 x 600 37.9 60.3
5 800 x 600 46.9 75.0
6 832 x 624 49.7 74.5
7 1024 x 768 48.4 60.0
8 1024 x 768 60.0 75.0
9 1152 x 720 44.8 60.0
10 1152 x 870 68.7 75.1
11 1280 x 768 47.4 60.0
12 1280 x 960 60.0 60.0
13 1280 x 1024 63.9 60.0
14 1280 x 1024 79.9 75.0
15 1440 x 900 55.9 59.9
16 1600 x 1000 61.6 60.0
17 1680 x 1050 65.3 60.0
18 1600 x 1200 75.0 60.0
19 1600 x 1200 93.8 75.0
20 1920 x 1200 74.0 60.0
 
						

							
Technical Specifications
B–12User’s Guide
LCD Monitor Quality and Pixel Policy 
The HP LCD Monitor uses high-precision technology, manufactured according to high standards, to help guarantee 
trouble-free performance. Nevertheless, the display may have  cosmetic imperfections that appear as small bright or 
dark spots. This is common to all LCD di splays used in products supplied by all vendors and is not specific to the 
HP LCD Monitor. These imperfections are caused by  one or more defective pixels or subpixels.
■ A pixel consists of one red, one green, and one blue subpixel.
■ A defective whole pixel is always turned on (a bright spot  on a dark background), or it is always off (a dark spot 
on a bright background). The firs t is the more visible of the two.
■ A defective subpixel (dot defect) is less visible than a de fective whole pixel, and is small and only visible on a 
specific background.
To locate defective pixels, the monitor should be viewed  under normal operating conditions and in normal operating 
mode at a supported resolution and refresh rate, fr om a distance of approximately 50 cm (16 inches).
We expect that, over time, the industry will continue to im prove its ability to produce displays with fewer cosmetic 
imperfections, and we will adjust gu idelines as improvements are made.
For more information about your HP LCD Monitor, refer to the HP Web site at:  http://www.hp.com/support
Power Cord Set Requirements
The monitor power supply is provided with Automatic Line Switching (ALS). This feature allows the monitor to \
operate 
on input voltages between 100–240V
v, 50/60 Hz, 1.5A.
The power cord set (flexible cord or wall plug) received  with the monitor meets the requirements for use in the 
country/region where you  purchased the equipment.
If you need to obtain a power cord for a different coun try/region, you should purchase a power cord that is 
approved for use in that country/region.
The power cord must be rated for the product and for the  voltage and current marked on the product’s electrical 
ratings label. The voltage and current rating of the cord sh ould be greater than the voltage and current rating marked 
on the product. In addition, the cross-sectional  area of the wire must be a minimum of 0.75 mm
² or 18AWG, and the 
length of the cord must be between 4.94 ft. (1.5 m) and 12 ft . (3.6 m). If you have questions about the type of power 
cord to use, contact your HP-authorized service provider.
A power cord should be routed so that it  is not likely to be walked on or pinched by items placed upon it or against 
it. Particular attention should be paid  to the plug, electrical outlet, and the point where the cord exits from the 
product.
 
						

							
User’s GuideC–1
C
Agency Regulatory Notices
Federal Communications Commission Notice
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 
of the FCC Rules. These limits are designed to provide re asonable protection against harmful interference in a 
residential installation. This equipment  generates, uses, and can radiate radio fr equency energy and, if not installed 
and used in accordance with the instructions, may cause  harmful interference to radio communications. However, 
there is no guarantee that interference will not occur in a  particular installation. If this equipment does cause harmful 
interference to radio or television reception, which can be  determined by turning the equipment off and on, the user 
is encouraged to try to correct the interference by one or more of the following measures:
■ Reorient or relocate the receiving antenna.
■ Increase the separation between the equipment and the receiver.
■ Connect the equipment into an outlet  on a circuit different from that to which the receiver is connected.
■ Consult the dealer or an experienced radio or television technician for \
help.
Modifications
The FCC requires the user to be notified  that any changes or modifications made  to this device that are not expressly 
approved by Hewlett-Packard Company may void  the user’s authority to operate the equipment.
Cables
Connections to this device must be made with shielded  cables with metallic RFI/EMI connector hoods to maintain 
compliance with FCC rules and regulations.
Declaration of Conformity for Products Marked with FCC Logo, 
United States Only
This device complies with Part 15 of the FCC Rules. Oper ation is subject to the following two conditions: (1) this 
device may not cause harmful interference, and (2) this de vice must accept any interference received, including 
interference that may cause undesired operation.
For questions regarding your product, contact:
Hewlett-Packard Company
P. O. Box 692000, Mail Stop 530113 
Houston, Texas 77269-2000
Or
Call: 1-800-474-6836
For questions regarding this FCC declaration, contact: Hewlett-Packard Company
P. O. Box 692000, Mail Stop 510101
Houston, Texas 77269-2000
Or
Call: 1-281-514-3333
To identify this product, refer to the part,  series, or model number found on the product.
 
						

							
Agency Regulatory Notices
C–2User’s Guide
Materials Disposal
This HP product contains mercury in the fluorescent lamp in the display LCD that might require special handling at 
end-of-life:
Disposal of this material can be regulated because of  environmental considerations. For disposal or recycling 
information, contact your local authorities or the Elec tronic Industries Alliance (EIA) (http://www.eiae.org).
Canadian Notice
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
Av i s  C a n a d i e n
Cet appareil numérique de la classe B respecte toutes le s exigences du Règlement sur le matériel brouilleur du 
Canada.
European Union Regulatory Notice
This product complies with  the following EU Directives:
■ Low Voltage Directive 2006/95/EC
■ EMC Directive 2004/108/EC
Compliance with these directives implies conformity to  applicable harmonized European standards (European 
Norms) which are listed on the EU Declaration of Conformi ty issued by Hewlett-Packard for this product or product 
family.
This compliance is indicated by one of the foll owing conformity markings placed on the product:
Hewlett-Packard GmbH, HQ-TRE, Herrenberg er Straße 140, 71034 Böblingen, Germany 
Disposal of Waste Equipment by Users in Private Households in 
the European Union
This symbol on the product or on its packaging indi cates that this product must not be disposed of 
with your other household waste. Instead, it is  your responsibility to dispose of your waste 
equipment by handing it over to a designated colle ction point for the recycling of waste electrical 
and electronic equipment. The separate collectio n and recycling of your waste equipment at the 
time of disposal will help to conserve natural reso urces and ensure that it is recycled in a manner 
that protects human health and the environment.  For more information about where you can drop 
off your waste equipment for recycling, please cont act your local city office, your household waste 
disposal service or the shop where you purchased the product.
 
XXXX *
This marking is valid for 
non-Telecom products and 
for EU harmonized Telecom 
products (for example, 
Bluetooth). This marking is valid for EU 
non-harmonized Telecom 
products.
*Notified body number (used 
only if applicable—refer to the 
product label).
 
						

							
Agency Regulatory Notices
User’s GuideC–3
Japanese Notice
Japanese Power Cord Notice
Japanese Material Content Declaration
A Japanese regulatory requirement, defined by Specification JIS-C-0950, 2005, mandates that manufacturers 
provide Material Content Declarations for certain catego ries of electronic products offered for sale after 
July 1, 2006. To view the JIS-C-0950 material declarat ion for this product, visit www.hp.com/go/jisc0950.
Korean Notice
EPA ENERGY STAR
® Compliance
Products marked with the ENERGY STAR® logo on the packaging box qualify with the 
U.S. Environmental Protection Agency’s ENERGY STAR
® guidelines for energy efficiency.
Products with the ENERGY STAR
® label are designed to use less energy, help you save money on 
utility bills, and help  protect the environment.
ENERGY STAR
® is a registered trademark owned by the U.S. government.
HP Recycling Program
HP offers product end-of-life return programs for HP and  other manufacturers’ hardware in several geographic areas.
The terms and availability of these programs vary by geog raphy because of differences in regulatory requirements 
and local customer demand. For information on the HP  recycling program, refer to the HP Web site at: 
http://www.hp.com/recycle
 
						

							
Agency Regulatory Notices
C–4User’s Guide
Part number: 440143-005
The Table of Toxic and Hazardous Substances/Elements and their Content 
as required by China’s 
Management Methods for Controlling Pollution by Electronic Information P\
roducts 
Toxic and Hazardous Substances and Elements
Part Name Lead
(Pb)
Mercury
(Hg)
Cadmium
(Cd)
Hexavalent
Chromium
(Cr(VI))
Polybrominated
biphenyls (PBB) 
Polybrominated
diphenyl ethers 
(PBDE)
Liquid Crystal Display 
Panel X X  O  O  O  O 
Chassis/OtherXOOOOO
O: Indicates that this toxic or hazardous substance contained in all of \
the homogeneous materials for this part is below 
the limit requirement in SJ/T
11363-2006 .
X: Indicates that this toxic or hazardous substance contained in at leas\
t one of the homogeneous materials used for this 
part is above the limit requirement in SJ/T 11363-2006 .
All parts named in this table with an “X” are in compliance with t\
he European Union’s RoHS Legislation – “Directive 
2002/95/EC of the European Parliament and of the Council of 27 January 2\
003 on the restriction of the use of certain 
hazardous substances in electrical and electronic equipment”. 
Note: The referenced Environmental Protection Use Period Marking was det\
ermined according to normal operating use 
conditions of the product such as temperature and humidity. 
\b	
\f

 \b	 
 \f
 
\b	
\f

(Pb)
(Hg)
(Cd) 
(Cr(VI))
 
(PBB)

(PBDE)
 X X O  O  O  O 
\b	
/
XOOOOO
O \f
\
 SJ/T11363 -2006  !#$%&(
X \f
)*+,\
-. SJ/T11363 -2006  !#$%(
  X”\b	
\f
 RoHS!
“ 
 /
 20031 27 0 1 1 23  !  2002/95/EC #$%&
  !# 
$%&()*+),-.