Honeywell Lynxr 2 Instruction Manual

– 41 – 
FIRE ALARM SYSTEM 
FIRE ALARM SYSTEM FIRE ALARM SYSTEM  FIRE ALARM SYSTEM (If Installed) 
    
General Information 
 
UL
ULUL UL 
    LYNXR-2 Series is not intended for UL985 Household Fire applications unless a 24-hour backup 
battery (P/N LYNXRCHKIT-HC) is installed. 
 
General  
Your fire alarm system (if installed) is active 24 hours a day, providing continuous protection. In the 
event of an emergency, the installed smoke and heat detectors will automatically activate your security 
system,...

– 42 – 
FIRE ALARM SYSTEM
FIRE ALARM SYSTEMFIRE ALARM SYSTEM FIRE ALARM SYSTEM 
    
National Fire Protection Association’s 
Smoke Detector Recommendations 
 
UL
ULUL UL 
    LYNXR-2 Series is not intended for UL985 Household Fire applications unless a 24-hour backup 
battery (P/N LYNXRCHKIT-HC) is installed. 
 
With regard to the number and placement of smoke and heat detectors, we subscribe to the 
recommendations contained in the National Fire Protection Associations (NFPA) Standard #72 noted 
below....

– 43 – 
FIRE ALARM SYSTEM 
FIRE ALARM SYSTEM FIRE ALARM SYSTEM  FIRE ALARM SYSTEM  
    
Emergency Evacuation  
UL
ULUL UL 
    LYNXR-2 Series is not intended for UL985 Household Fire applications unless a 24-hour backup 
battery (P/N LYNXRCHKIT-HC) is installed. 
 
Establish and regularly practice a plan of escape in the event of fire. The following steps are 
recommended by the National Fire Protection Association: 
 
 
1.  Position your detector or your interior and/or exterior sounders 
so that they...

– 44 – 
SYSTEM FUNCTIONS
SYSTEM FUNCTIONSSYSTEM FUNCTIONS SYSTEM FUNCTIONS 
    
Security Codes 
General Information 
For additional security you (the Master User Code) can assign secondary user codes to individual users 
enabling them to perform specific system functions. These secondary users are identified by user 
numbers when their codes are assigned. You can assign up to 6 user codes (2-digit user numbers 03-
08). Note that the master user is the only one who can assign codes to secondary users,...

– 45 – 
SYSTEM FUNCTIONS
SYSTEM FUNCTIONSSYSTEM FUNCTIONS SYSTEM FUNCTIONS 
    
Testing the System (to be conducted weekly) 
 
Entering Test Mode 
The TEST key puts your system into the Test mode, which allows each protection point to be checked 
for proper operation. The keypad sounds a single beep every 45 seconds as a reminder that the system 
is in the Test mode.  
 
NOTE:  An alarm message will not be sent to your alarm monitoring company during the following tests. 
 
Disarm the system and close...

– 46 – 
SYSTEM FUNCTIONS
SYSTEM FUNCTIONSSYSTEM FUNCTIONS SYSTEM FUNCTIONS 
    
Trouble Messages 
Typical Trouble Condition Displays 
To silence the beeping sound for fault conditions, press any key.  FAULT  Indicates that a problem exists with the zone(s) displayed, accompanied by rapid beeping. 
First, determine if the zone(s) displayed are intact and make them so if they are not. If 
the zone uses a wireless detector, check that changes in the room (moving furniture, 
televisions, etc.) are not...

– 47 – 
SYSTEM FUNCTIONS
SYSTEM FUNCTIONSSYSTEM FUNCTIONS SYSTEM FUNCTIONS 
    
Maintaining your system 
 
The components of your security system are designed to be as maintenance-free as possible. To make 
sure that your system is in working condition, do the following: 
1.  Test your system weekly. 
2.  Test your system after any alarm occurs (see the TESTING THE SYSTEM section). 
 
Low Battery Conditions in Wireless Sensors 
Each wireless sensor in your system has a 9-volt or 3-volt battery. The...

– 48 – 
SUMMARY 
SUMMARY SUMMARY  SUMMARY O
OO OF AUDIBLE NOTIFICATION
F AUDIBLE NOTIFICATIONF AUDIBLE NOTIFICATION F AUDIBLE NOTIFICATION 
     *UPPER CASE indicates announcements after pressing STATUS once. Lower case indicates announcements after 
pressing STATUS twice. 
SOUND CAUSE  DISPLAY  ANNOUNCEMENT* 
INTERRUPTED 
Speaker and 
external piezo and 
bell FIRE ALARM 
OR  
CARBON MONOXIDE 
ALARM FIRE ALARM is displayed; zone 
number in alarm displayed. 
OR 
ALARM is displayed; zone number in 
alarm...

– 49 – 
SUMMARY 
SUMMARY SUMMARY  SUMMARY O
OO OF AUDIBLE N
F AUDIBLE NF AUDIBLE N F AUDIBLE NOTIFICATION
OTIFICATIONOTIFICATION OTIFICATION 
    
 
Additional Announcements: 
Pressing STATUS key once will announce the following primary messages, depending on 
the system’s status at the time: 
Disarmed–Ready to Arm [check system] 
Disarmed [not ready to arm] 
Armed [away] [stay] [instant] [check system] [exit now] 
 
Pressing the STATUS key twice will announce the following secondary messages, depending...

– 50 – 
  
FCC STATEMENT 
THIS DEVICE COMPLIES WITH PART 15 OF FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING 
TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS 
DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY 
CAUSE UNDESIRED OPERATION.  
Federal Communications Commission (FCC) Part 15 Statement 
This equipment has been tested to FCC requirements and has been found acceptable for use. The FCC 
requires the following statement for your...