Honeywell Galaxy 3144 User Guide

							33
ZONE REFERENCE TABLES
e n o Zno i t c n u Fno i t p i r c s e Dem i h Cti m Otr a P
1 0 0 1
2 0 0 1
3 0 0 1
4 0 0 1
5 0 0 1
6 0 0 1
7 0 0 1
8 0 0 1
1 1 0 1
2 1 0 1
3 1 0 1
4 1 0 1
5 1 0 1
6 1 0 1
7 1 0 1
8 1 0 1
O I Ren o Zno i t c n u Fno i t p i r c s e Dem i h Cti m Otr a P
1
2
3
4
5
6
7
8
O I Ren o Zno i t c n u Fno i t p i r c s e Dem i h Cti m Otr a P
1
2
3
4
5
6
7
8 
						

							34
ALARM AND HELP MESSAGES
Alarm In Progress
The system is currently in alarm condition and must be cancelled by a valid PIN or
keyswitch operation.
Pa Reset Required
After a PA (Personal Attack) zone has been activated, the system has to be reset by a
high level code (such as a manager or engineer depending on the reset level setting).
Manager Reset Required
Following an alarm activation, the system requires to be reset by a manager level
code.
 This message is displayed when a tamper alarm occurs.
Engineer Reset Required
The system has been programmed for engineer reset following an alarm activation.
The engineer must be called to reset the system before the user can set the
alarm.Tamper alarms usually require an engineer to visit the site to check all
modules on the system.
Alarm Cause Code
Following an alarm activation, the system requires to be reset by user entry of an
appropriate alarm cause code.
No Entries
This message appears if a user attempts to view or inspect the log and there is
nothing in the log to be viewed or when the omit option is selected and there are no
omittable zones on the system.
Invalid Selection
The option selected or value entered is illegal or out of range.
Invalid Code
The code entered is not a valid code registered in the system memory.
Option Not Available
This option is provided by the engineer, where it is specifically required. Attempting to
select an option when it has not been provided results in the display of
Technistore Reset
Call the Alarm Monitoring Station and quote the five digit number displayed. Enter the
number quoted by the monitoring station to reset the system.
No Modules Added
When exiting Engineer Mode the panel does not detect the change in the number of
modules. Press esc to continue.NO MODULE ADDED
ESC TO CONTINUE
ALARM IN
PROGRESS
PA
RESET REQUIRED 
CALL MANAGER
RESET REQUIRED
CALL ENGINEER
RESET REQUIRED
NO ENTRIES
INVALID
OPTION
CALL ALARM CO.
QUOTE CODE XXXXX
ALARM CAUSE CODE
>
OPTION NOT 
AVAILABLE
INVALID CODE 
						

							35
INSTALLER DETAILS
Name: -----------------------------------------------------------------------------------
Address: ---------------------------------------------------------------------------------
-------------------------------------------------------------------------------------------
-------------------------------------------------------------------------------------------
-------------------------------------------------------------------------------------------
Telephone: ------------------------------------------------------------------------------
Office Hours:---------------------------------------------------------------------------
Other Times:---------------------------------------------------------------------------
Account No.: ---------------------------------------------------------------------------
APPENDIX 1 - NOTE FOR SWEDISH MARKET
Resetting Using Alarm Cause Code
This option is not normally used but, if enabled by the engineer, when a reset is required, the
user must enter an alarm cause code to reset the system.
If there are multiple alarm causes and/or multiple groups require to be reset, then the alarm
cause code only has to be entered once. The user enters the most appropriate code as deter-
mined on site. The cause code value should be determined in conjunction with the Alarm
Receiving Centre (ARC). 
						

							36
IU1-0033  Rev 2.0© Copyright Honeywell Security