Honeywell control panel VISTA128BPVISTA250BP VISTA128SIA User Manual

 
 
– 71 – 
Quick Guide to System Functions 
FUNCTION PROCEDURE COMMENTS 
Check Zones  Press [✱].  To view faulted zones when is system not ready 
Display All 
Descriptors Press and hold [✱] for 5 seconds.  Displays all alpha descriptors programmed by 
installer. 
Arm System  Enter code. 
Press arming key desired (AWAY, 
STAY, INSTANT, MAXIMUM). Arms system in mode selected. 
NOTE: After pressing the STAY or INSTANT 
arming key, enter 1, 2 or 3 to arm in 
the desired STAY or INSTANT mode. 
Disarm System...

 
 
– 72 – 
Quick Guide to System Functions (cont’d) 
FUNCTION PROCEDURE COMMENTS 
Delete a User  Enter master/manager code. 
Press CODE [8]. 
Enter user no. to be deleted. 
Enter master/manager code. 
Press 1 (Yes) at prompt. Master & Manager level users can delete users. 
A user can only be deleted by a user with higher 
authority level. 
Real-Time Clock 
 Enter Master code.  Press [#] + [63] 
 Press [✳] or [#] to move cursor. Enter time and 
date accordingly. Press any key (0-9) for 
AM/PM. 
Enter...

 
 
– 73 – 
Summary of Audible Notification 
(Alpha Display Keypads) 
SOUND CAUSE  DISPLAY 
LOUD, 
INTERRUPTED* 
 Keypad & External FIRE ALARM FIRE is displayed; descriptor of zone in alarm is 
displayed. 
LOUD, 
CONTINUOUS* 
 Keypad & External BURGLARY/AUDIBLE EMERGENCY 
ALARM  AL ARM is displayed; descriptor of zone in alarm is 
also displayed. 
ONE SHORT BEEP 
 (not repeated) 
Keypad only a. SYSTEM DISARM   
b.  SYSTEM ARMING ATTEMPT 
WITH AN OPEN ZONE. 
c.  BYPASS VERIFY  a. DISARMED/READY TO ARM is...

 
 
– 74 – 
FEDERAL COMMUNICATIONS COMMISSION STATEMENTS 
The user shall not make any changes or modifications to the equipment unless authorized by the Installation 
Instructions or Users Manual. Unauthorized changes or modifications could void the users authority to 
operate the equipment.  FCC CLASS B STATEMENT 
This equipment has been tested to FCC requirements and has been found acceptable for use. The FCC 
requires the following statement for your information:  This equipment generates and uses...

 
 
– 75 – 
 
 “FEDERAL COMMUNICATIONS COMMISSION (FCC) Part 68 NOTICE 
This equipment complies with Part 68 of the FCC rules. On the front cover of this equipment is a 
label that contains, among other information, the FCC registration number and ringer equivalence 
number (REN) for this equipment. If requested, this information must be provided to the 
telephone company. 
This equipment uses the following jacks: 
  An RJ31X is used to connect this equipment to the telephone network. 
The REN is used to...

 
 
– 76 – CANADIAN DEPARTMENT OF COMMUNICATIONS  
(DOC) STATEMENT 
 
NOTICE 
The Canadian Department of Communications label identifies certified equipment. This certification means that the equipment meets certain telecommunications network protective, operational and safety requirements. The Department does not guarantee the equipment will operate to the user’s satisfaction. 
Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local...

 
 
– 77 – 
WARNING!   
THE LIMITATIONS OF THIS ALARM SYSTEM While this system is an advanced design security system, it does not offer guaranteed protection against burglary or fire or other emergency. Any alarm system, whether commercial or residential, is subject to compromise or failure to warn for a variety of reasons. For example:   Intruders may gain access through unprotected openings or have the technical sophistication to bypass an alarm sensor or disconnect an alarm warning device. ...

 
 
– 78 – 
Index 
#70 command ............................................... 50 
4286 VIP module ..................................... 9, 50 
AC Loss ........................................................ 65 
Access Another Partition....................... 22 
Access Control Commands .......................... 58 
Access Door .................................................. 49 
Action Code
............................................... 57 
Action Specifier
...........................................

 
 
– 79 – 
Manager ....................................................... 16 
Master .......................................................... 16 
Master Keypad......................................... 9, 23 
Maximum ................................................. 7, 22 
MAXIMUM .................................................. 14 
MAXIMUM mode......................................... 40 
Memory of Alarm.................................. 8, 42 
Messages...

 
 
ÊK5895V5*Š 
K5895V5 4/09 Rev C  
 TWO YEAR LIMITED WARRANTY  Honeywell International Inc., acting through its Security & Communications business (“Seller”), 2 Corporate Center Drive, Melville, New York 11747 warrants its products to be free from defects in materials and workmanship under normal use and service, normal wear and tear excepted, for 24 months from the manufacture date code; provided, however, that in the event the Buyer presents a proper invoice relating to the purchased product and such...