honda nc700 x xa xd owners 2012 User Manual

18
Operation Guide
Operation Guide
Parts Location
(NC700X/XA)
Rear brake fluid reservoir (P79)
Lower cowl (P67)
Front brake fluid reservoir 
(P79)
Throttle grip (P90)
Engine oil fill cap/dipstick 
(P71)
Engine oil drain bolt (P73)
Engine oil filter (P73)
Coolant reserve tank (P77)
Battery (P70)
Main fuse (P117)
Front brake lever
Rear brake pedal
12 NC700X Revision-42MGS6010.book  18 ページ  ２０１１年１２月１３日　火曜日　午後４時１４分  

19continued
Operation Guide
Shift lever (P37)
Side stand (P82)
Fuel fill cap (P44)
Clutch lever (P87)
Rear Seat (P43)
Drive chain (P83)
Maintenance lid (P66)
Luggage box (P45)
Fuse box (P115)
Crankcase breather (P91)
Windscreen (P93)
12 NC700X Revision-42MGS6010.book  19 ページ  ２０１１年１２月１３日　火曜日　午後４時１４分  

20
Parts Location (Continued)
Operation Guide
(NC700XD)
Rear brake fluid reservoir (P79)
Lower cowl (P67)
Front brake fluid reservoir 
(P79)
Throttle grip (P90)
Engine oil fill cap/dipstick (P71)
Engine oil drain bolt (P73)
Engine oil filter (P73)
Coolant reserve tank (P77)
Battery (P70)
Main fuse (P117)
Front brake lever
Rear brake pedal Clutch oil filter 
(P75)
12 NC700X Revision-42MGS6010.book  20 ページ  ２０１１年１２月１３日　火曜日　午後４時１４分  

21
Operation Guide
Side stand (P82)
Fuel fill cap (P44)
Parking brake lever 
(P81)
Rear Seat (P43)
Drive chain (P83)
Maintenance lid (P66)
Luggage box (P45)
Fuse box (P115)
Crankcase breather (P91)
Windscreen (P93)
12 NC700X Revision-42MGS6010.book  21 ページ  ２０１１年１２月１３日　火曜日　午後４時１４分  

22
Operation Guide
Instruments
Display Check
When the ignition switch is turned on, all the mode and digital segments 
will show, and the tachometer segm ent progress to maximum scale and 
then disappear.
If any part of these displays does not come on when it should, have your 
dealer check for problems. B button
A button
12 NC700X Revision-42MGS6010.book  22 ページ  ２０１１年１２月１３日　火曜日　午後４時１４分  

23continued
Operation Guide
Odometer [TOTAL] & Tripmeter 
[TRIP A/B]
A button switches between 
odometer & tripmeters at the 
ordinary display.
• Odometer: Total distance ridden.
• Tripmeter: Distance ridden since tripmeter was reset (press and 
hold B button to reset to 0.0 km/
mile). Tachometer
NOTICE
Do not operate the engine in the tachometer 
red zone. Excessive engine speed can 
adversely affect engine life.
Clock (12-hour display)
To set the clock: 
(P27)
Fuel gauge
Remaining fuel when only 
1st...

24
Instruments (Continued)
Operation GuideClock (12-hour display)
To set the clock: 
(P27)
(NC700XD)Odometer [TOTAL] & Tripmeter 
[TRIP A/B]
A button switches between 
odometer & tripmeters at the 
ordinary display.
• Odometer: Total distance ridden.
• Tripmeter: Distance ridden since  tripmeter was reset (press and 
hold B button to reset to 0.0 km/
mile). Tachometer
NOTICE
Do not operate the engine in the tachometer 
red zone. Excessive engine speed can 
adversely affect engine life.
Fuel gauge...

25continued
Operation Guide
D indicator
Comes on when the D mode is selected in the AT MODE. 
(P41)
S indicator
Comes on when the S mode is selected in the AT MODE. 
(P41)
Gear position indicator
The gear position is shown in the gear position  indicator when the D, S mode or MT MODE 
are selected.
u “-” appears for a few seconds and then goes off when the engine starts.
u “-” flashes when the engine stop switch position is changed from Run   to Off   position 
with the ignition switch on.
u “-” flashes...

26
Instruments (Continued)
Operation Guide
Display Setting
You can adjust the three settings.
• Backlight brightness adjustment
• Clock setting
• (E, III E type only) Changing of speed and 
mileage unit In addition, to move the ordinary display at 
display setting.
• The button is not pressed for about 30 
seconds
• Turn the ignition switch off and then on
Each setting will be cancelled if the A button 
is not pressed.
1 Backlight brightness adjustment:
You can adjust the brightness three levels.
! a...

27
Operation Guide
2 To set the clock:
!a After backlight brightness adjustment, the 
hour digits start flashing.
! b Press B button until the desired hour and 
AM/PM are displayed.
uPress and hold to advance the hour fast.
! c Press A button. The minute digits start 
flashing.
! d Press B button until the desired minute is 
displayed.
uPress and hold to advance the minute 
fast.
!e
Press A button. The clock is set, and then 
the display returns  to the backlight 
brightness adjustment.
Press A button....