Hitachi Cp-X2011 Projector Users Manual

7
ENGLISH
  Y CB/PB   CR/PRCOMPONENT VIDEO OUTL R
AUDIO OUTVIDEO OUTL R
AUDIO OUT
AUDIO OUTRGB OUTAUDIO OUTRGB OUTRS-232CRGB IN
L R
AUDIO OUTS-VIDEO OUT
USB
L R
AUDIO IN
Connecting your devices
WRWKHSURMHFWRU
Make sure that all the devices are suitable to be connected with this product, and 
prepare the cables required to connect. Please refer to the following illustrations 
to connect them. To input component video signal to COMPUTER IN1/2 port, 
SOHDVHVHHWKH³2SHUDWLQJ*XLGH´LQWKH&
VCR/DVD...

8
Connecting power supply
1.Put the connector of the power cord into the 
AC IN (AC inlet) of the projector.
2.)LUPO\SOXJWKHSRZHUFRUG

9
ENGLISH
Adjusting the projector's elevator
When the place to put the projector is slightly uneven to 
the left or right, use the elevator feet to place the projector 
horizontally. 
Using the feet can also tilt the projector in order to project at a suitable angle to 
the screen, elevating the front side of the projector within 14 degrees.
This projector has 2 elevator feet and 2 elevator buttons. An elevator foot is 
adjustable while pushing the elevator button on the same side as it.
1.Holding...

10
Displaying the picture
1.Activate your signal source. Turn the signal 
source on, and make it send the signal to 
the projector.
2.Use the VOLUME + /VOLUME - buttons 
to adjust the volume. 
To have the projector silent, press the MUTE
button on the remote control.
3.Press the INPUT button on the projector. 
Each time you press the button, the 
projector switches its input port in turn.
You can also use the remote control to 
select an input signal. Press the VIDEO
button for selecting an input signal...

11
ENGLISH
Turning off  the power
1.Press the STANDBY/ON button on the 
projector or the remote control.
The message “Power off?” will appear on 
the screen for about 5 seconds.
2.Press the STANDBY/ON button again 
while the message appears.
The projector lamp will go off, and the 
POWER indicator will begin blinking in 
orange. Then the POWER indicator will 
stop blinking and light in steady orange 
when the lamp cooling is complete.
3.Attach the lens cover, after the POWER
indicator turns in steady...

12
Replacing the lamp
$RIWLPHFRXOGFDXVH
the pictures darker or the color tone poor. Note that each lamp has a different 
lifetime, and some may burst or burn out soon after you start using them.
Preparation of a new lamp and early replacement are recommended. To prepare 
a new lamp, make contact with your dealer and tell the lamp type number.
Type number : DT01021
1.Turn the projector off, and unplug the power cord. 
Allow the projector to cool for at least 45 minutes.
2.Prepare a new lamp. If the...

13
ENGLISH
 HIGH VOLTAGE HIGH TEMPERATURE HIGH PRESSURE
WARNING
yThe projector uses a high-pressure mercury glass lamp. The lamp 
can break with a loud bang, or burn out, if jolted or scratched, handled while hot, or 
worn over time. Note that each lamp has a different lifetime, and some may burst or 
burn out soon after you start using them. In addition, if the bulb bursts, it is possible 
IRU VKDUGV RI JODVV WR 

14 3OHDVHFKHFNDQGFOHDQWKHDLU

15
ENGLISH
Using the CD manual
G&520WLWOHG

16
6SHFL