Haier Hdy60m 6kg Manual

WALL  MOUNTING INSTRUCTIONS
1. Determine the location of the dr yer on the wall and mark the 
    bracket position. A minimum 50 mm is needed be tween the top of the dryer and
   the celling for ease of installation;
   If mounting above a washing ma chine, allow sufficient room to
   open the lid of the washe r.
9
Tools required:
For plaster/          Drill&3mm Bit                        1
Wooden wall       Philips head screwdriver       1 
Wall mounting kit includes 

Plastic Spacers...

WALL MOUNTING INSTRUCTIONS
3. Install the hooks to the dryer, in the inverted position, remove 
    the 2 screws and 2 plastic plugs as indicated in Fig.1 .
4. Align the hooks as shown in Fig.2 and refit screws tightly.
    Install the spacers provided as Fig.2. 
10
plastic plugs
2 hooks
3 screws
2 spacers 

WALL  MOUNTING INSTRUCTIONS
5. W ith assistance, mount dryer on  wall bracket s. See Fig. 3
6.  Asecond control panel with inverted symbols is supplied.
Peel the release paper from the back of inverted film then 
place new control panel film on t he surface so that the writing is the 
    correct way around.
1 1
Caution:
     Plug must be accessble after installation.
Start
HDY -M 60OFF
20 min
60 min
100 min
150 min
200 min
OFF 60 min
30 min
Cool
Warm
HDY -M60
StartCool
Warm
OFF
20 min
60 min
100 min
150...

DRYING RACK FITTING INSTRUCTION
DRYER FREE ST ANDING-UPRIGHT
For ease of access, the rack is to be mounted near the dryer top. Firstl\
 y hold the rack 
horizontally with the two end projections point ing upwards and away from yourself. 
Position the rack near the top of the dryer 
and place the end of the right rack projection 
into the right cabinet mounting hole (Fig.1).
Then gently pull on the left rack projection un til
it fits around the cabinet and springs into the
left cabinet mounting hole.
The...

RACK FITTING INSTRUCTION
RACK STORAGE - DR YER INVERTED.
To hold the dryer rack out of the way
when not in use, it will be necessary to
attach the retaining clip to the base of 
your dryer .
T o do this, firstly remove the screw located
4 cm from the right corner of the inverted
dryer ( Fig.3).
Then position the retaining clip over the hole
 so that the prong on the clip is near the
cabinet corner and faces outwards (Fig.4).
LOADING DR YER RACK
To make use of the drying rack, firstly rotate
the outlet...

14
The following must be confirmed before calling for service:
Problem                           Possible Cause
The dryer does not start
The drying result is not 
good-Is the dryer plugged in?
-Is the power on?
-Is the door closed properly?
-Has a drying program been set?
-Was the correct drying program set?
-Is the filter screen clean?
-Did the amount of the loaded laundry exceed the rated load?
-Was the loaded laundry spun dry before being  loaded into the dryer?
-Did the laundry become twisted during...