Haier Gdz51 Manual

English•Dryer must be exhausted outside (outdoors, not beneath the mobile
home) using metal ducting that will not support combustion. 
Metal ducting must be 4 inches (10.16 cm) in diameter with 
no obstructions. Rigid metal duct is preferred.
•If dryer is exhausted through the floor and  area beneath the
mobile home is enclosed, the exhaust system must terminate 
outside the enclosure with the termination securely fastened to the
mobile home structure.
• Refer to previous pages for other important...

21English
1. This appliance must be properly grounded. Electrical shock can result if the 
dryer is not properly grounded. Follow the instructions in this manual 
for proper grounding.
2. Do not use an extension cord with this dryer. Some extension cords are not
designed to withstand the amounts of electrical current this dryer utilizes and 
can melt, creating electric shock and/or fire hazard. Locate the dryer within
reach of the receptacle for the length power cord to be purchased, 
allowing some slack...

English1. Remove the screws securing the terminal block access cover 
and the strain relief mounting bracket located on the back of the 
dryer upper corner.
2. Install a U.L. approved strain relief into the power cord entry hole 
of the mounting bracket. Finger tighten the nut only at this time.
3. Thread a U.L. Approved 30 Amp. Power cord, NEMA 10-30 Type
SRDT, through the strain relief.
4. Attach the power cord neutral (center wire) conductor to the silver 
colored center terminal on the terminal...

23English
4-Wire Cord Connections1. Remove the screws securing the terminal block access cover 
and the strain relief mounting bracket located on the back 
of the dryer upper corner.
2. Install a U.L. approved strain relief into the power cord entry hole 
of the mounting bracket. Finger tighten the nut only at this time.
3. Remove the green neutral ground wire from the green ground 
screw located above the terminal block.green 
ground 
screw
green neutral
ground wiregreen power cord
ground wiresilver...

English4.   Thread a U.L. approved 30 Amp power cord, NEMA 14-30 type ST 
or SRDT through the strain relief.
5. Attach the green power cord ground wire to the cabinet with 
green ground screw.
6. Attach the white (neutral) power cord conductor from the power 
cord and the green ground wire from the dryer harness to the 
silver-colored center terminal on the terminal block. Tighten the 
screw securely.
7.   Attach the red and black power cord conductors to the outer 
brass-colored terminals on the...

25EnglishLimited Warranty
Full ONE Year In-Home Warranty
For 12 months from the date of original retail
purchase, Haier will repair or replace any
part free of charge including labor that fails
due to a defect in materials or workmanship.
Limited Warranty
After one year from the original retail pur-
chase date, Haier will provide a part at no
cost, as indicated below, to replace said part
as a result of a defect in materials or work-
manship. Haier is responsible solely for the
cost of the part. All...

gdz5-1-02
Issued: July-01IMPORTANT
Do Not Return This Product To The Store
If you have a problem with this product, please contact the Haier Customer
Satisfaction Center at 1-877-337-3639.
DATED PROOF OF PURCHASE REQUIRED FOR WARRANTY SERVICE
IMPORTANT
Ne pas Réexpédier ce Produit au Magasin
Pour tout problème concernant ce produit, veuillez contacter le service des 
consommateurs ‘Haier Customer Satisfaction Center’ au 1-877-337-3639.
UNE PREUVE D’ACHAT DATEE EST REQUISE POUR BENEFICIER DE LA GARANTIE....