Global Garden Products Lawn Mower XM140HD XM160HD Instructions Manual

82 11 -00 84 -80
XM140HD XM160HD
INSTRUCTIONS FOR USE
MODE D’EMPLOI
SAFETY REGULATIONS SAFETY RULES ANSI
CONSIGNES DE SECURITE RÈGLES DE SÉCURITÉ A N SI EN ... 5
FR .. 12
EN... 19
EN... 23
FR.... 25
FR.... 29 

2
A
B
S
I
F
G
I
H
G
D, E
C
MON
P 
1
3
52
4
6 

3
U
T QR
0
1
7
9
118
10
12 

4
K 
L
13
15
1714
16
18 

5
ENGLISHEN
1 GENERAL
This symbol indicates WARNING. 
Personal injury and/or damage to 
property may result if the instructions 
are not followed carefully.
You must read these instructions for use 
and the accompanying pamphlet 
“SAFETY INSTRUCTIONS” 
carefully, before starting up the 
machine.
1.1 SYMBOLS
The following symbols appear on the machine. 
They are there to remind you of the care and 
attention required in use.
This is what the symbols mean:
Warning!
Read the instruction manual and the...

6
ENGLISHEN
2.4 Seat
Release the catch (2:S) and fold up the seat brack-
et.
Install the mounting in the rear (upper) holes as 
follows:
1. Install the shoulder washers (2:F) on the screws 
(2:G).
2. Insert the screws through the slots in the brack-
et. Place a washer (2:I) between the seat and the 
bracket.
3. Tighten the screws in the seat. Tightening 
torque: 9±1.7 Nm.
If the screws are tightened more than 
9±1.7 Nm, the seat will be damaged.
4. Check that the seat moves easily in the slots in 
the...

7
ENGLISHEN
3.3 Clutch-parking brake (6:M)
(HD)
The pedal (6:M) has the follow-
ing three positions:
•Released. The clutch is not activated. The park-
ing brake is not activated.
•Depressed halfway. Forward drive disengaged. 
The parking brake is not activated.
•Fully depressed. Forward drive disengaged. 
The parking brake is fully activated but not 
locked. This position is also used as emergency 
brake.
3.4 Inhibitor, parking brake (6:N)
The inhibitor locks the (6:M) pedal in the 
depressed position....

8
ENGLISHEN
3.9 POWER TAKE-OFF (7:Q)
A lever for engaging and disengaging the power 
take-off for operating the cutting deck. Two 
positions:
1.Forward position – power take-off 
disengaged.
2. Backward position – power take-off 
engaged.
3.10 CLUTCH RELEASE LEVER 
(fig. 8) (HD)
A lever for disengaging the variable transmission. 
Enables the machine to be moved by hand without 
the help of the engine. 
The disengagement lever must never be 
between the outer and inner positions. 
This overheats and...

9
ENGLISHEN
With the engine running and the driver sitting on 
the seat, check as follows: 
- select a gear, lift your weight off the seat – the 
engine must stop (only Man). 
- press the drive pedal so that the machine starts 
to move, release the drive pedal – the machine 
should stop (only HD). 
- engage the power take-off, lift your weight off 
the seat – the engine should stop. 
Do not use the machine if the safety 
system is not working! Take the 
machine to a service workshop for 
inspection! 
5.5...

10
ENGLISHEN
6.3 CLEANINGTo reduce the risk of fire, keep the 
engine, silencer, battery and fuel tank 
free from grass, leaves and oil.
To reduce the risk of fire, regularly 
check the machine for oil and/or fuel 
leakage. 
When washing the machine with water under high 
pressure, do not point the jet directly at the 
transmission.
Do not point jets of water directly at the engine. 
Use a brush or compressed air in order to clean it.
6.4 ENGINE OIL
Change engine oil the first time after 5 hours of...