GGP Italy SPA Lawn Tractor 71505176 0 102-122 Operators Manual

great care when using for the first few times as engagement may be sudden
until the belt is sufficiently run in.
6.3.6 A
DJUSTMENT OF THE SPRING OF THE PAWL FOR HOOKING THE GRASS-CATCHER
If the grass-catcher tends to jump about and to
open up when going over rough ground, or if it has
difficulty in hooking back on after being emptied,
the tension of the spring will need to be adjust-
ed(1).
Change the hooking point by using one of the
holes (2) until the required result is achieved.  
6.4 DISMANTLING AND...

6.4.2 REPLACING AND REPAIRING TYRES
The tyres are of the «Tubeless» type and therefore all puncture repairs will have
to be carried out by a tyre-repair expert in accordance with the methods for this
kind of tyre.
6.4.3 R
EPLACING BULBS
The bulbs (18W) have a bayonet fitting
and are installed in the bulb holder which
can be taken out by turning it anti-clock-
wise, using pliers.
6.4.4 R
EPLACING A FUSE
The machine is fitted
with fuses (1) with differ-
ent capacities and func-
tions. Specifically:
– 10 A...

on to indicate that the battery is going to run out and the machine will have
problems starting.
In electric tipping models:
– 10A fuse = protects the control motor circuit. If it trips, the tipping system
stops working electrically, so you can empty the grass-catcher using the
manual lever (if fitted).
The fuse capacity is indicated on the fuse.
A blown fuse must always be replaced by one of the same
type and ampere rating, and never with one of another rating.
If you cannot find out why the fuse has...

EN 53 TROUBLESHOOTING
7. TROUBLESHOOTING
PROBLEM LIKELY CAUSE SOLUTION
1.With the key at
«ON» the dashboard
remains off with no
audible signal.
2.With the key at
«ON» the dashboard
remains off, but there
is an audible signal. 
3.With the key on
«START» the dash-
board comes on but
the starter motor does
not runa
4.With the key on
«START» the starter
motor runs but the
engine does not start
5. Starting is difficult
or the engine runs
erratically
6.Weak engine per-
formance during cut-
tingThe protection...

EN 54TROUBLESHOOTING
PROBLEM LIKELY CAUSE SOLUTION
7.Engine stops when
blades are engaged
8.The battery warning
light does not turn off
after a few minutes’
work
9.The oil warning
light comes on while
working ( if fitted)
10.The engine stops
and an audible signal
is heard
11.The engine stops
with no audible warn-
ing
12.The blades warn-
ing light stays lit when
the blades are disen-
gaged
13.The blades do not
engage 
( models with 
lever operated
engagement)
➤
➤
– you are not ready to engage the blades...

EN 55 TROUBLESHOOTING
PROBLEM LIKELY CAUSE SOLUTION
( models with
electromagnetic
clutch)
14.Uneven cut and
poor grass collection
15.Unusual vibrations
while working
16.With the engine
running, the machine
does not move when
the drive pedal is
pressed.( 
for
hydrostatic drive
models)➤
➤– belt loosened
– problems in the electromagnetic clutch 
– cutting deck not parallel to the ground
– blade cutting badly  
– forward speed too high compared to
height of grass (☛5.4.5)
–  collector channel is blocked
–...

EN 56ACCESSORIES ON REQUEST
8. ACCESSORIES ON REQUEST
1. FRONT COUNTERWEIGHTS
These improve stability at the front of the machine,
particularly when being used on ground which is
mostly sloping. 
2. STONE-GUARD KIT
For use in place of the grass-catcher when the cut-
tings are not to be collected.
3. TOWING HITCH
For towing a small trailer.
4. CLOTH COVER
Protects the machine from dust when not in use.
5. CB01 MAINTENANCE BATTERY-CHARGER 
This makes it possible to keep the battery in good
working order...

EN 57 SPECIFICATIONS
9. SPECIFICATIONS
The data in the brackets (.....) refer to the model “122”.
For mechanical drive models:
Forward speed (approximate) at
3000 min.
-1:
in 1st ............................... 2.2 km/h
in 2nd  ............................ 3.8 km/h
in 3rd  .............................. 5.8 km/h
in 4th  .............................. 6.4 km/h
in 5th  .............................. 9.7 km/h
in Reverse ....................... 2.8 km/h
For hydrostatic drive models:
Forward speed  (at 3000...

EN 58ALPHABETICAL INDEX
10. ALPHABETICAL INDEX
Key
Function .................................................... 4.4
Lights
Switch......................................................... 4.6
Replacing bulbs....................................... 6.4.3
Maintenance
How it is to be done ..................... 6.2.1 - 6.2.2
Mowing
Adjusting height ......................................... 4.8
How to cut ............................................... 5.4.5
At the end of mowing .................................