GGP Italy SPA Lawn Tractor 71503773 2 Operators Manual
Here you can view all the pages of manual GGP Italy SPA Lawn Tractor 71503773 2 Operators Manual. The GGP Italy SPA manuals for Lawn and Garden are available online for free. You can easily download all the documents as PDF.
Page 21
EN 20HOW TO USE THE MACHINE – stopping the engine if even just one of the safety requirements is lacking. a)To start the engine it will be necessary that: – the transmission is in “neutral”; – the blades are not engaged; – the operator is seated or the parking brake is engaged. b)The engine stops when: – the operator leaves his seat when the blades are engaged; – the operator leaves his seat when the transmission is not in “neutral”; – the operator leaves his seat with the transmission in “neutral” but...
Page 22
EN 21 HOW TO USE THE MACHINE 5.3 DIRECTIONS BEFORE STARTING THE WORK Before starting work, it is necessary to carry out several checks and operations to ensure that the work gives the best results and is done in maximum safety 5.3.1 S EAT ADJUSTMENT To change the seat position, loosen the four fixing bolts (1) and slide it along the bracket slots. Once you have found the position, tighten the four screws (1). 5.3.2 T YRE PRESSURE Having the correct tyre pressure is the main condition for ensuring that...
Page 23
described in the engine manual, this must be between the MIN and MAX marks on the dipstick. Refuel using a funnel, but do not completely fill the tank. The tanks capacity is about 5.5 litres. Refuelling should be carried out in an open or well venti- lated area with engine stopped. Always remember that petrol fumes are inflammable. DO NOT TAKE A NAKED FLAME TO THE TANK’S OPENING IN ORDER TO SEE THE TANK’S CONTENTS AND DO NOT SMOKE WHEN REFUELLING. Do not drip petrol onto the plastic parts to avoid...
Page 24
EN 23 HOW TO USE THE MACHINE If you would like to mow without using the grass-catcher, an optional stone-guard kit (☛ 8.2) is available. This has to be attached to the rear plate as indicated in the relevant instruc- tions. 5.3.5 C HECKING THE EFFECTIVENESS OF THE SAFETY DEVICES Check that the safety systems are working properly by simulating the various sit- uations of usage shown in the table (☛5.2) and making sure that the correct result is achieved for each situation. 5.3.6 C HECKING THE BRAKING...
Page 25
5.4 USING THE MACHINE 5.4.1 S TARTING All starting operations have to be effected in an open or well ventilated area! ALWAYS REMEMBER THAT EXHAUST GASES ARE TOXIC! To start the engine: – open the fuel stopcock (1) ( if fitted); – put the transmission into neutral («N») (☛4.22 or 4.32); – disengage the blades (☛4.7); – engage the parking brake on sloping ground; – when starting from cold, move the accelerator lever to the «CHOKE» position shown on the label; – if the engine is already warm, just put the...
Page 26
EN 25 HOW TO USE THE MACHINE engine from starting if safety requirements have not been met (☛5.2). In these cases, once the situation has been corrected, the key must first be turned back to «OFF» before the engine can be restarted. 5.4.2 S TARTING AND MOVING WITHOUT MOWING This machine has not been approved for use on public roads. It has to be used (as indicated by the highway code) in private areas closed to traffic. When moving the machine, the blades must be disengaged and the cutting deck put at...
Page 27
EN 26HOW TO USE THE MACHINE Drive must be engaged in the way already described ( ☛4.32) to prevent sudden engagement from causing tipping up and loss of control of the vehicle, particularly on slopes. 5.4.3 B RAKING First, reduce the machine’s speed by reducing the engine’s r.p.m. and then push the brake pedal (☛4.21 or 4.31) to further reduce the speed until the machine stops. For hydrostatic drive models: The machine already slows down considerably by just releasing the drive pedal. 5.4.4 R EVERSE...
Page 28
EN 27 HOW TO USE THE MACHINE – start moving forwards onto the grass area very gradually and with particular caution, as already described; – adjust the forward speed and the cutting height (☛4.8) according to the lawn condition (height, density and dampness of the grass). On flat ground, these general conditions can be followed: High and dense grass - wet lawn 2 km/h Average condition grass 3,5 ... 5,5 km/h Low grass - dry lawn over 5,5 km/h For hydrostatic drive models: The speed is controlled in a...
Page 29
EN 28HOW TO USE THE MACHINE – engage the parking brake on slopes; – pull out the lever (1) and tip up the grass- catcher to empty it; – close up the grass-catcher so that it hooks onto the pawl (2). At times the audible warning may be heard at the moment of engaging the blade even when the grass- catcher has been emptied. This is due to grass-cuttings left on the sensor (3) of the micro-switch. To stop the signal, disengage the blade and then immediately engage it again. Always keep the sensor (3) free...
Page 30
EN 29 HOW TO USE THE MACHINE 5.4.9 END OF WORK Stop the machine, put the accelerator lever in the «SLOW» position and turn off the engine by putting the key into the «OFF» position. When the engine is stopped, close the fuel stopcock (1) ( if fitted). To avoid backfire, put the accelerator in the «SLOW» position for 20 seconds before stopping the engine. Always take out the ignition key if leaving the machine unattended! To keep the battery charged, do not leave the key in the «ON» position when the...