GGP Italy SPA Engine Sv150 71520122/1 Russian Version Manual

71520122/1 Realizzazione: EDIPROM / bergamo
GGP ITALY 
SPA
Via del Lavoro, 6
I-31033 Castelfranco Veneto (TV) ITALY
FR
MANUEL D’UTILISATION
OPERATOR’S MANUAL
GEBRAUCHSANWEISUNG
MANUALE DI ISTRUZIONI
GEBRUIKERSHANDLEIDING
MANUAL DE INSTRUCCIONES
MANUAL DE INSTRUÇÕES
∂°Ã∂πƒπ¢π√ √¢∏°πø¡
KULLANIM KILAVUZUУПАТСТВА ЗА УП\bТРЕБАINSTRUKSJONSBOK
BRUKSANVISNING
BRUGSANVISNING
KÄYTTÖOHJEET
NÁVOD K POUŽITÍ
INSTRUKCJE OBSŁUGI
HASZNÁLATI UTASÍTÁS
êìKéÇéÑëíÇé èé ùKëèãì\
ÄíÄñàà
PRIRUČNIK ZA UPORABO
PRIROČNIK ZA UPORABU...

123
4
6598
10
7
3.1
SLOW
1
CHOKE
F AST
3.2
2
MAX
MIN
15.1.1
1
3a
1
3
5.1.2
1
2
3
5.1.3
12
5.1.4
3
2
1
5.2-3
2
1
3
5.5-6
1
MAXMIN
4
2
3
6.3
123
4
6.4
3
5
1
4
21
3a
6.5
1
0,6-0,8 mm
2
3
11
4
6.6
1
2
3
4
6.7 

1EN
READING AND UNDERSTANDING THE
MANUAL
Some paragraphs in the manual containing infor-
mation of particular importance for safety and
operation are highlighted at various levels of
emphasis, and signify the following:
or   
These give details or further information on
what has already been said, and aim to prevent
damage either to the engine or other damages.
Non-observance will re-
sult in the risk of injury to oneself or others.
Non-observance will re-
sult in the risk of serious injury or death to...

engine is hot;
–if fuel is spilled, do not attempt to start the
engine but move the lawnmower away
from the area of spillage and avoid creating
any source of ignition until the fuel has
evaporated and fuel vapours have dissipat-
ed;
–always put the tank and fuel container caps
back on and tighten well. 
4) Replace faulty silencers and the guard, if
damaged.
C) OPERATION
1) Do not operate the engine in a confined
space where dangerous carbon monoxide
fumes can collect.
2) Do not use starting fluids or...

The engine performance, reliability and life are
influenced by many factors, some external and
some strictly associated with the quality of the
products used and with the scheduled mainte-
nance. 
The following information allow a better under-
standing and use of your engine.
ENVIRONMENTAL CONDITIONS
The operation of a four-stroke endothermic
engine is affected by:
a) Temperature:
–Working in low temperatures could lead to a
difficult cold starting.
–Working in very high temperatures could lead
to a...

BEFORE EVERY USE
Before every use, perform the following checking
procedures in order to assure a regular opera-
tion.
Check oil level
See the specific chapter (8.1) for the oil to be
used. 
a)Place engine level.
b)Clean around oil fill.
c)Remove the fillercap (1), clean the tip of the
dipstick (2), insert and tighten down.
d)Remove dipstick again and check the oil level
that must be between the “MIN” and “MAX”
marks.
e)If oil is required, add oil of the same kind up
to the “MAX” mark, being careful not...

clothing (ties, scarves, etc.) or hair closer to
the top part of the engine.
Do not operate on over 15°
inclines to prevent malfunctioning of the
engine.
STOPPING DURING OPERATION
a)Move throttle control to “SLOW”.
b)Release the safety brake control handle (2) to
stop the engine.
STOPPING AT THE END OF OPERA-
TION
a)Move throttle control (1) to “SLOW”.
b)Release the safety brake control handle (2) to
stop the engine.
c)Once the engine has cooled, disconnect the
spark plug cap (3).
d)Remove any grass...

CHANGE OIL
See the specific chapter (8.1) for the oil to be
used.
Drain oil while the engine
is warm, being careful not to touch the hot
engine nor the drained oil.
a)Place engine level.
b)Clean around oil fill (1).
c)Remove the fillercap (1). 
d)Have a container ready (2) to collect the oil.
e)Tip the lawnmower on its left side so that the
oil will drain from the oil fill (3).
f)Place the lawnmower level and top up with
new oil.
g)Check the oil level on the dipstick (4). Oil
should be at “MAX” mark....

ADJUSTMENT OF THE ACCELERATOR
CABLE
If the engine does not reach its maximum rpm
with the throttle control in “FAST” position, this is
likely due to an out-of-phase connection
between the accelerator lever and the governor
lever. 
To restore the correct phase:
a)Stop the engine, remove the spark plug cap6.7and wait until the engine has cooled.
b)Loosen the screw (1) of the clamp (2) so that
the cable casing (3) is free to move.
c)Move the throttle control to “SLOW”.
d)Move governor control lever (4)...

8EN
REFILLING AND OPERATION MATERIALS
Fuel  .......................................................................................... Unleaded gasoline, minimum 90 octane
Tank capacity  .............................................................................................................................. 0.8 liter
Engine oil:  from 5 to 35 °C ......................................................................................................... SAE 30
from -15 to +5 °C...