Ford Fusion 2 Manual

							PRINCIPLE OF OPERATION
The engine immobiliser is a theft protection
system that prevents someone from
starting the engine with an incorrectly
coded key.
CODED KEYS
Note:
Do not shield your keys with metal
objects. This may prevent the receiver from
recognising your key as a valid one.
Note: Have all of your remaining keys
erased and recoded if you lose a key. Ask
your dealer for further information. Have
replacement keys recoded together with
your existing keys.
If you lose a key, you can obtain a
replacement from your Ford Dealer. If
possible, provide them with the key
number from the tag provided with the
original keys. You can also obtain
additional keys from your Ford Dealer.
ARMING THE ENGINE
IMMOBILISER
The engine immobiliser is armed
automatically a short time after you have
switched the ignition off.
The indicator in the instrument cluster will
flash to confirm that the system is
operating.
DISARMING THE ENGINE
IMMOBILISER
Switching on the ignition disarms the
system if the correct code is recognised.
The indicator illuminates for
approximately three seconds and then
extinguishes
. If the indicator illuminates constantly for
one minute or flashes for approximately
one minute and then repeatedly at irregular
intervals, the system did not recognise the
key code or a system fault is present.
Remove the key and try again.
If the engine does not start, a system
malfunction has occurred. Have the system
checked by an expert immediately.
29
Engine immobiliser 
						

							ARMING THE ALARM
The system is armed as soon as the vehicle
is locked and acts as a deterrent to
unauthorised persons who attempt to
open the doors, bonnet or luggage
compartment, or remove the audio system.
Automatic arming delay
The 20 seconds arming delay begins when
the bonnet, luggage compartment and all
doors are closed and locked.
Alarm
The alarm sounds for 30 seconds if an
unauthorised person opens a door, the
load compartment or the bonnet. The
hazard warning flashers will flash for five
minutes.
Any attempt to start the engine or to
remove the audio system sounds the alarm
again.
DISARMING THE ALARM
Disarm and silence the alarm by unlocking
either of the front doors or luggage
compartment with the key.
30
Alarm 
						

							ADJUSTING THE STEERING
WHEEL
WARNING
Never adjust the steering wheel
when the vehicle is moving.
Note:
Make sure that you are sitting in the
correct position.  See Sitting in the Correct
Position (page 64). WARNING
Make sure that you fully engage the
locking lever when returning it to its
original position.
AUDIO CONTROL
Select radio, CD or cassette mode on the
audio unit.
The following functions can be operated
with the remote control:
Volume
Volume up: Pull the VOL+ switch towards
the steering wheel.
Volume down: Pull the 
VOL− switch
towards the steering wheel.
31
Steering Wheel122E95178                    3E95179    E70361  
						

							Seek
Move the SEEK switch towards the
steering wheel or the instrument panel:
• In 
radio mode, this will locate the next
radio station up or down the frequency
band.
• In 
CD mode, it will select the next or
previous track.
Mode Briefly press the button on the side: •
In 
radio mode, this will locate the next
pre-set radio station.
• In 
CD mode, this will select the next
CD if a CD changer is fitted.
• In 
all modes to abort a traffic message
during broadcasting.
Press and hold the button on the side:
• In 
radio mode, to change the
waveband.
32
Steering WheelE70362 E70363  
						

							WINDSCREEN WIPERS
Single wipe
A
Intermittent wiping or
autowipers
B
Normal wiping
C
High speed wiping
D
Intermittent wiping Select wipe interval with rotary switch: 1 =
Short time interval.
6 = Extended time
interval. Autowipers WARNINGS
In icy conditions, make sure that the
windscreen has been fully defrosted
before selecting autowipers.
Switch off the autowipers feature
before entering a car wash.
Replace the wiper blades as soon as
they begin to leave bands of water
and smears or when they do not
completely remove water from the
windscreen. If the blades are not replaced,
the rain sensor will continue to detect
water on the windscreen. This will result
in the wipers continuing to operate
although the majority of the windscreen is
dry. Note:
The autowipers feature is intended
for use during wet weather conditions only
and is very sensitive to anything which
touches the windscreen near to the rain
sensor. Objects such as dirt, mist or flies
hitting the windscreen in this location may
cause the wipers to wipe even though the
windscreen is mostly dry.
Note: The autowipers feature should not
be selected when it is snowing, foggy or
when the roads have been salted. In these
weather conditions, select an alternative
position if necessary.
When autowipers is selected, the wipers
will cycle once regardless of whether the
windscreen is wet or dry. Thereafter, or
when the ignition is switched on with
autowipers selected, the wipers will not
cycle until water is detected on the
windscreen. Alternatively, move the lever
to another position and then select
autowipers, or operate the washer.
33
Wipers and WashersABCDE72172 E721732  
						

							The rain sensor will continuously measure
the amount of water on the windscreen
and adjust the speed of the front wipers
automatically (single wipe, intermittent,
normal or high speed wiping).
The sensitivity of the rain sensor is set
using the rotary control:
1 = High sensitivity: The wipers will wipe
even if only a small amount of water is
detected on the windscreen.
6
 = Low sensitivity: The wipers will only
wipe when a larger amount of water is
detected on the windscreen.
WINDSCREEN WASHERS WARNING
Do not operate the windscreen
washer for more than 10 seconds or
when the reservoir is empty. REAR WINDOW WIPER AND
WASHERS
Intermittent wiping
Pull the lever towards the steering wheel.
Reverse gear wipe
The rear wiper will be activated
automatically when selecting reverse gear,
if
•
the rear wiper is not already switched
on,
• the wiper lever is in position 
C, or D
• in position 
B and the front wipers are
operating.
The rear wiper will follow the front wiper
interval (at intermittent or normal speed).
34
Wipers and WashersE721732 E72174 E72175  
						

							Washer
WARNING
Do not operate the washer for more
than 10 seconds at a time, and never
when the reservoir is empty.
Pull the lever fully towards the steering
wheel and hold it to operate the washer.
The washer will operate in conjunction with
the wipers.
The washer jet for the rear window is
located on the roof above the rear window. CHECKING THE WIPER
BLADES Run the tip of your fingers over the edge of
the blade to check for roughness.
Clean the wiper blade lips with water
applied with a soft sponge.
CHANGING THE WIPER
BLADES
35
Wipers and WashersE72176 E66644 E6664552431                  
						

							Lift the wiper arm and position the wiper
blade at a right angle to the wiper arm. To
remove, press the retaining clip in the
direction of the arrow, disengage the wiper
blade and pull it off the arm in the opposite
direction.
36
Wipers and Washers 
						

							LIGHTING CONTROL
Lighting control positions
OffA
Side and tail lamps
B
Headlamps
C
Autolamps Note:
If you have switched autolamps on,
you can only switch the main beam on when
autolamps has switched the headlamps on. The headlamps will come on and go off
automatically depending on the ambient
light.
Home safe lighting
You can switch home safe lighting on up
to 10 minutes after you have switched the
ignition off.
Vehicles without autolamps
Switch the headlamps on and then switch
them off within two seconds.
Vehicles with autolamps
a.
Switch autolamps on and then switch
them off within two seconds.
b. Switch autolamps off and then switch
them 
on within two seconds.
Welcome lighting
The side and tail lamps will come on when
you unlock the doors with the remote
control. They will switch off automatically
after a short time.
Main/dipped beam Pull the lever fully towards the steering
wheel to switch between main and dipped
beam.
37
LightingABCE72161 E72162 E72168  
						

							Headlamp flasher
Pull the lever slightly towards the steering
wheel.
FRONT FOG LAMPS
Note:
It is not possible to switch on the
front fog lamps when the lighting switch is
set to AUTO. To switch on the front fog
lamps, switch off the autolamps feature.
Switch on the headlamps 1 and pull out
the control switch one position 2.
The front fog lamps should be used only
when visibility is considerably restricted by
fog, snow or rain. REAR FOG LAMPS
WARNING
The rear fog lamps may only be used
when visibility is restricted to less
than 50 m and must not be used
when it is raining or snowing. Note:
On vehicles not equipped with front
fog lamps the control switch can be pulled
out only one position.
Note: It is not possible to switch on the rear
fog lamps when the lighting switch is set to
AUTO. To switch on the rear fog lamps,
switch off the autolamps feature.
Switch on the exterior lamps 1 and pull out
the control two positions 
2.
38
LightingE72168 E72163 12E72164