Ford Fusion 2 Manual

PRINCIPLE OF OPERATION
The engine immobiliser is a theft protection
system that prevents someone from
starting the engine with an incorrectly
coded key.
CODED KEYS
Note:
Do not shield your keys with metal
objects. This may prevent the receiver from
recognising your key as a valid one.
Note: Have all of your remaining keys
erased and recoded if you lose a key. Ask
your dealer for further information. Have
replacement keys recoded together with
your existing keys.
If you lose a key, you can obtain a...

ARMING THE ALARM
The system is armed as soon as the vehicle
is locked and acts as a deterrent to
unauthorised persons who attempt to
open the doors, bonnet or luggage
compartment, or remove the audio system.
Automatic arming delay
The 20 seconds arming delay begins when
the bonnet, luggage compartment and all
doors are closed and locked.
Alarm
The alarm sounds for 30 seconds if an
unauthorised person opens a door, the
load compartment or the bonnet. The
hazard warning flashers will flash for five...

ADJUSTING THE STEERING
WHEEL
WARNING
Never adjust the steering wheel
when the vehicle is moving.
Note:
Make sure that you are sitting in the
correct position.  See Sitting in the Correct
Position (page 64). WARNING
Make sure that you fully engage the
locking lever when returning it to its
original position.
AUDIO CONTROL
Select radio, CD or cassette mode on the
audio unit.
The following functions can be operated
with the remote control:
Volume
Volume up: Pull the VOL+ switch towards
the steering wheel....

Seek
Move the SEEK switch towards the
steering wheel or the instrument panel:
• In 
radio mode, this will locate the next
radio station up or down the frequency
band.
• In 
CD mode, it will select the next or
previous track.
Mode Briefly press the button on the side: •
In 
radio mode, this will locate the next
pre-set radio station.
• In 
CD mode, this will select the next
CD if a CD changer is fitted.
• In 
all modes to abort a traffic message
during broadcasting.
Press and hold the button on the side:...

WINDSCREEN WIPERS
Single wipe
A
Intermittent wiping or
autowipers
B
Normal wiping
C
High speed wiping
D
Intermittent wiping Select wipe interval with rotary switch: 1 =
Short time interval.
6 = Extended time
interval. Autowipers WARNINGS
In icy conditions, make sure that the
windscreen has been fully defrosted
before selecting autowipers.
Switch off the autowipers feature
before entering a car wash.
Replace the wiper blades as soon as
they begin to leave bands of water
and smears or when they do not...

The rain sensor will continuously measure
the amount of water on the windscreen
and adjust the speed of the front wipers
automatically (single wipe, intermittent,
normal or high speed wiping).
The sensitivity of the rain sensor is set
using the rotary control:
1 = High sensitivity: The wipers will wipe
even if only a small amount of water is
detected on the windscreen.
6
 = Low sensitivity: The wipers will only
wipe when a larger amount of water is
detected on the windscreen.
WINDSCREEN WASHERS WARNING...

Washer
WARNING
Do not operate the washer for more
than 10 seconds at a time, and never
when the reservoir is empty.
Pull the lever fully towards the steering
wheel and hold it to operate the washer.
The washer will operate in conjunction with
the wipers.
The washer jet for the rear window is
located on the roof above the rear window. CHECKING THE WIPER
BLADES Run the tip of your fingers over the edge of
the blade to check for roughness.
Clean the wiper blade lips with water
applied with a soft sponge....

Lift the wiper arm and position the wiper
blade at a right angle to the wiper arm. To
remove, press the retaining clip in the
direction of the arrow, disengage the wiper
blade and pull it off the arm in the opposite
direction.
36
Wipers and Washers 

LIGHTING CONTROL
Lighting control positions
OffA
Side and tail lamps
B
Headlamps
C
Autolamps Note:
If you have switched autolamps on,
you can only switch the main beam on when
autolamps has switched the headlamps on. The headlamps will come on and go off
automatically depending on the ambient
light.
Home safe lighting
You can switch home safe lighting on up
to 10 minutes after you have switched the
ignition off.
Vehicles without autolamps
Switch the headlamps on and then switch
them off within two...

Headlamp flasher
Pull the lever slightly towards the steering
wheel.
FRONT FOG LAMPS
Note:
It is not possible to switch on the
front fog lamps when the lighting switch is
set to AUTO. To switch on the front fog
lamps, switch off the autolamps feature.
Switch on the headlamps 1 and pull out
the control switch one position 2.
The front fog lamps should be used only
when visibility is considerably restricted by
fog, snow or rain. REAR FOG LAMPS
WARNING
The rear fog lamps may only be used
when visibility is...