Flir ThermovisionMDSeries Operators Manual
Have a look at the manual Flir ThermovisionMDSeries Operators Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 33 Flir manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
432-0010-00-10 Rev 100 — MD-Series Operator’s Manual 59 MD-Series Reference Information Restoring the Factory Network Settings In some cases, it may be necessary to restore the network settings of the camera to the original factory settings. At each power up, the system transmits a packet and then checks to determine if that sa me packet has been received. Detection of the received packet indicates the came ra has a custom loopback connector installed on its Ethernet interface. The detection of the loopback packet cues the camera to restore factory defaults and to revert to the same configuration and behavior as when the camera left the factory. The following table describes the loopback connector. The RJ45 loopback termination ties pin 1 to pin 3, and pin 2 to pin 6. The other pins are not connected. Pin # Signal Tied to pin # 1 Transmit + 3 2 Transmit - 6 3 Receive + 1 4 Unused N/A 5 Unused N/A 6 Receive - 2 7 Unused N/A 8 Unused N/A
MD-Series Reference Information 60432-0010-00-10 Rev 100 — MD-Series Operator’s Manual
FLIR Systems, Inc. CS World Headquarters FLIR Systems, Inc. 70 Castilian Dr. Goleta, CA 93117 USA PH:+ 1 805 964 9797 PH:+ 1 877 773 3547 (Sales) PH:+ 1 888 747 3547 (Technical Support) FX: + 1 805 685 2711 [email protected] EUROPE CS Eurasian Headquarters FLIR Systems CVS BV Charles Petitweg 21 4847 NW Teteringen - Breda Netherlands PH: + 31 (0) 765 79 41 94 FX: + 31 (0) 765 79 41 99 [email protected] FLIR Systems, Inc. Corporate Headquarters FLIR Systems, Inc. 27700A SW Parkway Ave. Wilsonville, OR 97070 USA PH: + 1 503 498 3547 PH: + 1 877 773 3547 FX: + 1 503 498 3153 [email protected]