Epson Projector BrightLink 1430Wi User Manual

4. Remove the markers from inside the Touch Unit.
5. Press the
Menubutton on the remote control or projector control panel.
6. Select Easy Interactive Function from theExtended menu.
41  

7. Select
Touch Unit Setup.
8. Make sure Poweris set to On.
42 

The Touch Unit power turns on and the indicator light turns blue.
Warning:
Do not look into the projectors projection window or the Touch Units laser diffusion ports
(located on the back of the Touch Unit); this could cause injury to eyesight.
9. Select Angle Adjustment.
The Angle Adjustment screen is displayed.
43   

10. Turn the adjustment dials on the Touch Unit counterclockwise until you hear a click. Press the
button on the remote control.
Note: Make sure to stop turning the dials when you hear the click.
11. Attach the two markers you removed from the Touch Unit to the marker positions shown on the projected screen ( ) ( ).
44     

12. Match the positions so that the crosses (A) overlap with the points (B) on the marker positions ( ) (
). Move the marker over the projected cross until the lines of the cross align with the lines on the
marker.
13. When pointers ( ) ( ) with the same color (blue and green) as the marker positions are displayed on the left and right of the projection surface, attach the markers to the projection surface
as follows:
• For magnetic screens: Place the bottom of the markers on the screen.
45      

• For non-magnetic screens: Use the supplied tape to secure the markets. Attach the tape so that
each end of the marker is secure on the screen.
Correct position:
Incorrect position:
Note: Do not place anything other than the markers near the projected image during angle
adjustment. If other objects are on the projected image, angle adjustment may not be performed
correctly.
46   

14. Turn the adjustment dials on the Touch Unit to move the pointers so that they move inside of the
target of the same color (blue and green) on either side.
Turning an adjustment dial clockwise moves the pointer diagonally up towards the center of the
projected image.
47  

Turning an adjustment dial counterclockwise moves the pointer diagonally down away from the
center of the projected image.
When the pointers are inside the target, the colors become solid ( ) ( )
Note:
If a dial makes a clicking sounds, the pointer will not move any further. When turning the dials,
make sure the shadows from your arm or body do not cover the markers.
15. When the pointers on the left and right become solid colors, press the button on the remote control.
48   

The next adjustment screen is displayed.
49  

16. Place the markers at the top marker positions [1]. When angle adjustment is performed correctly, the
upper pointers become solid colors. If the upper pointers do not become solid colors, start again
from step 9.
50