Epson Powerlite Presenter Users Guide

Welcome11
Important Safety Instructions
Follow these safety instructions when setting up and using your PowerLite Presenter:
■Except as specifically explained in this User’s Guide, do not attempt to service this product 
yourself. Refer all servicing to qualified service personnel.
■Never open any cover on the projector, exce pt the lamp and filter covers. Dangerous 
electrical voltages inside the projector can severely injure you.
■The projector’s accessories come packaged in  plastic bags. Keep...

12Welcome
■ The lamp(s) in this product contain mercury. Please consult your state and local 
regulations regarding disposal or recycling. Do not put in the trash.
■The lamp in this projector is under high intern al pressure and may make a loud noise if it 
breaks. If it breaks, ventilate the room to prevent mercury gas inside the lamp from being 
inhaled or coming into contact with the eyes or mouth.
■Do not bring your face close to the projector while it is in use, to prevent burns from hot 
air...

Welcome13
■Don’t overload wall outlets, extension cords, or integral convenience receptacles. This can 
cause fire or electric shock.
■Unplug the projector from the wall outlet and refer servicing to qualified service 
personnel under the following conditions: when the power cord or plug is damaged or 
frayed; if liquid has been spilled into the projector, or if it has been exposed to rain, water, 
or excessive humidity; if smoke, unusual smells, or unusual noises come from the 
projector; if it doesn’t...

14Welcome
■Make sure there is at least 4 inches of space between the intake ventilation slots and the 
wall or other object.
■Avoid projecting a high-contrast still image for more than 15 minutes to prevent burn-in. 
If this happens, project a bright screen until the burn-in disappears (from 30 to 60 
minutes). If you can’t eliminate the burn-i n, contact Epson as described on page 68.
■Do not turn the volume too high, especially  when using headphones. Listening to high 
volume sounds over an extended...

Unpacking and Setting Up15
Unpacking and Setting Up
Follow these instructions to unpack your projector, choose a location, and set up your 
projector.
Unpacking
Make sure you have all the parts shown here:
PowerLite PresenterRemote control and 
2 AA Batteries
CD with  User’s Guide  and 
electronic registration Power cord
Password 
Protected 
sticker
VGA computer cable
Protective 
case 

16Unpacking and Setting Up
Choosing a Location
You can use your PowerLite Presenter just about anywhere—in the classroom or conference 
room, on a tabletop, desktop, or cart.
Your projector should be directly in front of the screen, 
facing straight ahead (at a 90-degree angle to the surface).
If the image is too low, you can raise it by extending the feet 
and tilting the projector up. This causes the image to lose its 
rectangular shape, but the projector will correct it 
automatically. If necessary,...

Unpacking and Setting Up17
When setting up the projector, keep these considerations in mind:
■Make sure you don’t block the air vents on the sides.
■Make sure you place the projector within 9 feet (2.7 meters) of an electrical outlet, power 
strip, or extension cord. 
■Do not tilt the projector more than 10 degrees while playing CDs or DVDs.
40 in. 4.1 to 5 ft. (1.3 to 1.5 meters)
50 in. 5.2 to 6.2 ft. (1.6 to 1.9 meters)
60 in. 6.2 to 7.5 ft. (1.9 to 2.3 meters)
70 in. 7.3 to 8.8 ft. (2.2 to 2.7...

18Unpacking and Setting Up
Setting Up PowerLite Presenter
1. If you have a screen, set it up following the instructions included with the screen. Make sure you read all the instructions to avoid damaging the screen.
2. Put the batteries in the remote control.
Note:  Use only AA-size alkaline or manganese dry batteries.
3. Reattach the battery cover.
4. Expose the remote control to bright light for several minutes before using it in the dark. 
The buttons will glow in the dark briefly. 

Unpacking and Setting Up19
5. Open the lens cover, then connect the power cord and plug in the projector. The   light turns orange.
Once you’ve finished setting up the projector, do one of the following:
■If you would like to play a DVD, see “Playing DVDs” on page 20.
■If you would like to connect other equipm ent to the projector, see“Using PowerLite 
Presenter with Other Equipment” on page 29.
Turning the Projector Off
1. If there is a disc inside the projector, eject it.
2. Press the   button on the...

20Playing DVDs
Playing DVDs
Follow the instructions in this section to play a DVD and control playback.
Starting a DVD
Insert your DVD into the slot.
Warning: Close the lens cover before inserting or ejecting a disc. When the picture appears, do not 
look into the lens, and do not allow children or pets  to look into the lens. The bright light may affect 
your vision.
After about 30 seconds, the projector warms up and the picture comes on.