Epson Gt2500 User Manual

Make sure TCP/IP is included in the network components 
list.
 
If TCP/IP appears in the list , go to Scanning Over a Network; otherwise, go to step 5. 
Click Add. The Select Network Component Type window 
appears.
 
Select Protocol from the list and click 
Add.
  

Select Microsoft from the Manufacturers list and TCP/IP from Network Protocols list, 
then click OK.
 
Follow the instructions on the screen to finish adding the protocol. The\
n go to 
Scanning Over a Network.
 
Top  

Home > Using the Network Image Express Card 
Scanning Over a Network
Starting EPSON Scan Settings  
Scanning an Image  
Starting EPSON Scan Settings
Make sure your Epson scanner and Network Image Express Card are turned o\
n and working 
properly. Then follow the steps below to use the EPSON Scan Settings pro\
gram to enable 
network scanning.
 
 
Note:
l     With Windows 2000 and XP, you need to log on with administrator privileg\
es to 
install the software.
 
l     With Windows 2000, XP, and Mac OS...

2000) > EPSON Scan > EPSON Scan Settings. 
Mac OS X:  
Click the EPSON Scan Settings icon in the Utility folder.
 
Select EPSON GT-2500 from the Select Scanner drop-down 
list.
  

Click the Network radio button, then click the Add 
button.  

In the Add window, choose the Network Image Express Cards IP address un\
der 
Search for addresses, or click the Enter address radio button and type in the 
address. Then click the OK button.
 
In the EPSON Scan Settings window, click the Test button to check the connection. If 
everything works properly, you see a successful connection message in th\
e Scanner 
Status box.
  

Click OK to save the 
settings.
 
Top  

Scanning an Image
 
Note:
You must set the IP address for your Network Image Express Card before y\
ou can scan 
using it. See Starting EPSON Scan Settings for instructions.
 
Turn on your scanner and the client 
computer.
 
On the client computer, double-click the EPSON Scan icon on the desktop (Windows) 
or open it from the Applications folder (Mac OS X).
 
Select your desired mode and scanning settings, then do one of the follo\
wing to start 
your scan:
 
l     Click the Scan button on the EPSON...

Home > Maintenance 
Cleaning the Scanner
To keep your scanner operating at its best, clean it periodically using \
the following procedure. 
Turn off the scanner using its power 
button.
 
Unplug the AC adapter cord from the 
scanner.
 
Clean the outer case with a cloth dampened with mild detergent and 
water.
 
If the glass surface of the document table gets dirty, clean it with a s\
oft dry cloth. If 
the glass surface is stained with grease or some other hard-to-remove ma\
terial, use a 
small amount...

a. underside of ADF 
b. left side of document table
 
 
Caution:
l     Do not press the glass surface of the document table with any force. 
l     Be careful not to scratch or damage the glass surface of the document ta\
ble, 
and do not use a hard or abrasive brush to clean it. A damaged glass sur\
face 
can decrease the scan quality.
 
l     Never use alcohol, thinner, or corrosive solvent to clean the scanner. T\
hese 
chemicals can damage the scanner components and the case.
 
l     Be careful not...