Epson AcuLaser C3800N User Manual

Using the Control Panel191
EPSON AcuLaser C3800 Users Guide
T. Margin
Sets the distance from the top of the page to the baseline of the first printable line. The 
distance is measured in inches. The smaller the value, the closer the printable line is to the 
top.
Text
Sets the page length in lines. For this option, a line is assumed to be 1 pica (1/6 inch). If 
you change the Orientation, Page Size, or T. Margin settings, the page length setting 
automatically returns to the default for each paper size....

Using the Control Panel192
EPSON AcuLaser C3800 Users Guide
Status and Error Messages
This section contains a list of error messages shown on the LCD panel, a brief description 
of each message and suggestions for correcting the problem. Note that not every message 
shown on the LCD panel indicates a problem. When the   mark is displayed at the right of 
the warning message, multiple warnings occur. To confirm all warnings that occur, press 
the dDown button to display the Status Menu, then press the...

Using the Control Panel193
EPSON AcuLaser C3800 Users Guide
Can’t Print Duplex
The printer has encountered problems during duplex printing. Make sure you are using an 
appropriate type and size of paper for the duplex printing. The problem could also be a 
result of incorrect settings for the paper source you are using. Pressing the NStart/Stop 
button will print the rest of the print job on only one side of the paper. Press the +Cancel 
Job button to cancel the print job.
Can’t Print File
The printer...

Using the Control Panel194
EPSON AcuLaser C3800 Users Guide
Collate Disabled
Printing by specifying the number of copies is no longer possible due to a lack of memory 
(RAM). If this error occurs, print only one copy at a time.
To clear this error, select Clear Warning from the control panel’s Reset Menu. For 
instruction about accessing the control panel menus, see How to access the control panel 
menus on page 165.
Cooling Down zz min
The printer is cooling down. The time until the printer is ready to...

Using the Control Panel195
EPSON AcuLaser C3800 Users Guide
Form Feed
The printer is ejecting paper due to a user request. This message appears when pressing 
the NStart/Stop button once to make the printer offline, then holding down the 
NStart/Stop button for more than 2 seconds in order not to receive form feed command.
Format Error ROM A
An unformatted ROM module has been inserted. 
To clear this error, either press the NStart/Stop button or turn off the printer and remove 
the ROM module, then...

Using the Control Panel196
EPSON AcuLaser C3800 Users Guide
Install Transfer Unit
There is no transfer unit installed or the transfer unit is not installed properly. Install the 
transfer unit if it is not installed. 
If a transfer unit is already installed, turn off the printer, open the front cover, then remove 
the transfer unit. Reinstall the unit properly, then close the front cover. The error clears 
automatically if the transfer unit is properly installed. 
Install uuuu TnrCart
The wrong imaging...

Using the Control Panel197
EPSON AcuLaser C3800 Users Guide
Manual Duplex
One side for the manual duplex printing is finished. To start printing on the other side, set 
the paper and press the NStart/Stop button. See Printing with the Duplex Unit (models 
with Duplex Unit only) on page 51 for windows, or Printing with the Duplex Unit (models 
with Duplex Unit only) on page 128 for Macintosh.
Manual Feed ssss
The manual feed mode is specified for the current print job. Make sure the paper size 
indicated...

Using the Control Panel198
EPSON AcuLaser C3800 Users Guide
NonGenuine Toner uuuu
The installed imaging cartridge is not an genuine Epson imaging cartridge. The printout 
and remaining amount of each imaging cartridge displayed on the control panel may be 
different from those when using genuine EPSON imaging cartridges. Epson shall not be 
liable for any damages or problems arising from the use of consumable products not 
manufactured or approved by Epson. Installing a genuine imaging cartridge is...

Using the Control Panel199
EPSON AcuLaser C3800 Users Guide
Paper Out tttt sssss
There is no paper in the specified paper source (tttt). Load paper of the size (sssss) into 
the paper source.
Paper Set tttt sssss
The paper loaded in the specified paper source (tttt) does not match the required paper 
size (sssss). Replace the loaded paper with the correct size paper and press the 
NStart/Stop button to resume printing, or press the +Cancel Job button to cancel the 
print job.
If you press the NStart/Stop...

Using the Control Panel200
EPSON AcuLaser C3800 Users Guide
Ready
The printer is ready to receive data and print.
In this mode, the remaining amount of the imaging cartridge for each color is displayed in 
seven levels.
Replace Fuser
The fuser has reached the end of its service life and needs to be replaced.
Turn the printer off and wait for 30 minutes, then replace the fuser unit with a new one. See 
Fuser Unit on page 233 for instructions.
Replace Toner uuuu
The indicated imaging cartridges have...