Electrolux Ews 106410 W User Manual

user manual
Washing Machine
EWS 106410 W
 G·4Ú$  
 
?¦Zò

Electrolux. Thinking of you.
Share more of our thinking at www.electrolux.com
CONTENTS
Safety information   2
Product description   4
Control panel   5
First use   7
Personalisation  7
Daily use   8Helpful hints and tips   11
Washing programmes   12
Care and cleaning   15
What to do if...   20
Technical data   22
Installation  23
Subject to change without notice
 SAFETY INFORMATION
Important! Read carefully & keep for future
reference.
• The safety of Your appliance complies
with the industry standards...

occur to the product and to property if
this is not adhered to. See relevant sec-
tion in the user manual.
• After having installed the appliance,
check that it is not standing on the inlet
and drain hose and the worktop is not
pressing the electrical supply cable
against the wall.
• If the machine is situated on a carpeted
floor, please adjust the feet in order to al-
low air to circulate freely under the appli-
ance.
• Always be sure, that there is no water
leakage from hoses and their connec-
tions...

PRODUCT DESCRIPTION
Your new appliance meets all modern requirements for effective treatment of laundry
with low water, energy and detergent consumption. Its new washing system allows to-
tal use of detergent and reduces water consumption so saving energy.
12
3
4
5
6
1Detergent dispenser drawer
2Control panel
3Door opening handle
4Drain pump
5Adjustable feet
Detergent dispenser drawer
 Compartment for detergent used for
prewash and soak phase or for stain re-
mover used during the stain action phase (if...

CONTROL PANEL
Below is a picture of the control panel. It shows the programme selector dial as well as
the buttons, pilot light and the display. These are presented by relevant numbers on
the following pages.
12456789103
1Programme selector dial
2TEMPERATURE button
3SPIN reduction button
4PREWASH button
5EXTRA RINSE button
6DELAY START button
7Display
8START/PAUSE button
9DOOR LOCKED pilot light
10TIME MANAGER buttons
Programme Selector Dial
It allows you to switch the appliance on/off
and/or to select a...

Time Manager
These buttons allows you to modify the
programme duration automatically pro-
posed by the appliance.
Door locked pilot light
The pilot light 9 illuminates when the pro-
gramme starts and indicates if the door can
be opened:• light on: the door cannot be opened. The
machine in working or has stopped with
water left in the tub.
• light off: the door can be opened. The
programme is finished or the water has
been emptied out.
• light flashing: the door is opening
Display
7.47.57.1
7.27.3
The...

7.4: Soil degree icons
•
Intensive 
•
Normal 
•
Daily 
•
Light 
•
Quick 
•
Super Quick 
•
Refresh 
•
Super Refresh 
When selecting a programme on the dis-
play appears an icon indicating the degree
of soiling automatically proposed by the
machine.
7.5: Child safety lock 
 (see «Child Safe-
ty Lock» paragraph).
Table of Symbols
= Cottons = Jeans
= Synthetics = Blanket
= Delicates = Cold
= Wool = Rinse Hold
= Silk = Prewash
= Lingerie = Extra Rinse
= Soak = Child safety lock
= Rinse = Delay Start
= Drain =...

There are two different ways to set this op-
tion:
1. Before pressing button 8: it will be im-
possible to start the machine.
2. After pressing button 8: it will be impos-
sible to change any other programme or
option.To enable or disable this option press si-
multaneously for about 6 seconds buttons
5 and 6 until on the display, the icon 
 ap-
pears or disappears.
DAILY USE
Load the laundry
Open the door by carefully pulling the door
handle outwards. Place the laundry in the
drum, one item at a time,...

the corresponding buttons. The green pilot
light of the button 8 starts to flash.
The selector dial can be turned either clock-
wise or counterclockwise. Turn to position
 to reset programme/Switching the ma-
chine off.
At the end of the programme the selec-
tor dial must be turned to position 
 ,
to switch the machine off.
Caution! If you turn the programme
selector dial to another programme
when the machine is working, the red
pilot light of button 8 will blink 3 times
and the message Err is displayed...

To interrupt a programme which is running,
press the button 8: the green pilot light
starts blinking.
To restart the programme from the point at
which it was interrupted, press the button 8
again. If you have chosen a delayed start,
the machine will begin the countdown. If an
incorrect option is selected, the red pilot
light of the button 8 blinks for 3 times the
message Err is displayed for a few sec-
onds.
Select the Time Manager option by
pressing buttons 10
By pressing these buttons repeatedly, the...